|
|
ATLAS Collaboration(Aad, G. et al), Aikot, A., Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., et al. (2023). Combined Measurement of the Higgs Boson Mass from the H → γγ and H → ZZ* → 4l Decay Channels with the ATLAS Detector Using √s=7, 8, and 13 TeV pp Collision Data. Phys. Rev. Lett., 131(25), 251802–21pp.
Abstract: A measurement of the mass of the Higgs boson combining the H -> ZZ* -> 4l and H -> gamma gamma decay channels is presented. The result is based on 140 fb(-1) of proton-proton collision data collected by the ATLAS detector during LHC run 2 at a center-of-mass energy of 13 TeV combined with the run 1 ATLAS mass measurement, performed at center-of-mass energies of 7 and 8 TeV, yielding a Higgs boson mass of 125.11 +/- 0.09(stat) +/- 0.06(syst) = 125.11 +/- 0.11 GeV. This corresponds to a 0.09% precision achieved on this fundamental parameter of the Standard Model of particle physics.
|
|
|
|
Martinez-Reviriego, P., Esperante, D., Grudiev, A., Gimeno, B., Blanch, C., Gonzalez-Iglesias, D., et al. (2024). Dielectric assist accelerating structures for compact linear accelerators of low energy particles in hadrontherapy treatments. Front. Physics, 12, 1345237–12pp.
Abstract: Dielectric Assist Accelerating (DAA) structures based on ultralow-loss ceramic are being studied as an alternative to conventional disk-loaded copper cavities. This accelerating structure consists of dielectric disks with irises arranged periodically in metallic structures working under the TM02-pi mode. In this paper, the numerical design of an S-band DAA structure for low beta particles, such as protons or carbon ions used for Hadrontherapy treatments, is shown. Four dielectric materials with different permittivity and loss tangent are studied as well as different particle velocities. Through optimization, a design that concentrates most of the RF power in the vacuum space near the beam axis is obtained, leading to a significant reduction of power loss on the metallic walls. This allows to fabricate cavities with an extremely high quality factor, over 100,000, and shunt impedance over 300 M omega/m at room temperature. During the numerical study, the design optimization has been improved by adjusting some of the cell parameters in order to both increase the shunt impedance and reduce the peak electric field in certain locations of the cavity, which can lead to instabilities in its normal functioning.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Cardillo, F., Castillo Gimenez, V., et al. (2023). Search for single vector-like B quark production and decay via B → bH(b(b)over-bar) in pp collisions at √s=13 TeV with the ATLAS detector. J. High Energy Phys., 11(11), 168–52pp.
Abstract: A search is presented for single production of a vector-like B quark decaying into a Standard Model b-quark and a Standard Model Higgs boson, which decays into a b (b) over bar pair. The search is carried out in 139 fb(-1) of root s = 13 TeV proton-proton collision data collected by the ATLAS detector at the LHC between 2015 and 2018. No significant deviation from the Standard Model background prediction is observed, and mass-dependent exclusion limits at the 95% confidence level are set on the resonance production cross-section in several theoretical scenarios determined by the couplings c(W), c(Z) and c(H) between the B quark and the Standard Model W, Z and Higgs bosons, respectively. For a vector-like B occurring as an isospin singlet, the search excludes values of c(W) greater than 0.45 for a B resonance mass (m(B)) between 1.0 and 1.2 TeV. For 1.2 TeV < m(B)< 2.0 TeV, c(W) values larger than 0.50-0.65 are excluded. If the B occurs as part of a (B, Y) doublet, the smallest excluded c(Z) coupling values range between 0.3 and 0.5 across the investigated resonance mass range 1.0 TeV < m(B)< 2.0 TeV.
|
|
|
|
LHCb Collaboration(Aaij, R. et al), Jaimes Elles, S. J., Jashal, B. K., Martinez-Vidal, F., Oyanguren, A., Rebollo De Miguel, M., et al. (2024). Improved Measurement of CP Violation Parameters in B0s → J/ψ K+ K- Decays in the Vicinity of the φ(1020) Resonance. Phys. Rev. Lett., 132(5), 051802–12pp.
Abstract: The decay-time-dependent CP asymmetry in B0s -> J=psi(-> mu+mu-)K+K- decays is measured using proton-proton collision data, corresponding to an integrated luminosity of 6 fb-1, collected with the LHCb detector at a center-of-mass energy of 13 TeV. Using a sample of approximately 349 000 B0s signal decays with an invariant K+K- mass in the vicinity of the phi(1020) resonance, the CP-violating phase phi s is measured, along with the difference in decay widths of the light and heavy mass eigenstates of the B0s-B over bar 0s system, Delta Gamma s, and the difference of the average B0s and B0 meson decay widths, Gamma s – Gamma d. The values obtained are phi s = -0.039 +/- 0.022 +/- 0.006 rad, Delta Gamma s = 0.0845 +/- 0.0044 +/- 0.0024 ps-1, and -0.0015 +/- 0.0014 ps-1, where the first uncertainty is statistical and the second systematic. These are the most precise single measurements to date and are consistent with expectations based on the Standard Model and with the previous LHCb analyses of this decay. These results are combined with previous independent LHCb measurements. The phase phi s is also measured independently for each polarization state of the K+K- system and shows no evidence for polarization dependence.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Aikot, A., Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., et al. (2023). Measurement of the B0s → μμ effective lifetime with the ATLAS detector. J. High Energy Phys., 09(9), 199–32pp.
Abstract: This paper reports the first ATLAS measurement of the B-s(0) -> μμeffective lifetime. The measurement is based on the data collected in 2015-2016, amounting to 26.3 fb(-1) of 13TeV LHC proton-proton collisions. The proper decay-time distribution of 58 +/- 13 background-subtracted signal candidates is fit with simulated signal templates parameterised as a function of the B-s(0) effective lifetime, with statistical uncertainties extracted through a Neyman construction. The resulting effective measurement of the B-s(0) -> μμlifetime is 0.99(-0.07)(+0.42) (stat.) +/- 0.17 (syst.) ps and it is found to be consistent with the Standard Model.
|
|
