|
|
Fonseca, R. M., & Hirsch, M. (2015). SU(5)-inspired double beta decay. Phys. Rev. D, 92(1), 015014–14pp.
Abstract: The short-range part of the neutrinoless double beta amplitude is generated via the exchange of exotic particles, such as charged scalars, leptoquarks and/or diquarks. In order to give a sizable contribution to the total decay rate, the masses of these exotics should be of the order of (at most) a few TeV. Here, we argue that these exotics could be the “light” (i.e., weak-scale) remnants of some B – L violating variants of SU(5). We show that unification of the standard model gauge couplings, consistent with proton decay limits, can be achieved in such a setup without the need to introduce supersymmetry. Since these nonminimal SU(5)-inspired models violate B – L, they generate Majorana neutrino masses and therefore make it possible to explain neutrino oscillation data. The light colored particles of these models can potentially be observed at the LHC, and it might be possible to probe the origin of the neutrino masses with Delta L = 2 violating signals. As particular realizations of this idea, we present two models, one for each of the two possible tree-level topologies of neutrinoless double beta decay.
|
|
|
|
Hirsch, M., Reichert, L., & Porod, W. (2011). Supersymmetric mass spectra and the seesaw scale. J. High Energy Phys., 05(5), 086–32pp.
Abstract: Supersymmetric mass spectra within two variants of the seesaw mechanism, commonly known as type-II and type-III seesaw, are calculated using full 2-loop RGEs and minimal Supergravity boundary conditions. The type-II seesaw is realized using one pair of 15 and (15) over bar superfields, while the type-III is realized using three copies of 24(M) superfields. Using published, estimated errors on SUSY mass observables attainable at the LHC and in a combined LHC+ILC analysis, we calculate expected errors for the parameters of the models, most notably the seesaw scale. If SUSY particles are within the reach of the ILC, pure mSugra can be distinguished from mSugra plus type-II or type-III seesaw for nearly all relevant values of the seesaw scale. Even in the case when only the much less accurate LHC measurements are used, we find that indications for the seesaw can be found in favourable parts of the parameter space. Since our conclusions crucially depend on the reliability of the theoretically forecasted error bars, we discuss in some detail the accuracies which need to be achieved for the most important LHC and ILC observables before an analysis, such as the one presented here, can find any hints for type-II or type-III seesaw in SUSY spectra.
|
|
|
|
Arbelaez, C., Hirsch, M., & Reichert, L. (2012). Supersymmetric mass spectra and the seesaw type-I scale. J. High Energy Phys., 02(2), 112.
Abstract: We calculate supersymmetric mass spectra with cMSSM boundary conditions and a type-I seesaw mechanism added to explain current neutrino data. Using published, estimated errors on SUSY mass observables for a combined LHC+ILC analysis, we perform a theoretical chi(2) analysis to identify parameter regions where pure cMSSM and cMSSM plus seesaw type-I might be distinguishable with LHC+ILC data. The most important observables are determined to be the (left) smuon and selectron masses and the splitting between them, respectively. Splitting in the (left) smuon and selectrons is tiny in most of cMSSM parameter space, but can be quite sizeable for large values of the seesaw scale, m S S. Thus, for very roughly m(SS) >= 10(14) GeV hints for type-I seesaw might appear in SUSY mass measurements. Since our numerical results depend sensitively on forecasted error bars, we discuss in some detail the accuracies, which need to be achieved, before a realistic analysis searching for signs of type-I seesaw in SUSY spectra can be carried out.
|
|
|
|
Arbelaez, C., Fonseca, R. M., Romao, J. C., & Hirsch, M. (2013). Supersymmetric SO(10)-inspired GUTs with sliding scales. Phys. Rev. D, 87(7), 075010–19pp.
Abstract: We construct lists of supersymmetric models with extended gauge groups at intermediate steps, all of which are inspired by SO(10) unification. We consider three different kinds of setups: (i) the model has exactly one additional intermediate scale with a left-right (LR) symmetric group; (ii) SO(10) is broken to the LR group via an intermediate Pati-Salam scale; and (iii) the LR group is broken into SU(3)(c) X SU(2)(L) X U(1)(R) X U(1)(B-L), before breaking to the standard model (SM) group. We use sets of conditions, which we call the “sliding mechanism,” which yield unification with the extended gauge group(s) allowed at arbitrary intermediate energy scales. All models thus can have new gauge bosons within the reach of the LHC, in principle. We apply additional conditions, such as perturbative unification, renormalizability and anomaly cancellation and find that, despite these requirements, for the ansatz (i) with only one additional scale still around 50 different variants exist that can have a LR symmetry below 10 TeV. For the more complicated schemes (ii) and (iii) literally thousands of possible variants exist, and for scheme (ii) we have also found variants with very low Pati-Salam scales. We also discuss possible experimental tests of the models from measurements of supersymmetry masses. Assuming mSugra boundary conditions we calculate certain combinations of soft terms, called “invariants,” for the different classes of models. Values for all the invariants can be classified into a small number of sets, which contain information about the class of models and, in principle, the scale of beyond-minimal supersymmetric extension of the Standard Model physics, even in case the extended gauge group is broken at an energy beyond the reach of the LHC.
|
|
|
|
Esteves, J. N., Romao, J. C., Hirsch, M., Staub, F., & Porod, W. (2011). Supersymmetric type-III seesaw mechanism: Lepton flavor violating decays and dark matter. Phys. Rev. D, 83(1), 013003–21pp.
Abstract: We study a supersymmetric version of the seesaw mechanism type III. The model consists of the minimal supersymmetric extension of the standard model particle content plus three copies of 24 superfields. The fermionic part of the SU(2) triplet contained in the 24 is responsible for the type-III seesaw, which is used to explain the observed neutrino masses and mixings. Complete copies of 24 are introduced to maintain gauge coupling unification. These additional states change the beta functions of the gauge couplings above the seesaw scale. Using minimal Supergravity boundary conditions, we calculate the resulting supersymmetric mass spectra at the electroweak scale using full 2-loop renormalization group equations. We show that the resulting spectrum can be quite different compared to the usual minimal Supergravity spectrum. We discuss how this might be used to obtain information on the seesaw scale from mass measurements. Constraints on the model space due to limits on lepton flavour violating decays are discussed. The main constraints come from the bounds on μ-> e gamma but there are also regions where the decay tau -> μgamma gives stronger constraints. We also calculate the regions allowed by the dark matter constraint. For the sake of completeness, we compare our results with those for the supersymmetric seesaw type II and, to some extent, with type I.
|
|
