Abstract: This paper presents a study of the radiation hardness of the hadronic Tile Calorimeter of the ATLAS experiment in the LHC Run 2. Both the plastic scintillators constituting the detector active media and the wavelength-shifting optical fibres collecting the scintillation light into the photodetector readout are elements susceptible to radiation damage. The dedicated calibration and monitoring systems of the detector (caesium radioactive sources, laser and minimum bias integrator) allow to assess the response of these optical components. Data collected with these systems between 2015 and 2018 are analysed to measure the degradation of the optical instrumentation across Run 2. Moreover, a simulation of the total ionising dose in the calorimeter is employed to study and model the degradation profile as a function of the exposure conditions, both integrated dose and dose rate. The measurement of the relative light output loss in Run 2 is presented and extrapolations to future scenarios are drawn based on current data. The impact of radiation damage on the cell response uniformity is also analysed.

Abstract: The Deep Underground Neutrino Experiment (DUNE) is a long-baseline neutrino experiment based in the U.S.A. and composed of a Near Detector (ND) complex at Fermi National Laboratory (FNAL), and a Far Detector (FD) complex located at the Sanford Underground Research Facility (SURF) similar to 1300 km distant. DUNE will study neutrino oscillations looking for unresolved issues of the Standard Model of particle physics (SM) such as CP violation in the leptonic sector, neutrino mass ordering and others, starting from the early 2030s. The FD, with a mass of similar to 17 kt, that will exploit both ionization and scintillation signals to detect neutrino interactions with Argon. Scintillating photons in LAr will be detected by the photon detection system (PDS) based on light collectors coupled to Silicon Photomultipliers (SiPMs). During a test campaign, different laboratories of the collaboration performed an investigation of the best SiPM candidates that fulfill the DUNE FD requirements. We identified two models of SiPM, produced by Hamamatsu Photonics K.K. (HPK) and Fondazione Bruno Kessler (FBK), respectively. In this paper, we focus on the FBK selected model showing its main features. We will describe the characterization protocol, the results at both room and cryogenic temperatures and the photon detection efficiency measurements.

Abstract: The inner tracking system of the ATLAS experiment will be upgraded to a full silicon detector in 2030 for HL-LHC. The new tracking system is called ITk, the Inner Tracker. The ITk requirements include operational efficiency higher than 99% and noise hit occupancy smaller than 0.1%. During the pre-production phase of the ITk project, many short-strip modules were observed to exhibit so-called “Cold Noise (CN)”, wherein clusters of strips displayed very high noise when the modules were operated at temperatures below-35 degrees C. To investigate the CN impact and ensure the quality of module production, huge amount of effort have been put in by the collaboration. This paper focuses on the impact of CN on the tracking performance by examining two short strip modules that exhibit CN: one is non-irradiated, while the other one has been irradiated to the maximum expected end-of-lifetime fluence. For each module, the global and single strip tracking performance are evaluated. The global performance study shows that the non-irradiated module can be operated within specifications with a threshold around 1fC, but it is not possible to operate the irradiated module as required. In the single strip analysis, it was found that while CN does not affect the charge collection, it reduces the operating window and leaves less margin for detector operation. In the non-irradiated module, less than 3% of strips fail the detector requirements in the CN regions. For the irradiated module, about 20% of strips fail the requirements in the low CN region and around 52% fail in the high CN region. The fraction of strips that cannot operate due to CN throughout their lifetime can be predicted according to the measured noise at the required noise occupancy level and its expected median collected charge. In cases when the noise hit occupancy caused by CN is kept below 1% with a threshold smaller than 0.45 fC, at least 60% of strips could meet the operating requirements by the end of detector's lifetime. Thus, the module is likely to satisfy the operating requirements in terms of global efficiency and global noise occupancy.