|
|
Martinez-Cañadas, M. A., Porras, I., Macias, M., Praena, J., Fontana, C. L., Bonaldi, C., et al. (2026). First experimental validation of the MgF2 core of the Beam Shaping Assembly from the NeMeSiS project for Boron Neutron Capture Therapy. Radiat. Phys. Chem., 246, 113969–10pp.
Abstract: A Beam Shaping Assembly model was proposed by the Neutrons for Medicine and Scientific applications project for its application to Boron Neutron Capture Therapy. The first experimental test of the core moderator was performed at the MONNET facility at the Joint Research Centre in Geel, Belgium. To this end, the conducted experiment had three main goals: first, an energy and angular characterization of the 7Li(p,n) at 2.1 MeV; second, the validation of the magnesium fluoride (MgF2) total cross-section following transmission measurements through thin samples; third, the measurement of the moderation capabilities of MgF2 after irradiating several blocks of the material. All measurements used a lithium glass detectors with the time-of-flight technique. Monte Carlo simulations were done to calculate the necessary corrections, as well as several checks and further analysis. In this work we illustrate the chronology in all these sequential steps.
|
|
|
|
Torres-Sanchez, P., Lerendegui-Marco, J., Balibrea-Correa, J., Babiano-Suarez, V., Gameiro, B., Ladarescu, I., et al. (2025). The potential of the i-TED Compton camera array for real-time boron imaging and determination during treatments in Boron Neutron Capture Therapy. Appl. Radiat. Isot., 217, 111649–9pp.
Abstract: This paper explores the adaptation and application of i-TED Compton imagers for real-time dosimetry in Boron Neutron Capture Therapy (BNCT). The i-TED array, previously utilized in nuclear astrophysics experiments at CERN, is being optimized for detecting and imaging 478 keV gamma-rays, critical for accurate BNCT dosimetry. Detailed Monte Carlo simulations were used to optimize the i-TED detector configuration and enhance its performance in the challenging radiation environment typical of BNCT. Additionally, advanced 3D image reconstruction algorithms, including a combination of back-projection and List-Mode Maximum Likelihood Expectation Maximization (LM-MLEM), are implemented and validated through simulations. Preliminary experimental tests at the Institut Laue-Langevin (ILL) demonstrate the potential of i-TED in simplified conditions, with ongoing experiments focusing on testing imaging capabilities in realistic BNCT conditions.
|
|
