|
Araujo Filho, A. A. (2024). Analysis of a regular black hole in Verlinde's gravity. Class. Quantum Gravity, 41(1), 015003–30pp.
Abstract: This work focuses on the examination of a regular black hole within Verlinde's emergent gravity, specifically investigating the Hayward-like (modified) solution. The study reveals the existence of three horizons under certain conditions, i.e. an event horizon and two Cauchy horizons. Our results indicate regions which phase transitions occur based on the analysis of heat capacity and Hawking temperature. To compute the latter quantity, we utilize three distinct methods: the surface gravity approach, Hawking radiation, and the application of the first law of thermodynamics. In the case of the latter approach, it is imperative to introduce a correction to ensure the preservation of the Bekenstein-Hawking area law. Geodesic trajectories and critical orbits (photon spheres) are calculated, highlighting the presence of three light rings. Additionally, we investigate the black hole shadows. Furthermore, the quasinormal modes are explored using third- and sixth-order Wentzel-Kramers-Brillouin approximations. In particular, we observe stable and unstable oscillations for certain frequencies. Finally, in order to comprehend the phenomena of time-dependent scattering in this scenario, we provide an investigation of the time-domain solution.
|
|
|
LHCb Collaboration(Aaij, R. et al), Jashal, B. K., Martinez-Vidal, F., Oyanguren, A., Remon Alepuz, C., & Ruiz Vidal, J. (2022). Analysis of Neutral B-Meson Decays into Two Muons. Phys. Rev. Lett., 128(4), 041801–13pp.
Abstract: The branching fraction B(B-s(0)->mu(+)mu(-)) = (3.09(-0.43-0.11)(+0.46+0.15)) x 10(-9) and the effective lifetime to tau(B-s(0) -> mu(+)mu(-)) = 2.07 +/- 0.29 +/- 0.03 ps are measured, where the first uncertainty is statistical and the second systematic. No significant signal for B-0 ->mu(+)mu(-)gamma) and B-s(0)->mu(+)mu(-)gamma decays is found and upper limits B(B(B-0 ->mu(+)mu(-)) < 2.6 x 10(-10) and B(B-s(0) -> mu(+)mu(-)gamma) < 2.0 x 10(-9) at the 95% C.L. are determined, where the latter is limited to the range m(mu mu) > 4.9 GeV/c(2). The results are in agreement with the standard model expectations.Branching fraction and effective lifetime measurements of the rare decay B-s(0) -> mu(+)mu(-) and searches for the decays B-0 -> mu(+)mu(-) and B-s(0) -> mu(+)mu(-)gamma are reported using proton-proton collision data collected with the LHCb detector at center-of-mass energies of 7, 8, and 13 TeV, corresponding to a luminosity of 9 fb(-1).
|
|
|
Garcia Canal, C. A., Tarutina, T., & Vento, V. (2023). Analysis of Nuclear Effects in Structure Functions and Their Connection with the Binding Energy of Nuclei. Braz. J. Phys., 53(6), 161–8pp.
Abstract: We describe nuclear effects in structure functions of nuclei in DIS by means of a multiplicative factor beta(A)(x) which differentiates the structure function of the bound nucleons from that of the free nucleons. Our analysis determines that beta(A)(x) establishes a relation between the quark-gluon dynamics expressed by the bound nucleon structure functions and the nuclear dynamics as described by the well-known semi-empirical Bethe-Weizsacker mass formula. This relation corroborates a connection between the underlying quark-gluon dynamics and the phenomenological nuclear dynamics.
|
|
|
Wang, E., Liang, W. H., & Oset, E. (2021). Analysis of the e(+)e(-) -> J/psi D(D)over-bar reaction close to the threshold concerning claims of a chi(c0)(2P) state. Eur. Phys. J. A, 57(1), 38–9pp.
