|
|
Aguilar, A. C., Ibañez, D., & Papavassiliou, J. (2013). Ghost propagator and ghost-gluon vertex from Schwinger-Dyson equations. Phys. Rev. D, 87(11), 114020–14pp.
Abstract: We study an approximate version of the Schwinger-Dyson equation that controls the nonperturbative behavior of the ghost-gluon vertex in the Landau gauge. In particular, we focus on the form factor that enters in the dynamical equation for the ghost dressing function, in the same gauge, and derive its integral equation, in the “one-loop dressed” approximation. We consider two special kinematic configurations, which simplify the momentum dependence of the unknown quantity; in particular, we study the soft gluon case and the well-known Taylor limit. When coupled with the Schwinger-Dyson equation of the ghost dressing function, the contribution of this form factor provides considerable support to the relevant integral kernel. As a consequence, the solution of this coupled system of integral equations furnishes a ghost dressing function that reproduces the standard lattice results rather accurately, without the need to artificially increase the value of the gauge coupling.
|
|
|
|
Albaladejo, M., Hidalgo-Duque, C., Nieves, J., & Oset, E. (2013). Hidden charm molecules in finite volume. Phys. Rev. D, 88(1), 014510–18pp.
Abstract: In the present paper we address the interaction of pairs of charmed mesons with hidden charm in a finite box. We use the interaction from a recent model based on heavy-quark spin symmetry that predicts molecules of hidden charm in the infinite volume. The energy levels in the box are generated within this model, and from them some synthetic data are generated. These data are then employed to study the inverse problem of getting the energies of the bound states and phase shifts for D (D) over bar or D*(D) over bar*. Different strategies are investigated using the lowest two levels for different values of the box size, and the errors produced are studied. Starting from the upper level, fits to the synthetic data are carried out to determine the scattering length and effective range plus the binding energy of the ground state. A similar strategy using the effective range formula is considered with a simultaneous fit to the two levels-one above and the other one below the threshold. This method turns out to be more efficient than the previous one. Finally, a method based on the fit to the data by means of a potential and a conveniently regularized loop function, turns out to be very efficient and allows us to produce accurate results in the infinite volume starting from levels of the box with errors far larger than the uncertainties obtained in the final results. A regularization method based on Gaussian wave functions turns out to be rather efficient in the analysis and as a byproduct a practical and fast method to calculate the Luscher function with high precision is presented.
|
|
|
|
Albaladejo, M., & Oset, E. (2013). Combined analysis of the pn -> d pi(+)pi(-) and pn -> pn pi(+)pi(-) cross sections and implications for the interpretation of the pn -> d pi(+)pi(-) data. Phys. Rev. C, 88(1), 014006–6pp.
Abstract: We use recent data that show a narrow peak around root s = 2.37 GeV in the pn -> d pi(+)pi(-) cross section, with about double strength at the peak than in the analogous pn -> d pi(0)pi(0) reaction, and, assuming that it is due to the excitation of a dibaryon resonance, we evaluate the cross section for the pn -> pn pi(+)pi(-) reaction, with the final pn unbound but with the same quantum numbers as the deuteron. We use accurate techniques to determine the final state interaction in the case of the pn forming a deuteron or a positive energy state, which allow us to get the pn -> pn pi(+)pi(-) cross section with pn in I = 0 and S = 1, that turns out to be quite close or saturates the experimental pn -> pn pi(+)pi(-) total cross section around root s = 2.37 GeV, depending on the angular momentum assumed. This poses problems to the assumption of the dibaryon hypothesis, which could be rendered more restrictive with future precise data on the pn -> pn pi(+)pi(-) reaction.
|
|
|
|
ALEPH, D. E. L. P. H. I., L3 and OPAL Collaborations, LEP Electroweak Working Group(Schael, S. et al), Costa, M. J., Ferrer, A., Fuster, J., Garcia, C., Oyanguren, A., et al. (2013). Electroweak measurements in electron positron collisions at W-boson-pair energies at LEP. Phys. Rep., 532(4), 119–244.
Abstract: Electroweak measurements performed with data taken at the electron positron collider LEP at CERN from 1995 to 2000 are reported. The combined data set considered in this report corresponds to a total luminosity of about 3 fb(-1) collected by the four LEP experiments ALEPH, DELPHI, 13 and OPAL, at centre-of-mass energies ranging from 130 GeV to 209 GeV. Combining the published results of the four LEP experiments, the measurements include total and differential cross-sections in photon-pair, fermion-pair and four-fermion production, the latter resulting from both double-resonant WW and ZZ production as well as singly resonant production. Total and differential cross-sections are measured precisely, providing a stringent test of the Standard Model at centre-of-mass energies never explored before in electron positron collisions. Final-state interaction effects in four-fermion production, such as those arising from colour reconnection and Bose Einstein correlations between the two W decay systems arising in WW production, are searched for and upper limits on the strength of possible effects are obtained. The data are used to determine fundamental properties of the W boson and the electroweak theory. Among others, the mass and width of the W boson, m(w) and Gamma(w), the branching fraction of W decays to hadrons, B(W -> had), and the trilinear gauge-boson self-couplings g(1)(Z), K-gamma and lambda(gamma), are determined to be: m(w) = 80.376 +/- 0.033 GeV Gamma(w) = 2.195 +/- 0.083 GeV B(W -> had) = 67.41 +/- 0.27% g(1)(Z) = 0.984(-0.020)(+0.018) K-gamma – 0.982 +/- 0.042 lambda(gamma) = 0.022 +/- 0.019.
|
|
|
|
Alesini, D., Boni, R., Di Pirro, G., Di Raddo, R., Ferrario, M., Gallo, A., et al. (2013). The C-Band accelerating structures for SPARC photoinjector energy upgrade. J. Instrum., 8, P05004–24pp.
Abstract: The use of C-Band structures for electron acceleration and production of high quality beams has been proposed and adopted in several linac projects all over the world. The two main projects that adopted such type of structures are the Japanese Free Electron Laser (FEL) project in Spring-8 and the SwissFEL project at Paul Scherrer Institute (PSI). Also the energy upgrade of the SPARC photo-injector at LNF-INFN (Italy) from 150 to more than 240 MeV will be done by replacing a low gradient S-Band accelerating structure with two C-band structures. The structures are Traveling Wave (TW) and Constant Impedance (CI), have symmetric axial input couplers and have been optimized to work with a SLED RF input pulse. The paper presents the design criteria of the structures, the realization procedure and the low and high power RF test results on a prototype. The high power tests have been carried out by the Frascati INFN Laboratories in close collaboration with the Japanese Laboratory KEK. Experimental results confirmed the feasibility of the operation of the prototype at 50 MV/m with about 10(6) breakdowns per pulse per meter. Such high gradients have not been reached before in C-Band systems and demonstrated the possibility to use C-band accelerators, if needed, at such high field level. The results of the internal inspection of the structure after the high power test are also presented.
|
|
