|
|
Garani, R., & Palomares-Ruiz, S. (2022). Evaporation of dark matter from celestial bodies. J. Cosmol. Astropart. Phys., 05(5), 042–53pp.
Abstract: Scatterings of galactic dark matter (DM) particles with the constituents of celestial bodies could result in their accumulation within these objects. Nevertheless, the finite temperature of the medium sets a minimum mass, the evaporation mass, that DM particles must have in order to remain trapped. DM particles below this mass are very likely to scatter to speeds higher than the escape velocity, so they would be kicked out of the capturing object and escape. Here, we compute the DM evaporation mass for all spherical celestial bodies in hydrostatic equilibrium, spanning the mass range [10(-)(10) – 10(2)] M-circle dot, for constant scattering cross sections and s-wave annihilations. We illustrate the critical importance of the exponential tail of the evaporation rate, which has not always been appreciated in recent literature, and obtain a robust result: for the geometric value of the scattering cross section and for interactions with nucleons, at the local galactic position, the DM evaporation mass for all spherical celestial bodies in hydrostatic equilibrium is approximately given by E-c/T-chi similar to 30, where E-c is the escape energy of DM particles at the core of the object and T-chi is their temperature. In that case, the minimum value of the DM evaporation mass is obtained for super-Jupiters and brown dwarfs, m(ev)(ap) similar or equal to 0.7 GeV. For other values of the scattering cross section, the DM evaporation mass only varies by a factor smaller than three within the range 10(-41) cm(2) <= sigma(p) <= 10(-31) cm(2), where sigma(p) is the spin-independent DM-nucleon scattering cross section. Its dependence on parameters such as the galactic DM density and velocity, or the scattering and annihilation cross sections is only logarithmic, and details on the density and temperature profiles of celestial bodies have also a small impact.
|
|
|
|
Carrio, F. (2022). The Data Acquisition System for the ATLAS Tile Calorimeter Phase-II Upgrade Demonstrator. IEEE Trans. Nucl. Sci., 69(4), 687–695.
Abstract: The tile calorimeter (TileCal) is the central hadronic calorimeter of the ATLAS experiment at the large hadron collider (LHC). In 2025, the LHC will be upgraded leading to the high luminosity LHC (HL-LHC). The HL-LHC will deliver an instantaneous luminosity up to seven times larger than the LHC nominal luminosity. The ATLAS Phase-II upgrade (2025-2027) will accommodate the subdetectors to the HL-LHC requirements. As part of this upgrade, the majority of the TileCal on-detector and off-detector electronics will be replaced using a new readout strategy, where the on-detector electronics will digitize and transmit digitized detector data to the off-detector electronics at the bunch crossing frequency (40 MHz). In the counting rooms, the off-detector electronics will compute reconstructed trigger objects for the first-level trigger and will store the digitized samples in pipelined buffers until the reception of a trigger acceptance signal. The off-detector electronics will also distribute the LHC clock to the on-detector electronics embedded within the digital data stream. The TileCal Phase-II upgrade project has undertaken an extensive research and development program that includes the development of a Demonstrator module to evaluate the performance of the new clock and readout architecture envisaged for the HL-LHC. The Demonstrator module equipped with the latest version of the on-detector electronics was built and inserted into the ATLAS experiment. The Demonstrator module is operated and read out using a Tile PreProcessor (TilePPr) Demonstrator which enables backward compatibility with the present ATLAS Trigger and Data AcQuisition (TDAQ), and the timing, trigger, and command (TTC) systems. This article describes in detail the main hardware and firmware components of the clock distribution and data acquisition systems for the Demonstrator module, focusing on the TilePPr Demonstrator.
|
|
|
|
Briz, J. A., Nerio, A. N., Ballesteros, C., Borge, M. J. G., Martinez, P., Perea, A., et al. (2022). Proton Radiographs Using Position-Sensitive Silicon Detectors and High-Resolution Scintillators. IEEE Trans. Nucl. Sci., 69(4), 696–702.