Abstract: We analyze the D (D) over bar mass distribution from a recent Belle experiment on the e(+)e(-) -> J/.D (D) over bar reaction, and show that the mass distribution divided by phase sp(c)e does not have a clear peak above the D (D) over bar threshold that justifies the experimental claim of chi(c0)(2P) state from those data. Then we use a unitary formalismwith coupled channels D+ D-, D-0 (D) over bar (0), D-s(D) over bar (s), and eta eta, with some of the interactions taken from a theoretical model, and use the data to fix other parameters. We then show that, given the poor quality of the data, we can get different fits leading to very different D (D) over bar amplitudes, some of them supporting a D (D) over bar bound state and others not. The main conclusion is that the claim for the chi(c0)(2P) state, already included in the PDG, is premature, but refined data can provide very valuable information on the D (D) over bar scattering amplitude. As side effects, we warn about the use of a Breit-Wigner amplitude parameterization close to threshold, and show that the D-s(D) over bar (s) channel plays an important role in this reaction.
|
|
|
Wang, E., Li, H. S., Liang, W. H., & Oset, E. (2021). Analysis of the gamma gamma -> D(D)over-bar reaction and the D(D)over-bar bound state. Phys. Rev. D, 103(5), 054008–10pp.
Abstract: In this work, we investigate the reaction of gamma gamma -> D (D) over bar, taking into account the S-wave D (D) over bar final state interaction. By fitting to the D (D) over bar, invariant mass distributions measured by the Belle and BABAR Collaborations, we obtain a good reproduction of the data by means of a D (D) over bar, amplitude that produces a bound D (D) over bar, statewith isospin I = 0 close to threshold. The error bands of the fits indicate, however, that more precise data on this reaction are needed to be more assertive about the position and width of such a state.
|
|
|
Renteria-Estrada, D. F., Hernandez-Pinto, R. J., & Sborlini, G. F. R. (2021). Analysis of the Internal Structure of Hadrons Using Direct Photon Production. Symmetry-Basel, 13(6), 942–10pp.
Abstract: Achieving a precise description of the internal structure of hadrons is crucial for deciphering the hidden properties and symmetries of fundamental particles. It is a hard task since there are several bottlenecks in obtaining theoretical predictions starting from first principles. In order to complement highly accurate experiments, it is necessary to use ingenious strategies to impose constraints from the theory side. In this article, we describe how photons can be used to unveil the internal structure of hadrons. We explore how to describe NLO QCD plus LO QED corrections to hadron plus photon production at colliders and discuss the impact of these effects on the experimental measurements.
|
|
|
Gonzalez-Iglesias, D., Esperante, D., Gimeno, B., Blanch, C., Fuster-Martinez, N., Martinez-Reviriego, P., et al. (2023). Analysis of the Multipactor Effect in an RF Electron Gun Photoinjector. IEEE Trans. Electron Devices, 70(1), 288–295.
Abstract: The objective of this work is the evaluation of the risk of suffering a multipactor discharge within an RF electron gun photoinjector. Photoinjectors are a type of source for intense electron beams, which are the main electron source for synchrotron light sources, such as free-electron lasers. The analyzed device consists of 1.6 cells and it has been designed to operate at the S-band. Besides, around the RF gun there is an emittance compensation solenoid, whose magnetic field prevents the growth of the electron beam emittance, and thus the degradation of the properties of the beam. The multipactor analysis is based on a set of numerical simulations by tracking the trajectories of the electron cloud in the cells of the device. To reach this aim, an in-house multipactor code was developed. Specifically, two different cases were explored: with the emittance compensation solenoid assumed to be off and with the emittance compensation solenoid in operation. For both the cases, multipactor simulations were carried out exploring different RF electric field amplitudes. Moreover, for a better understanding of the multipactor phenomenon, the resonant trajectories of the electrons and the growth rate of the electrons population are investigated.
|
|
|
Bayar, M., Ikeno, N., & Oset, E. (2020). Analysis of the psi (4040) and psi (4160) decay into D-(*()) (D)over-bar(()*()), D-s(()*()) (D)over-bar(s)(()*()). Eur. Phys. J. C, 80(3), 222–9pp.
