|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2014). Measurement of chi(c1) and chi(c2) production with root s=7 TeV pp collisions at ATLAS. J. High Energy Phys., 07(7), 154–52pp.
Abstract: The prompt and non-prompt production cross-sections for the chi(c1) and chi(c2) charmonium states are measured in pp collisions at root s = 7TeV with the ATLAS detector at the LHC using 4.5 fb(-1) of integrated luminosity. The chi(c) states are reconstructed through the radiative decay chi c -> J/psi gamma ( with J/psi -> mu(+)mu(-)) where photons are reconstructed from gamma -> e(+)e(-) conversions. The production rate of the chi(c2) state relative to the chi(c1) state is measured for prompt and non-prompt chi(c) as a function of J/psi transverse momentum. The prompt chi(c) cross-sections are combined with existing measurements of prompt J/psi production to derive the fraction of prompt J/psi produced in feed-down from chi(c) decays. The fractions of chi(c1) and chi(c2) produced in b-hadron decays are also measured.
|
|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2014). Light-quark and gluon jet discrimination in collisions at root s=7 TeV with the ATLAS detector. Eur. Phys. J. C, 74(8), 3023–29pp.
Abstract: A likelihood-based discriminant for the identification of quark- and gluon-initiated jets is built and validated using 4.7 fb of proton-proton collision data at collected with the ATLAS detector at the LHC. Data samples with enriched quark or gluon content are used in the construction and validation of templates of jet properties that are the input to the likelihood-based discriminant. The discriminating power of the jet tagger is established in both data and Monte Carlo samples within a systematic uncertainty of 10-20 %. In data, light-quark jets can be tagged with an efficiency of while achieving a gluon-jet mis-tag rate of in a range between and for jets in the acceptance of the tracker. The rejection of gluon-jets found in the data is significantly below what is attainable using a Pythia 6 Monte Carlo simulation, where gluon-jet mis-tag rates of 10 % can be reached for a 50 % selection efficiency of light-quark jets using the same jet properties.
|
|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2014). Monitoring and data quality assessment of the ATLAS liquid argon calorimeter. J. Instrum., 9, P07024–55pp.
Abstract: The liquid argon calorimeter is a key component of the ATLAS detector installed at the CERN Large Hadron Collider. The primary purpose of this calorimeter is the measurement of electron and photon kinematic properties. It also provides a crucial input for measuring jets and missing transverse momentum. An advanced data monitoring procedure was designed to quickly identify issues that would affect detector performance and ensure that only the best quality data are used for physics analysis. This article presents the validation procedure developed during the 2011 and 2012 LHC data-taking periods, in which more than 98% of the proton-proton luminosity recorded by ATLAS at a centre-of-mass energy of 7-8 TeV had calorimeter data quality suitable for physics analysis.
|
|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2014). Measurement of event-plane correlations in root s(NN)=2.76 TeV lead-lead collisions with the ATLAS detector. Phys. Rev. C, 90(2), 024905–29pp.
Abstract: A measurement of event-plane correlations involving two or three event planes of different order is presented as a function of centrality for 7 μb(-1) Pb + Pb collision data at v root s(NN) = 2.76 TeV, recorded by the ATLAS experiment at the Large Hadron Collider. Fourteen correlators are measured using a standard event-plane method and a scalar-product method, and the latter method is found to give a systematically larger correlation signal. Several different trends in the centrality dependence of these correlators are observed. These trends are not reproduced by predictions based on the Glauber model, which includes only the correlations from the collision geometry in the initial state. Calculations that include the final-state collective dynamics are able to describe qualitatively, and in some cases also quantitatively, the centrality dependence of the measured correlators. These observations suggest that both the fluctuations in the initial geometry and the nonlinear mixing between different harmonics in the final state are important for creating these correlations in momentum space.
|
|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2014). Flavor tagged time-dependent angular analysis of the B-s(0) -> J/psi phi decay and extraction of Delta Gamma(s) and the weak phase phi(s) in ATLAS. Phys. Rev. D, 90(5), 052007–26pp.
Abstract: A measurement of the B-s(0) -> J/psi phi decay parameters, updated to include flavor tagging is reported using 4.9 fb(-1) of integrated luminosity collected by the ATLAS detector from root s = 7 TeV pp collisions recorded in 2011 at the LHC. The values measured for the physical parameters are phi(s) = 0.12 +/- 0.25(stat) +/- 0.05(syst) rad Delta Gamma(s) = 0.053 +/- 0.021(stat) +/- 0.010(syst) ps(-1) Gamma(s) = 0.677 +/- 0.007(stat) +/- 0.004(syst) ps(-1) vertical bar A(parallel to)(0)vertical bar(2) = 0.220 +/- 0.008(stat) +/- 0.009(syst) vertical bar A(0)(0)vertical bar(2) = 0.529 +/- 0.006(stat) +/- 0.012(syst) delta(perpendicular to) = 3.89 +/- 0.47(stat) +/- 0.11(syst) rad where the parameter Delta Gamma(s) is constrained to be positive. The S-wave contribution was measured and found to be compatible with zero. Results for phi(s) and Delta Gamma(s) are also presented as 68% and 95% likelihood contours, which show agreement with the Standard Model expectations.
|
|