Abstract: Proton therapy is a cancer treatment technique currently in growth since it offers advantages with respect to conventional X-ray and gamma-ray radiotherapy. In particular, better control of the dose deposition allowing to reach higher conformity in the treatments causing less secondary effects. However, in order to take full advantage of its potential, improvements in treatment planning and dose verification are required. A new prototype of proton computed tomography scanner is proposed to design more accurate and precise treatment plans for proton therapy. Our prototype is formed by double-sided silicon strip detectors and scintillators of LaBr3(Ce) with high energy resolution and fast response. Here, the results obtained from an experiment performed using a 100-MeV proton beam are presented. Proton radiographs of polymethyl methacrylate (PMMA) samples of 50-mm thickness with spatial patterns in aluminum were taken. Their properties were studied, including reproduction of the dimensions, spatial resolution, and sensitivity to different materials. Structures of up to 2 mm are well resolved and the sensitivity of the system was enough to distinguish the thicknesses of 10 mm of aluminum or PMMA. The spatial resolution of the images was 0.3 line pairs per mm (MTF-10%). This constitutes the first step to validate the device as a proton radiography scanner.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Cardillo, F., et al. (2022). Search for neutral long-lived particles in pp collisions at root s = 13 TeV that decay into displaced hadronic jets in the ATLAS calorimeter. J. High Energy Phys., 06(6), 005–49pp.
Abstract: A search for decays of pair-produced neutral long-lived particles (LLPs) is presented using 139 fb(-1) of proton-proton collision data collected by the ATLAS detector at the LHC in 2015-2018 at a centre-of-mass energy of 13 TeV. Dedicated techniques were developed for the reconstruction of displaced jets produced by LLPs decaying hadronically in the ATLAS hadronic calorimeter. Two search regions are defined for different LLP kinematic regimes. The observed numbers of events are consistent with the expected background, and limits for several benchmark signals are determined. For a SM Higgs boson with a mass of 125 GeV, branching ratios above 10% are excluded at 95% confidence level for values of c times LLP mean proper lifetime in the range between 20 mm and 10 m depending on the model. Upper limits are also set on the cross-section times branching ratio for scalars with a mass of 60 GeV and for masses between 200 GeV and 1 Tev.
|
|
|
|
LHCb Collaboration(Aaij, R. et al), Jashal, B. K., Martinez-Vidal, F., Oyanguren, A., Remon Alepuz, C., & Ruiz Vidal, J. (2022). Tests of Lepton Universality Using B-0 -> K(S)(0)l(+) l(-) and B+ -> K*(+)l(+)l(-) Decays. Phys. Rev. Lett., 128(19), 191802–15pp.
Abstract: Tests of lepton universality in B-0 -> K(S)(0)l(+)l(-) and B+ -> K*(+)l(+)l(-) decays where l is either an electron or a muon are presented. The differential branching fractions of B-0 -> K(S)(0)e(+)e(-) and B+ -> K*(+)e(+)e(-) decays are measured in intervals of the dilepton invariant mass squared. The measurements are performed using proton-proton collision data recorded by the LHCb experiment, corresponding to an integrated luminosity of 9 fb(-1). The results are consistent with the standard model and previous tests of lepton universality in related decay modes. The first observation of B-0 -> K(S)(0)e(+)e(-) and B+ -> K*(+)e(+)e(-) decays is reported.
|
|
|
|
Di Valentino, E., Gariazzo, S., Giunti, C., Mena, O., Pan, S., & Yang, W. Q. (2022). Minimal dark energy: Key to sterile neutrino and Hubble constant tensions? Phys. Rev. D, 105(10), 103511–15pp.
Abstract: Minimal dark energy models, described by the same number of free parameters of the standard cosmological model with cold dark matter plus a cosmological constant to parametrize the dark energy component, constitute very appealing scenarios which may solve long-standing, pending tensions. On the one hand, they alleviate significantly the tension between cosmological observations and the presence of one sterile neutrino motivated by the short-baseline anomalies: we obtain a 95% CL cosmological bound on the mass of a fully thermalized fourth sterile neutrino (N-eff = 4) equal to m(s) < 0.65(1.3) eV within the Phenomenologically Emergent Dark Energy (PEDE) and Vacuum Metamorphosis (VM) scenarios under consideration. Interestingly, these limits are in agreement with the observations at short-baseline experiments, and the PEDE scenario is favored with respect to the Lambda CDM case when the full data combination is considered. On the other hand, the Hubble tension is satisfactorily solved in almost all the minimal dark energy schemes explored here. These phenomenological scenarios may therefore shed light on differences arising from near and far Universe probes, and also on discrepancies between cosmological and laboratory sterile neutrino searches.
|
|
|
|
Mandal, S., Miranda, O. G., Sanchez Garcia, G., Valle, J. W. F., & Xu, X. J. (2022). Toward deconstructing the simplest seesaw mechanism. Phys. Rev. D, 105(9), 095020–32pp.