Abstract: We have performed an analysis of the e+e--> D(*) data in the region of the psi(4040) and psi(4160) resonances which have a substantial overlap and require special care. By using the P-3(0) model to relate the different D(*)(D) over bar(*) production modes, we make predictions for production of these channels and compare with experiment and other theoretical approaches. As a side effect we find that these resonances qualify largely as c (c) over bar states and theweight of the meson-meson components in the wave function is very small.
|
|
|
Ramalho, M., Suhonen, J., Kostensalo, J., Alcala, G. A., Algora, A., Fallot, M., et al. (2022). Analysis of the total beta-electron spectrum of( 92)Rb: Implications for the reactor flux anomalies. Phys. Rev. C, 106(2), 024315–7pp.
Abstract: We present here a microscopic nuclear-structure calculation of a beta-electron spectrum including all the beta-decay branches of a high Q-value reactor fission product contributing significantly to the reactor antineutrino energy spectrum. We perform large-scale nuclear shell-model calculations of the total electron spectrum for the beta(-) decay of Rb-92 to states in Sr-92 using a computer cluster. We exploit the beta-branching data of a recent total absorption gamma-ray spectroscopy (TAGS) measurement to determine the effective values of the weak axial-vector coupling, g(A), and the weak axial charge, g(A)(gamma(5)). By using the TAGS data we avoid the bias stemming from the pandemonium effect which is a systematic error biasing the usual beta-decay measurements. We take fully into account all the involved allowed and forbidden beta transitions, in particular the first-forbidden nonunique ones which have earlier been shown to be relevant in the context of the reactor-antineutrino flux anomaly and the unexplained spectral shoulder, the “bump,” the former one having been interpreted as one of the strongest evidence for the existence of sterile neutrinos. Here we are able to present quantitative evidence for the relevance of forbidden nonunique beta(-) decays in a total beta spectrum of a fission product, in this case( 92)Rb, which is one of the major contributors to the total reactor antineutrino spectral shape. We demonstrate that taking the forbidden spectral shapes fully into consideration leads for Rb-92 to a 2.6%-4.6% reduction in the expected inverse beta-decay rate at the reactor antineutrino telescopes. We also confirm by our calculation of a total beta-electron spectrum that the forbidden transitions can contribute to the formation of the spectral bump in the reactor-antineutrino flux profile.
|
|
|
Gonzalez-Iglesias, D., Esperante, D., Gimeno, B., Boronat, M., Blanch, C., Fuster-Martinez, N., et al. (2021). Analytical RF Pulse Heating Analysis for High Gradient Accelerating Structures. IEEE Trans. Nucl. Sci., 68(2), 78–91.
Abstract: The main aim of this work is to present a simple method, based on analytical expressions, for obtaining the temperature increase due to the Joule effect inside the metallic walls of an RF accelerating component. This technique relies on solving the 1-D heat-transfer equation for a thick wall, considering that the heat sources inside the wall are the ohmic losses produced by the RF electromagnetic fields penetrating the metal with finite electrical conductivity. Furthermore, it is discussed how the theoretical expressions of this method can be applied to obtain an approximation to the temperature increase in realistic 3-D RF accelerating structures, taking as an example the cavity of an RF electron photoinjector and a traveling wave linac cavity. These theoretical results have been benchmarked with numerical simulations carried out with commercial finite-element method (FEM) software, finding good agreement among them. Besides, the advantage of the analytical method with respect to the numerical simulations is evidenced. In particular, the model could be very useful during the design and optimization phase of RF accelerating structures, where many different combinations of parameters must be analyzed in order to obtain the proper working point of the device, allowing to save time and speed up the process. However, it must be mentioned that the method described in this article is intended to provide a quick approximation to the temperature increase in the device, which of course is not as accurate as the proper 3-D numerical simulations of the component.
|
|