|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2014). Measurement of dijet cross-sections in pp collisions at 7 TeV centre-of-mass energy using the ATLAS detector. J. High Energy Phys., 05(5), 059–67pp.
Abstract: Double-differential dijet cross-sections measured in pp collisions at the LHC with a 7 TeV centre-of-mass energy are presented as functions of dijet mass and half the rapidity separation of the two highest-p(T) jets. These measurements are obtained using data corresponding to an integrated luminosity of 4.5 fb(-1), recorded by the ATLAS detector in 2011. The data are corrected for detector effects so that cross-sections are presented at the particle level. Cross-sections are measured up to 5 TeV dijet mass using jets reconstructed with the anti-k(t) algorithm for values of the jet radius parameter of 0.4 and 0.6. The cross-sections are compared with next-to-leading-order perturbative QCD calculations by NLOJet++ corrected to account for non-perturbative effects. Comparisons with POWHEG predictions, using a next-to-leading-order matrix element calculation interfaced to a parton-shower Monte Carlo simulation, are also shown. Electroweak effects are accounted for in both cases. The quantitative comparison of data and theoretical predictions obtained using various parameterizations of the parton distribution functions is performed using a frequentist method. In general, good agreement with data is observed for the NLOJet++ theoretical predictions when using the CT10, NNPDF2.1 and MSTW 2008 PDF sets. Disagreement is observed when using the ABM11 and HERAPDF1.5 PDF sets for some ranges of dijet mass and half the rapidity separation. An example setting a lower limit on the compositeness scale for a model of contact interactions is presented, showing that the unfolded results can be used to constrain contributions to dijet production beyond that predicted by the Standard Model.
|
|
|
|
BABAR Collaboration(Lees, J. P. et al), Martinez-Vidal, F., Oyanguren, A., & Villanueva-Perez, P. (2014). Dalitz plot analysis of eta(c) -> K+K-eta and eta(c) -> K+K-pi(0) in two-photon interactions. Phys. Rev. D, 89(11), 112004–16pp.
Abstract: We study the processes gamma gamma -> K+K-eta and gamma gamma -> K+K-pi(0) using a data sample of 519 fb(-1) recorded with the BABAR detector operating at the SLAC PEP-II asymmetric-energy e(+)e(-) collider at center-of-mass energies at and near the Upsilon(nS) (n = 2, 3, 4) resonances. We observe eta(c) -> K+K-pi(0) and eta(c) -> K+K-eta decays, measure their relative branching fraction, and perform a Dalitz plot analysis for each decay. We observe the K*(0)(1430) -> K eta decay and measure its branching fraction relative to the K pi decay mode to be R(K*(0)(1430)) = B(K*(0)(1430)-> K eta)/B(K*(0)(1430)-> K pi) = 0.092 +/- 0.025(- 0.025)(+0.010). The eta(c) -> K+K-eta and K*(0)(1430) -> K eta results correspond to the first observations of these channels. The data also show evidence for eta(c)(2S) -> K+K-pi(0) and first evidence for eta(c)(2S) -> K+K-eta.
|
|
|
|
BABAR Collaboration(Lees, J. P. et al), Martinez-Vidal, F., Oyanguren, A., & Villanueva-Perez, P. (2014). Measurement of the B -> X(s)l(+)l(-) Branching Fraction and Search for Direct CP Violation from a Sum of Exclusive Final States. Phys. Rev. Lett., 112(21), 211802–8pp.
Abstract: We measure the total branching fraction of the flavor-changing neutral-current process B -> X(s)l(+)l(-), along with partial branching fractions in bins of dilepton and hadronic system (X-s) mass, using a sample of 471 x 10(6)Upsilon(4S) -> B (B) over bar events recorded with the BABAR detector. The admixture of charged and neutral B mesons produced at PEP-II2 are reconstructed by combining a dilepton pair with 10 different X-s final states. Extrapolating from a sum over these exclusive modes, we measure a lepton-flavor-averaged inclusive branching fraction B(B -> X(s)l(+)l(-)) = [6.73(-0.64)(+0.70)(stat)(-0.25)(+0.34)(exp syst) +/- 0.50(model syst)] x 10(-6) for m(l+l-)(2) > 0.1 GeV2/c(4). Restricting our analysis exclusively to final states from which a decaying B meson's flavor can be inferred, we additionally report measurements of the direct CP asymmetry A(CP) in bins of dilepton mass; over the full dilepton mass range, we find A(CP) = 0.04 +/- 0.11 +/- 0.01 for a leptonflavor-averaged sample.
|
|
|
|
n_TOF Collaboration(Zugec, P. et al), Domingo-Pardo, C., Giubrone, G., & Tain, J. L. (2014). GEANT4 simulation of the neutron background of the C6D6 set-up for capture studies at n_TOF. Nucl. Instrum. Methods Phys. Res. A, 760, 57–67.
Abstract: The neutron sensitivity of the Cr6D6 detector setup used at nTOF facility for capture measurements has been studied by means of detailed GEANT4 simulations. A realistic software replica of the entire nTOF experimental hall, including the neutron beam line, sample, detector supports and the walls of the experimental area has been implemented in the simulations. The simulations have been analyzed in the same manner as experimental data, in particular by applying the Pulse Height Weighting Technique. The simulations have been validated against a measurement of the neutron background performed with a(nat)-C sample, showing an excellent agreement above 1 keV. At lower energies, an additional component in the measured C-nat yield has been discovered, which prevents the use of C-nat data for neutron background estimates at neutron energies below a few hundred eV. The origin and time structure of the neutron background have been derived from the simulations. Examples of the neutron background for two different samples are demonstrating the important role of accurate simulations of the neutron background in capture cross-section measurements.
|
|
|
|
Goasduff, A., Valiente-Dobon, J. J., Lunardi, S., Haas, F., Gadea, A., de Angelis, G., et al. (2014). Counting rate measurements for lifetime experiments using the RDDS method with the new generation gamma-ray array AGATA. Nucl. Instrum. Methods Phys. Res. A, 758, 1–3.
Abstract: The differential Recoil Distance Doppler Shift (RDDS) method after multinucleon transfer (MNT) reactions to measure lifetimes of excited states in neutron-rich nuclei requires the use of a thick energy degrader for the recoiling ejectiles that are then detected in a spectrometer. This type of measurements greatly benefits from the use of the new generation segmented gamma-ray detectors, such as the AGATA demonstrator which offers unprecedented energy and angular resolutions. In order to make an optimized choice of the material and the thickness of the degrader for lifetime measurements using the RODS method after MNT, an experiment has been performed with the AGATA demonstrator. Counting rate measurements for different degraders are presented.
|
|
