|
Pavao, R. P., Sakai, S., & Oset, E. (2017). Triangle singularities in B- -> D*(0)pi(-)pi(0)eta and B- -> D*(0)pi(-)pi(+)pi(-). Eur. Phys. J. C, 77(9), 599–8pp.
Abstract: The possible role of the triangle mechanism in the B- decay into D*(0)pi(-)pi(0)eta and D*(0)pi(-)pi(+)pi(-) is investigated. In this process, the triangle singularity appears from the decay of B- into D*K-0(-) K*(0) followed by the decay of K-*0 into pi(-) K+ and the fusion of the K+ K-, which forms the a(0)(980) or f(0)(980), which finally decay into pi(0)eta or pi(+)pi(-), respectively. The triangle mechanism from the (K) over bar * K (K) over bar loop generates a peak around 1420 MeV in the invariant mass of pi(-) a(0) or pi(-) f(0), and it gives sizable branching fractions, Br(B- -> D*(0)pi(-) a(0); a(0) -> pi(0)eta) = (1.66 +/- 0.45) x 10(-6) and Br(B- -> D*(0)pi(-) f(0); f(0) -> pi(+)pi(-)) = (2.82 +/- 0.75) x 10(-6).
|
|
|
Marco-Hernandez, R., Bau, M., Ferrari, M., Ferrari, V., Pedersen, F., & Soby, L. (2017). A Low-Noise Charge Amplifier for the ELENA Trajectory, Orbit, and Intensity Measurement System. IEEE Trans. Nucl. Sci., 64(9), 2465–2473.
Abstract: A low-noise head amplifier has been developed for the extra low energy antiproton ring beam trajectory, orbit, and intensity measurement system at CERN. This system is based on 24 double-electrode electrostatic beam position monitors installed around the ring. A head amplifier is placed close to each beam position monitor to amplify the electrode signals and generate a difference and a sum signal. These signals are sent to the digital acquisition system, about 50 m away from the ring, where they are digitized and further processed. The beam position can be measured by dividing the difference signal by the sum signal while the sum signal gives information relative to the beam intensity. The head amplifier consists of two discrete charge preamplifiers with junction field effect transistor (JFET) inputs, a sum and a difference stage, and two cable drivers. Special attention has been paid to the amplifier printed circuit board design to minimize the parasitic capacitances and inductances at the charge amplifier stages to meet the gain and noise requirements. The measurements carried out on the head amplifier showed a gain of 40.5 and 46.5 dB for the sum and difference outputs with a bandwidth from 200 Hz to 75 MHz and an input voltage noise density lower than 400 pV/v Hz. Twenty head amplifiers have been already installed in the ring and they have been used to detect the first beam signals during the first commissioning stage in November 2016.
|
|
|
LHCb Collaboration(Aaij, R. et al), Garcia Martin, L. M., Henry, L., Martinez-Vidal, F., Oyanguren, A., Remon Alepuz, C., et al. (2017). Measurement of B-s(0) and D-s(-) Meson Lifetimes. Phys. Rev. Lett., 119(10), 101801–10pp.
Abstract: We report on a measurement of the flavor-specific B-s(0) lifetime and of the D-s(-) lifetime using proton-proton collisions at center-of-mass energies of 7 and 8 TeV, collected by the LHCb experiment and corresponding to 3.0 fb(-1) of integrated luminosity. Approximately 407 000 B-s(0) -> D-s(()*()) -> D-s(()*()-) mu+v(mu) decays are partially reconstructed in the K+K-pi(-)mu(+) final state. The B-s(0) and D-s(-) natural widths are determined using, as a reference, kinematically similar B-0 -> Dd(*)(-) mu+v(mu) decays reconstructed in the same final state. The resulting differences between widths of B-s(0) and B-0 mesons and of D-s(-) and D- mesons are Delta(Gamma)(B) = -0.0115 +/- 0.0053(stat) +/- 0.0041 (syst) ps(-1) and Delta(Gamma)(D) = 1.0131 +/- 0.0117(stat) +/- 0.0065(syst) ps(-1), respectively. Combined with the known B-0 and D- lifetimes, these yield the flavor-specific B-s(0) lifetime, tau(fs)(Bs0) = 1.547 +/- 0.013 (stat) +/- 0.010 (syst) +/- 0.004(tau(B)) ps and the D-s(-) lifetime, tau(Ds-) = 0.5064 +/- 0.0030(stat) +/- 0.0017(syst) +/- 0.0017(sys) +/- 0.0017(tau(D)). The last uncertainties originate from the limited knowledge of the B-0 and D- lifetimes. The results improve upon current determinations.