Abstract: The triplet or type-II seesaw mechanism is the simplest way to endow neutrinos with mass in the Standard Model (SM). Here we review its associated theory and phenomenology, including restrictions from S, T, U parameters, neutrino experiments, charged lepton flavor violation as well as collider searches. We also examine restrictions coming from requiring consistency of electroweak symmetry breaking, i.e., perturbative unitarity and stability of the vacuum. Finally, we discuss novel effects associated to the scalar mediator of neutrino mass generation namely, (i) rare processes, e.g., l(alpha)-> l(beta)gamma decays, at the intensity frontier, and also (ii) four-lepton signatures in colliders at the high-energy frontier. These can be used to probe neutrino properties in an important way, providing a test of the absolute neutrino mass and mass ordering, as well as of the atmospheric octant. They may also provide the first evidence for charged lepton flavor violation in nature. In contrast, neutrino nonstandard interaction strengths are found to lie below current detectability.
|
|
|
|
Dai, L. R., Molina, R., & Oset, E. (2022). Looking for the exotic X-0(2866) and its J(P)=1(+) partner in the (B)over-bar(0) -> D-(*) + K- K-(*)0 reactions. Phys. Rev. D, 105(9), 096022–7pp.
Abstract: We propose two reactions, (B) over bar (0) -> (KD+K-)-D-0 and (B) over bar (0) -> K*D-0*K-+(-), which have been already measured at Belle, to look into the J(P) = 0(+), X-0(2866) state and a 1(+) partner of molecular D*(K) over bar* nature by looking at the D+K- and D*K-+(-) invariant mass distributions, respectively. Very clear peaks over the background are predicted and the branching ratios for the production of these states are evaluated to facilitate the task of determining the needed statistics for their observation. We conclude that with the upgrade of Belle II clear peaks should be seen in both reactions for the two resonances discussed.
|
|
|
|
Bandyopadhyay, P., Jangid, S., & Karan, A. (2022). Constraining scalar doublet and triplet leptoquarks with vacuum stability and perturbativity. Eur. Phys. J. C, 82(6), 516–44pp.
Abstract: We investigate the constraints on the leptoquark Yukawa couplings and the Higgs-leptoquark quartic couplings for scalar doublet leptoquark (R) over tilde (2), scalar triplet leptoquark S-3 and their combination with both three generations and one generation with respect to perturbative unitarity and vacuum stability. The perturbative unitarity of all the dimensionless couplings is studied via one- and two-loop beta functions. New SU(2)(L) multiplets in terms of these leptoquarks are introduced to fabricate Landau poles at the two-loop level in the gauge coupling g(2) at 10(19.7) GeV and 10(14.4) GeV, respectively, for the S-3 and (R) over tilde (2) + S-3 models with three generations. However, such Landau poles cease to exist for (R) over tilde (2) and any of these extensions with both one and two generations up to Planck scale. The Higgs-leptoquark quartic couplings acquire severe constraints to protect Planck scale perturbativity, whereas leptoquark Yukawa couplings acquire some upper bound in order to respect Planck scale stability of Higgs vacuum. The Higgs quartic coupling at the two-loop level constrains the leptoquark Yukawa couplings for (R) over tilde (2), S-3, (R) over tilde (2) + S-3 with values less than or similar to 1.30, 3.90, 1.00 with three generations. In the effective potential approach, the presence of any of these leptoquarks with any number of generations pushes the metastable vacuum of the Standard Model to the stable region.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Cardillo, F., Castillo Gimenez, V., et al. (2022). Search for resonant pair production of Higgs bosons in the b(b)over-barb(b)over-bar final state using pp collisions at root s=13 TeV with the ATLAS detector. Phys. Rev. D, 105(9), 092002–36pp.
Abstract: A search for resonant Higgs boson pair production in the b (b) over barb (b) over bar final state is presented. The analysis uses 126 fb(-1)- 139 fb(-1) of pp collision data at root s = 13 TeV collected with the ATLAS detector at the Large Hadron Collider. The analysis is divided into two channels, targeting Higgs boson decays which are reconstructed as pairs of small-radius jets or as individual large-radius jets. Spin-0 and spin2 benchmark signal models are considered, both of which correspond to resonant HH production via gluon-gluon fusion. The data are consistent with Standard Model predictions. Upper limits are set on the production cross section times branching ratio to Higgs boson pairs of a new resonance in the mass range from 251 GeV to 5 TeV.
|
|
