|
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., Cabrera Urban, S., et al. (2023). Evidence of off-shell Higgs boson production from ZZ leptonic decay channels and constraints on its total width with the ATLAS detector. Phys. Lett. B, 846, 138223–29pp.
Abstract: This Letter reports on a search for off-shell production of the Higgs boson using 139 fb(-1) of pp collision data at root s = 13 TeV collected by the ATLAS detector at the Large Hadron Collider. The signature is a pair of Z bosons, with contributions from both the production and subsequent decay of a virtual Higgs boson and the interference of that process with other processes. The two observable final states are ZZ -> 4l and Z Z -> 2l2 nu with l = e or mu. In the ZZ -> 4l final state, a dense Neural Network is used to enhance analysis sensitivity with respect to matrix element-based discrimination. The background-only hypothesis is rejected with an observed (expected) significance of 3.3 (2.2) standard deviations, representing experimental evidence for off-shell Higgs boson production. Assuming that no new particles enter the production of the virtual Higgs boson, its total width can be deduced from the measurement of its off-shell production cross-section. The measured total width of the Higgs boson is 4.5(-2.5)(+3.3) MeV, and the observed (expected) upper limit on the total width is found to be 10.5 (10.9) MeV at 95% confidence level.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., Cabrera Urban, S., et al. (2023). Measurement of the Sensitivity of Two-Particle Correlations in pp Collisions to the Presence of Hard Scatterings. Phys. Rev. Lett., 131(16), 162301–21pp.
Abstract: A key open question in the study of multiparticle production in high-energy pp collisions is the relationship between the “ridge”-i.e., the observed azimuthal correlations between particles in the underlying event that extend over all rapidities-and hard or semihard scattering processes. In particular, it is not known whether jets or their soft fragments are correlated with particles in the underlying event. To address this question, two-particle correlations are measured in pp collisions at collected by the ATLAS experiment at the LHC, with an integrated luminosity of 15.8 pb-1, in two different configurations. In the first case, charged particles associated with jets are excluded from the correlation analysis, while in the second case, correlations are measured between particles within jets and charged particles from the underlying event. Second-order flow coefficients, v2, are presented as a function of event multiplicity and transverse momentum. These measurements show that excluding particles associated with jets does not affect the measured correlations. Moreover, particles associated with jets do not exhibit any significant azimuthal correlations with the underlying event, ruling out hard processes contributing to the ridge. p= 13 TeV using data ffiffi s
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., Cabrera Urban, S., et al. (2023). New techniques for jet calibration with the ATLAS detector. Eur. Phys. J. C, 83(8), 761–41pp.
Abstract: A determination of the jet energy scale is presented using proton-proton collision data with a centre-of-mass energy of root s = 13 TeV, corresponding to an integrated luminosity of 140 fb(-1) collected using the ATLAS detector at the LHC. Jets are reconstructed using the ATLAS particle-flow method that combines charged-particle tracks and topo-clusters formed from energy deposits in the calorimeter cells. The anti-kt jet algorithm with radius parameter R = 0.4 is used to define the jet. Novel jet energy scale calibration strategies developed for the LHC Run 2 are reported that lay the foundation for the jet calibration in Run 3. Jets are calibrated with a series of simulation-based corrections, including state-of-the-art techniques in jet calibration such as machine learning methods and novel in situ calibrations to achieve better performance than the baseline calibration derived using up to 81 fb(-1) of Run 2 data. The performance of these new techniques is then examined in the in situ measurements by exploiting the transverse momentum balance between a jet and a reference object. The b-quark jet energy scale using particle flow jets is measured for the first time with around 1% precision using gamma+jet events.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., Cabrera Urban, S., et al. (2023). Inclusive and differential cross-sections for dilepton ttbar production measured in √s=13 TeV pp collisions with the ATLAS detector. J. High Energy Phys., 07(7), 141–78pp.
Abstract: Differential and double-differential distributions of kinematic variables of leptons from decays of top-quark pairs (t (t) over bar) are measured using the full LHC Run 2 data sample collected with the ATLAS detector. The data were collected at a pp collision energy of root s = 13TeV and correspond to an integrated luminosity of 140 fb(-1). The measurements use events containing an oppositely charged e μpair and b-tagged jets. The results are compared with predictions from several Monte Carlo generators. While no prediction is found to be consistent with all distributions, a better agreement with measurements of the lepton p(T) distributions is obtained by reweighting the t (t) over bar sample so as to reproduce the top-quark p(T) distribution from an NNLO calculation. The inclusive top-quark pair production cross-section is measured as well, both in a fiducial region and in the full phase-space. The total inclusive cross-section is found to be sigma(t (t) over bar) = 829 +/- 1 (stat) +/- 13 (syst) +/- 8 (lumi) +/- 2 (beam) pb, where the uncertainties are due to statistics, systematic effects, the integrated luminosity and the beam energy. This is in excellent agreement with the theoretical expectation.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., Cabrera Urban, S., et al. (2023). Observation of four-top-quark production in the multilepton final state with the ATLAS detector. Eur. Phys. J. C, 83(6), 496–35pp.
Abstract: This paper presents the observation of four-topquark (t (t) over bart (t) over bar) production in proton-proton collisions at the LHC. The analysis is performed using an integrated luminosity of 140 fb-1 at a centre-of-mass energy of 13 TeVcollected using the ATLAS detector. Events containing two leptons with the same electric charge or at least three leptons (electrons or muons) are selected. Event kinematics are used to separate signal from background through a multivariate discriminant, and dedicated control regions are used to constrain the dominant backgrounds. The observed (expected) significance of themeasured t (t) over bart (t) over bar signal with respect to the standard model (SM) background-only hypothesis is 6.1 (4.3) standard deviations. The t (t) over bart (t) over bar production cross section is measured to be 22.5(-5.5)(+6.6), consistent with the SM prediction of 12.0 +/- 2.4 fb within 1.8 standard deviations. Data are also used to set limits on the three-top-quark production cross section, being an irreducible background not measured previously, and to constrain the top-Higgs Yukawa coupling and effective field theory operator coefficients that affect t (t) over bart (t) over bar production.
|
|
