|
|
Tain, J. L., Agramunt, J., Algora, A., Aprahamian, A., Cano-Ott, D., Fraile, L. M., et al. (2015). The sensitivity of LaBr3:Ce scintillation detectors to low energy neutrons: Measurement and Monte Carlo simulation. Nucl. Instrum. Methods Phys. Res. A, 774, 17–24.
Abstract: The neutron sensitivity of a cylindrical circle minus 1.5 in x 1.5 in LaBr3:Ce scintillation detector was measured using quasi-monoenergetic neutron beams in the energy range from 40 keV to 2.5 MeV. In this energy range the detector is sensitive to gamma-rays generated in neutron inelastic and capture processes. The experimental energy response was compared with Monte Carlo simulations performed with the Geant4 simulation toolkit using the so-called High Precision Neutron Models. These models rely on relevant information stored in evaluated nuclear data libraries. The performance of the Geant4 Neutron Data Library as well as several standard nuclear data libraries was investigated. In the latter case this was made possible by the use of a conversion tool that allowed the direct use of the data from other libraries in Geant4. Overall it was found that there was good agreement with experiment for some of the neutron data bases like ENDF/B-VII.0 or JENDL-3.3 but not with the others such as ENDF/B-VI.8 or JEFF-3.1.
|
|
|
|
LHCb Collaboration(Aaij, R. et al), Martinez-Vidal, F., Oyanguren, A., Ruiz Valls, P., & Sanchez Mayordomo, C. (2015). Study of eta-eta ' mixing from measurement of B-(s)(0) -> J/psi eta((')) decay rates. J. High Energy Phys., 01(1), 024–24pp.
Abstract: A study of B and B-s(0) meson decays into J/psi eta and J/psi eta' final states is performed using a data set of proton-proton collisions at centre-of-mass energies of 7 and 8 TeV, collected by the LCHb experiment and corresponding to 3.0 fb(-1) of integrated luminosity. The decay B-0 -> J/psi eta' is observed for the first time. The following ratios of branching fractions are measured: B(B-0 -> J psi eta')/B(B-s(0) -> J psi eta') = (2.28 +/- 0.65 (stat) +/- 0.010 (syst) +/- 0.13 (f(s)/f(d)) x 10(-2) , B(B-0 -> J psi eta')/B(B-s(0) -> J psi eta') = (1.85 +/- 0.65 (stat) +/- 0.09 (syst) +/- 0.11 (f(s)/f(d)) x 10(-2) where the third uncertainty is related to the present knowledge of f(s)/f(d), the ratio between the probabilities for a b quark to form a B-s(0) or a B-0 meson. The branching fraction ratios are used to determine the parameters of eta-eta' meson mixing. In addition, the first evidence for the decay B-s(0) -> psi(2S)' is reported, and the relative branching fraction is measured, B(B-s(0) -> psi(2S)eta')/B(B-s(0) -> J psi eta') = (38.7 +/- 9.0 (stat) +/- 1.3 (syst) +/- 0.9(B)) x 10(-2), where the third uncertainty is due to the limited knowledge of the branching fractions of J/psi and psi(2S) mesons.
|
|
|
|
Molina, F. et al, Rubio, B., Agramunt, J., Algora, A., Domingo-Pardo, C., Gadea, A., et al. (2015). T-z =-1 -> 0 beta decays of Ni-54, Fe-50, Cr-46, and Ti-42 and comparison with mirror (He-3,t) measurements. Phys. Rev. C, 91(1), 014301–19pp.
Abstract: We have studied the beta decay of the T-z = -1, f(7/2) shell nuclei Ni-54, Fe-50, Cr-46, and Ti-42 produced in fragmentation reactions. The proton separation energies in the daughter T-z = 0 nuclei are relatively large (approximate to 4-5 MeV) so studies of the. rays are essential. The experiments were performed at GSI as part of the Stopped-beam campaign with the RISING setup consisting of 15 Euroball Cluster Ge detectors. From the newly obtained high precision beta-decay half-lives, excitation energies, and beta branching ratios, we were able to extract Fermi and Gamow-Teller transition strengths in these beta decays. With these improved results it was possible to compare in detail the Gamow-Teller (GT) transition strengths observed in beta decay including a sensitivity limit with the strengths of the T-z = +1 to T-z = 0 transitions derived from high resolution (He-3,t) reactions on the mirror target nuclei at RCNP, Osaka. The accumulated B(GT) strength obtained from both experiments looks very similar although the charge exchange reaction provides information on a broader energy range. Using the “merged analysis” one can obtain a full picture of the B(GT) over the full Q(beta) range. Looking at the individual transitions some differences are observed, especially for the weak transitions. Their possible origins are discussed.
|
|
|
|
Modamio, V., Valiente-Dobon, J. J., Jaworski, G., Huyuk, T., Triossi, A., Egea, J., et al. (2015). Digital pulse-timing technique for the neutron detector array NEDA. Nucl. Instrum. Methods Phys. Res. A, 775, 71–76.
Abstract: A new digital pulse-timing algorithm, to be used with the future neutron detector array NEDA, has been developed and tested. The time resolution of four 5 in diameter photomultiplier tubes (XP4512, R4144, R11833-100, and ET9390-kb), coupled to a cylindrical 5 in by 5 in BC501A liquict scintillator detector was measured by employing digital sampling electronics and a constant fraction discriminator (CFD) algorithm. The zero crossing of the CM algorithm was obtained with a cubic spline interpolation, which was continuous up to the second derivative. The performance of the algorithm was studied at sampling rates of 500 MS/s and 200 MS/s. The time resolution obtained with the digital electronics was compared to the values acquired with a standard analog CFD. The result of this comparison shows that the time resolution from the analog and the digital measurements at 500 MS/s and at 200 MS/s are within 15% for all the tested photomultiplier tubes.
|
|
|
|
Olmo, G. J., & Rubiera-Garcia, D. (2015). Brane-world and loop cosmology from a gravity-matter coupling perspective. Phys. Lett. B, 740, 73–79.
Abstract: We show that the effective brane-world and the loop quantum cosmology background expansion histories can be reproduced from a modified gravity perspective in terms of an f (R) gravity action plus a g(R) term non-minimally coupled with the matter Lagrangian. The reconstruction algorithm that we provide depends on a free function of the matter density that must be specified in each case and allows to obtain analytical solutions always. In the simplest cases, the function f (R) is quadratic in the Ricci scalar, R, whereas g(R) is linear. Our approach is compared with recent results in the literature. We show that working in the Palatini formalism there is no need to impose any constraint that keeps the equations second order, which is a key requirement for the successful implementation of the reconstruction algorithm.
|
|