|
|
|
Liang, W. H., Bayar, M., & Oset, E. (2017). Lambda(b) -> pi(-)(D-S(-)) Lambda(C)(2595), pi(-)(D-S(-)) Lambda(C)(2625) decays and DN, D*N molecular components. Eur. Phys. J. C, 77(1), 39–9pp.
Abstract: From the perspective that Lambda(C)(2595) and Lambda(C)(2625) are dynamically generated resonances from the DN, D*N interaction and coupled channels, we have evaluated the rates for Lambda(b) -> pi(-)Lambda(C)(2595) and Lambda(b) -> pi(-)Lambda(C)(2625) up to a global unknown factor that allows us to calculate the ratio of rates and compare with experiment, where good agreement is found. Similarly, we can also make predictions for the ratio of rates of the, yet unknown, decays of Lambda(b) -> D-s(-)Lambda(C)(2595) and Lambda(b) -> D-s(-)Lambda(c)(2625) and make estimates for their individual branching fractions.
|
|
|
Aliaga, R. J. (2017). Real-Time Estimation of Zero Crossings of Sampled Signals for Timing Using Cubic Spline Interpolation. IEEE Trans. Nucl. Sci., 64(8), 2414–2422.
Abstract: A scheme is proposed for hardware estimation of the location of zero crossings of sampled signals with subsample resolution for timing applications, which consists of interpolating the signal with a cubic spline near the zero crossing and then finding the root of the resulting polynomial. An iterative algorithm based on the bisection method is presented that obtains one bit of the result per step and admits an efficient digital implementation using fixed-point representation. In particular, the root estimation iteration involves only two additions, and the initial values can be obtained from finite impulse response (FIR) filters with certain symmetry properties. It is shown that this allows online real-time estimation of timestamps in free-running sampling detector systems with improved accuracy with respect to the more common linear interpolation. The method is evaluated with simulations using ideal and real timing signals, and estimates are given for the resource usage and speed of its implementation.
|
|
|
LHCb Collaboration(Aaij, R. et al), Garcia Martin, L. M., Henry, L., Martinez-Vidal, F., Oyanguren, A., Remon Alepuz, C., et al. (2017). Test of lepton universality with B-0 -> K*(0)l(+)l(-) decays. J. High Energy Phys., 08(8), 055–31pp.
Abstract: A test of lepton universality, performed by measuring the ratio of the branching fractions of the B-0 -> K*(0)mu(+) mu(-) and B-0 -> K*e(+)e(-) decays, R-K*0, is presented. The K*(0) meson is reconstructed in the final state K+pi(-), which is required to have an invariant mass within 100 MeV/c(2) of the known K*(892)(0) mass. The analysis is performed using proton-proton collision data, corresponding to an integrated luminosity of about 3 fb(-1), collected by the LHCb experiment at centre-of-mass energies of 7 and 8 TeV. The ratio is measured in two regions of the dilepton invariant mass squared, q(2), to be R-K*0 – {0.66(-0.007)(+0.11)(stat) +/- 0.03(syst) for 0.045 < q(2) < GeV2/c(4), 0.69(-0.07)(+0.11)(stat) +/- 0.05(syst) for 1.1 < q(2) < 6.0 GeV2/c(4). The corresponding 95.4% confidence level intervals are [0.52, 0.89] and [0.53, 0.94]. The results, which represent the most precise measurements of R-K*0 to date, are compatible with the Standard Model expectations at the level of 2.1-2.3 and 2.4-2.5 standard deviations in the two q(2) regions, respectively.
|
|
|
ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Barranco Navarro, L., Cabrera Urban, S., Castillo Gimenez, V., Cerda Alberich, L., et al. (2017). Measurement of the inclusive jet cross-sections in proton-proton collisions at root s=8 TeV with the ATLAS detector. J. High Energy Phys., 09(9), 020–54pp.
