|
|
n_TOF Collaboration(Paradela, C. et al), Domingo-Pardo, C., Giubrone, G., & Tain, J. L. (2015). High-accuracy determination of the U-238/U-235 fission cross section ratio up to approximate to 1 GeV at n_TOF at CERN. Phys. Rev. C, 91(2), 024602–11pp.
Abstract: The U-238 to U-235 fission cross section ratio has been determined at nTOF up to approximate to 1 GeV, with two different detection systems, in different geometrical configurations. A total of four datasets has been collected and compared. They are all consistent to each other within the relative systematic uncertainty of 3-4%. The data collected at nTOF have been suitably combined to yield a unique fission cross section ratio as a function of neutron energy. The result confirms current evaluations up to 200 MeV. Good agreement is also observed with theoretical calculations based on the INCL++ /Gemini++ combination up to the highest measured energy. The n_TOF results may help solve a long-standing discrepancy between the two most important experimental datasets available so far above 20 MeV, while extending the neutron energy range for the first time up to approximate to 1 GeV.
|
|
|
|
Boronat, M., Marinas, C., Frey, A., Garcia, I., Schwenker, B., Vos, M., et al. (2015). Physical Limitations to the Spatial Resolution of Solid-State Detectors. IEEE Trans. Nucl. Sci., 62(1), 381–386.
Abstract: In this paper we explore the effect of delta-ray emission and fluctuations in the signal deposition on the detection of charged particles in silicon-based detectors. We show that these two effects ultimately limit the resolution that can be achieved by interpolation of the signal in finely segmented position-sensitive solid-state devices.
|
|
|
|
LHCb Collaboration(Aaij, R. et al), Martinez-Vidal, F., Oyanguren, A., Ruiz Valls, P., & Sanchez Mayordomo, C. (2015). Measurement of the Semileptonic CP Asymmetry in B-0-(B)over-bar(0) Mixing. Phys. Rev. Lett., 114(4), 041601–9pp.
Abstract: The semileptonic CP asymmetry in B-0-(B) over bar (0) mixing, a(s1)(d), is measured in proton-proton collision data, corresponding to an integrated luminosity of 3.0 fb(-1), recorded by the LHCb experiment. Semileptonic B-0 decays are reconstructed in the inclusive final states D-mu(+) and D*(-)mu(+), where the D- meson decays into the K+pi(-)pi(-) final state and the D*(-) meson into the (D) over bar (0)(-> K+pi(-))pi(-) final state. The asymmetry between the numbers of D-(*()-)mu(+) and D-(*()+)mu(-) decays is measured as a function of the decay time of the B-0 mesons. The CP asymmetry is measured to be a(s1)(d) = (-0.02 +/- 0.19 +/- 0.30)%, where the first uncertainty is statistical and the second systematic. This is the most precise measurement of a(s1)(d) to date and is consistent with the prediction from the standard model.
|
|
|
|
Allanach, B. C., Bednyakov, A., & Ruiz de Austri, R. (2015). Higher order corrections and unification in the minimal supersymmetric standard model: SOFTSUSY3.5. Comput. Phys. Commun., 189, 192–206.
Abstract: We explore the effects of three-loop minimal supersymmetric standard model renormalisation group equation terms and some leading two-loop threshold corrections on gauge and Yukawa unification: each being one loop higher order than current public spectrum calculators. We also explore the effect of the higher order terms (often 2-3 GeV) on the lightest CP even Higgs mass prediction. We illustrate our results in the constrained minimal supersymmetric standard model. Neglecting threshold corrections at the grand unified scale, the discrepancy between the unification scale alpha(s) and the other two unified gauge couplings changes by 0.1% due to the higher order corrections and the difference between unification scale bottom-tau Yukawa couplings neglecting unification scale threshold corrections changes by up to 1%. The difference between unification scale bottom and top Yukawa couplings changes by a few percent. Differences due to the higher order corrections also give an estimate of the size of theoretical uncertainties in the minimal supersymmetric standard model spectrum. We use these to provide estimates of theoretical uncertainties in predictions of the dark matter relic density (which can be of order one due to its strong dependence on sparticle masses) and the LHC sparticle production cross-section (often around 30%). The additional higher order corrections have been incorporated into SOFTSUSY, and we provide details on how to compile and use the program. We also provide a summary of the approximations used in the higher order corrections. Program Summary Nature of problem: Calculating supersymmetric particle spectrum and mixing parameters in the minimal supersymmetric standard model. The solution to the renormalisation group equations must be consistent with boundary conditions on supersymmetry breaking parameters, as well as the weak-scale boundary condition on gauge couplings, Yukawa couplings and the Higgs potential parameters. Program title: SOFTSUSY Catalogue identifier: ADPMv50 Program summary URL: http://cpc.cs.qub.ac.uk/summaries/ADPMv50.html Program obtainable from: CPC Program Library, Queen's University, Belfast, N. Ireland Licensing provisions: Standard CPC licence, http://cpc.cs.qub.ac.uk/licence/licence.html No. of lines in distributed program, including test data, etc.: 240528 No. of bytes in distributed program, including test data, etc.: 2597933 Distribution format: tar.gz Programming language: C++, Fortran. Computer: Personal computer. Operating system: Tested on Linux 3.4.6. Word size: 64 bits. Classification: 11.1, 11.6. External routines: At least GiNaC1.3.5 [1] and CLN1.3.1 (both freely obtainable from http://www.ginac.de). Does the new version supersede the previous version?: Yes Catalogue identifier of previous version: ADPMv40 Journal reference of previous version: Comput. Phys. Comm. 185 (2014) 2322 Solution method: Nested iterative algorithm. Reasons for new version: Extension to include additional two and three-loop terms. Summary of revisions: All quantities in the minimal supersymmetric standard model are extended to have three-loop renormalisation group equations (including 3-family mixing) in the limit of real parameters and some leading two-loop threshold corrections are incorporated to the third family Yukawa couplings and the strong gauge coupling. Restrictions: SOFTSUSY will provide a solution only in the perturbative regime and it assumes that all couplings of the model are real (i.e. CP-conserving). If the parameter point under investigation is non-physical for some reason (for example because the electroweak potential does not have an acceptable minimum), SOFTSUSY returns an error message. The higher order corrections included are for the real R-parity conserving minimal supersymmetric standard model (MSSM) only. Running time: A minute per parameter point. The tests provided with the package only take a few seconds to run.
|
|
|
|
Pastore, A., Davesne, D., & Navarro, J. (2015). Linear response of homogeneous nuclear matter with energy density functionals. Phys. Rep., 563, 1–67.
Abstract: Response functions of infinite nuclear matter with arbitrary isospin asymmetry are studied in the framework of the random phase approximation. The residual interaction is derived from a general nuclear Skyrme energy density functional. Besides the usual central, spin-orbit and tensor terms it could also include other components as new density-dependent terms or three-body terms. Algebraic expressions for the response functions are obtained from the Bethe-Salpeter equation for the particle-hole propagator. Applications to symmetric nuclear matter, pure neutron matter and asymmetric nuclear matter are presented and discussed. Spin-isospin strength functions are analyzed for varying conditions of density, momentum transfer, isospin asymmetry, and temperature for some representative Skyrme functionals. Particular attention is paid to the discussion of instabilities, either real or unphysical, which could manifest in finite nuclei.
|
|
