T2K Collaboration(Abe, K. et al), Cervera-Villanueva, A., Escudero, L., Izmaylov, A., Sorel, M., & Stamoulis, P. (2015). Neutrino oscillation physics potential of the T2K experiment. Prog. Theor. Exp. Phys., (4), 043C01–36pp.
Abstract: The observation of the recent electron neutrino appearance in a muon neutrino beam and the high-precision measurement of the mixing angle theta(13) have led to a re-evaluation of the physics potential of the T2K long-baseline neutrino oscillation experiment. Sensitivities are explored for CP violation in neutrinos, non-maximal sin(2) 2 theta(23), the octant of theta(23), and the mass hierarchy, in addition to the measurements of delta CP, sin(2) theta(23), and Delta m(32)(2), for various combinations of nu-mode and (nu) over bar -mode data-taking. With an exposure of 7.8 x 10(21) protons-on-target, T2K can achieve 1 sigma resolution of 0.050 (0.054) on sin(2) theta(23) and 0.040 (0.045) x 10(-3) eV(2) on Delta m(32)(2) for 100% (50%) neutrino beam mode running assuming sin(2) theta(23) = 0.5 and Delta m(32)(2) = 2.4 x 10(-3) eV(2). T2K will have sensitivity to the CP-violating phase delta(CP) at 90% C.L. or better over a significant range. For example, if sin(2) 2 theta(23) is maximal (i.e.theta(23) = 45 degrees) the range is -115 degrees < delta(CP) < -60 degrees for normal hierarchy and +50 degrees < delta(CP) < + 130 degrees for inverted hierarchy. When T2K data is combined with data from the NO nu A experiment, the region of oscillation parameter space where there is sensitivity to observe a non-zero delta CP is substantially increased compared to if each experiment is analyzed alone.
|
T2K Collaboration(Abe, K. et al), Cervera-Villanueva, A., Escudero, L., Izmaylov, A., Sorel, M., & Stamoulis, P. (2015). Measurement of the electron neutrino charged-current interaction rate on water with the T2K ND280 pi(0) detector. Phys. Rev. D, 91(11), 112010–11pp.
Abstract: This paper presents a measurement of the charged current interaction rate of the electron neutrino beam component of the beam above 1.5 GeV using the large fiducial mass of the T2K pi(0) detector. The predominant portion of the v(e) flux (similar to 85%) at these energies comes from kaon decays. The measured ratio of the observed beam interaction rate to the predicted rate in the detector with water targets filled is 0.89 +/- 0.08(stat) +/- 0.11(sys), and with the water targets emptied is 0.90 +/- 0.09(stat) +/- 0.13 (sys). The ratio obtained for the interactions on water only from an event subtraction method is 0.87 +/- 0.33(stat) +/- 0.21(sys). This is the first measurement of the interaction rate of electron neutrinos on water, which is particularly of interest to experiments with water Cherenkov detectors.
|
T2K Collaboration(Abe, K. et al), Cervera-Villanueva, A., Escudero, L., Izmaylov, A., Sorel, M., & Stamoulis, P. (2015). Measurement of the nu(mu) charged-current quasielastic cross section on carbon with the ND280 detector at T2K. Phys. Rev. D, 92(11), 112003–14pp.
Abstract: This paper reports a measurement by the T2K experiment of the nu(mu) charged current quasielastic (CCQE) cross section on a carbon target with the off-axis detector based on the observed distribution of muon momentum (rho(mu)) and angle with respect to the incident neutrino beam (theta(mu)). The flux-integrated CCQE cross section was measured to be <sigma > = (0.83 +/- 0.12) x 10(-38) cm(2). The energy dependence of the CCQE cross section is also reported. The axial mass, M-A(QE), of the dipole axial form factor was extracted assuming the Smith-Moniz CCQE model with a relativistic Fermi gas nuclear model. Using the absolute (shape-only) rho(mu)-cos theta(mu) distribution, the effective M-A(QE) parameter was measured to be 1.26(-0.18)(+0.21) GeV/c(2) (1.43(-0.22)(+0.28) GeV/c(2)).
|
T2K Collaboration(Abe, K. et al), Cervera-Villanueva, A., Escudero, L., Gomez-Cadenas, J. J., Izmaylov, A., Monfregola, L., et al. (2014). Observation of Electron Neutrino Appearance in a Muon Neutrino Beam. Phys. Rev. Lett., 112(6), 061802–8pp.
Abstract: The T2K experiment has observed electron neutrino appearance in a muon neutrino beam produced 295 km from the Super-Kamiokande detector with a peak energy of 0.6 GeV. A total of 28 electron neutrino events were detected with an energy distribution consistent with an appearance signal, corresponding to a significance of 7.3 sigma when compared to 4.92 +/- 0.55 expected background events. In the Pontecorvo-Maki-Nakagawa-Sakata mixing model, the electron neutrino appearance signal depends on several parameters including three mixing angles theta(12), theta(23), theta(13), a mass difference vertical bar Delta m(32)(2)vertical bar and a CP violating phase delta(CP). In this neutrino oscillation scenario, assuming vertical bar Delta m(32)(2)vertical bar = 2.4 x 10(-3) eV(2), sin theta(2)(23) = 0.5, and vertical bar Delta m(32)(2)vertical bar > 0 (vertical bar Delta m(32)(2)vertical bar < 0), a best- fit value of sin2 theta(2)(13) = 0.140(- 0.032)(+0.038) (0.170(-0.037)(+0.045)) is obtained at delta(CP) = 0. When combining the result with the current best knowledge of oscillation parameters including the world average value of theta(13) from reactor experiments, some values of delta(CP) are disfavored at the 90% C. L.
|
T2K Collaboration(Abe, K. et al), Cervera-Villanueva, A., Escudero, L., Gomez-Cadenas, J. J., Izmaylov, A., Monfregola, L., et al. (2014). Measurement of the intrinsic electron neutrino component in the T2K neutrino beam with the ND280 detector. Phys. Rev. D, 89(9), 092003–18pp.
Abstract: The T2K experiment has reported the first observation of the appearance of electron neutrinos in a muon neutrino beam. The main and irreducible background to the appearance signal comes from the presence in the neutrino beam of a small intrinsic component of electron neutrinos originating from muon and kaon decays. In T2K, this component is expected to represent 1.2% of the total neutrino flux. A measurement of this component using the near detector (ND280), located 280 m from the target, is presented. The charged current interactions of electron neutrinos are selected by combining the particle identification capabilities of both the time projection chambers and electromagnetic calorimeters of ND280. The measured ratio between the observed electron neutrino beam component and the prediction is 1.01 +/- 0.10 providing a direct confirmation of the neutrino fluxes and neutrino cross section modeling used for T2K neutrino oscillation analyses. Electron neutrinos coming from muons and kaons decay are also separately measured, resulting in a ratio with respect to the prediction of 0.68 +/- 0.30 and 1.10 +/- 0.14, respectively.
|