Abstract: Inclusive jet production cross-sections are measured in proton-proton collisions at a centre-of-mass energy of root s = 8 TeV recorded by the ATLAS experiment at the Large Hadron Collider at CERN. The total integrated luminosity of the analysed data set amounts to 20.2 fb(-1). Double-differential cross-sections are measured for jets defined by the anti-k(t) jet clustering algorithm with radius parameters of R = 0.4 and R = 0.6 and are presented as a function of the jet transverse momentum, in the range between 70 GeV and 2.5 TeV and in six bins of the absolute jet rapidity, between 0 and 3.0. The measured cross-sections are compared to predictions of quantum chromodynamics, calculated at next-to-leading order in perturbation theory, and corrected for non-perturbative and electroweak effects. The level of agreement with predictions, using a selection of different parton distribution functions for the proton, is quantified. Tensions between the data and the theory predictions are observed.
|
|
|
Kosmas, T. S., Papoulias, D. K., Tortola, M., & Valle, J. W. F. (2017). Probing light sterile neutrino signatures at reactor and Spallation Neutron Source neutrino experiments. Phys. Rev. D, 96(6), 063013–12pp.
Abstract: We investigate the impact of a fourth sterile neutrino at reactor and Spallation Neutron Source neutrino detectors. Specifically, we explore the discovery potential of the TEXONO and COHERENT experiments to subleading sterile neutrino effects through the measurement of the coherent elastic neutrino-nucleus scattering event rate. Our dedicated chi(2)-sensitivity analysis employs realistic nuclear structure calculations adequate for high purity sub-keV threshold Germanium detectors.
|
|
|
ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Barranco Navarro, L., Cabrera Urban, S., Castillo Gimenez, V., Cerda Alberich, L., et al. (2017). Search for new phenomena in a lepton plus high jet multiplicity final state the ATLAS experiment using root S=13 TeV proton-proton collision data. J. High Energy Phys., 09(9), 088–50pp.
Abstract: A search for new phenomena in final states characterized by high jet multiplicity, an isolated lepton ( electron or muon) and either zero or at least three b-tagged jets is presented. The search uses 36.1 fb(-1) of root s = 13TeV proton-proton collision data collected by the ATLAS experiment at the Large Hadron Collider in 2015 and 2016. The dominant sources of background are estimated using parameterized extrapolations, based on observables at medium jet multiplicity, to predict the b-tagged jet multiplicity distribution at the higher jet multiplicities used in the search. No significant excess over the Standard Model expectation is observed and 95% confidence-level limits are extracted constraining four simplified models of R-parity-violating supersymmetry that feature either gluino or top-squark pair production. The exclusion limits reach as high as 2.1TeV in gluino mass and 1.2TeV in top-squark mass in the models considered. In addition, an upper limit is set on the cross-section for Standard Model t (t) over bart (t) over bar production of 60 fb (6.5 x the Standard Model prediction) at 95% confidence level. Finally, model-independent limits are set on the contribution from new phenomena to the signal-region yields.
|
|
|
Vento, V. (2017). AdS gravity and the scalar glueball spectrum. Eur. Phys. J. A, 53(9), 185–4pp.
Abstract: The scalar glueball spectrum has attracted much attention since the formulation of Quantum Chromodynamics. Different approaches give very different results for the glueball masses. We revisit the problem from the perspective of the AdS/CFT correspondence.
|
|