|
BABAR Collaboration(Lees, J. P. et al), Martinez-Vidal, F., & Oyanguren, A. (2011). Study of Y(3S, 2S) -> eta Y(1S) and Y(3S, 2S) -> pi(+) pi(-) Y(1S) hadronic transitions. Phys. Rev. D, 84(9), 092003–8pp.
Abstract: We study the Y(3S, 2S) -> eta Y(1S) and Y (3S,2S) -> pi(+)pi(-) transitions with 122 x 10(6) x Y(3S) and 100 x 10(6) Y (2S) mesons collected by the BABAR detector at the PEP-II asymmetric-energy e(+)e(-) collider. We measure B[Y(2S) -> eta Y(1S)] = (2.39 +/- 0.31 (stat) +/- 0.14(syst)) x 10(-4) and Gamma[Y(2S) -> eta Y(1S)]/Gamma[Y(2S) ->pi(+)pi(-)(1S)] – (2.39 +/- 0.31(stat) +/- 0.14(syst)) x 10(-3). We find no evidence for Y(3S) -> eta Y (1S) and obtain B[Y(3S) -> eta Y(1S)] < 1.0 x 10(-4) and Gamma[Y (3S) -> eta Y(1S)/Gamma[Y(3S) -> pi(+)pi(-) Y(1S)] < 2.3 x 10(-3) as upper limits at the 90% confidence level. We also provide improved measurements of the Y(S) – Y(1S) and Y(3S) – Y (1S) mass differences, 562.170 +/- 0.007(stat) +/- 0.088(syst). MeV/c(2) and 893.813 +/- 0: 015(stat) +/- 0.107(syst.) MeV/c(2), respectively.
|
|
|
Hirsch, M., Reichert, L., & Porod, W. (2011). Supersymmetric mass spectra and the seesaw scale. J. High Energy Phys., 05(5), 086–32pp.
Abstract: Supersymmetric mass spectra within two variants of the seesaw mechanism, commonly known as type-II and type-III seesaw, are calculated using full 2-loop RGEs and minimal Supergravity boundary conditions. The type-II seesaw is realized using one pair of 15 and (15) over bar superfields, while the type-III is realized using three copies of 24(M) superfields. Using published, estimated errors on SUSY mass observables attainable at the LHC and in a combined LHC+ILC analysis, we calculate expected errors for the parameters of the models, most notably the seesaw scale. If SUSY particles are within the reach of the ILC, pure mSugra can be distinguished from mSugra plus type-II or type-III seesaw for nearly all relevant values of the seesaw scale. Even in the case when only the much less accurate LHC measurements are used, we find that indications for the seesaw can be found in favourable parts of the parameter space. Since our conclusions crucially depend on the reliability of the theoretically forecasted error bars, we discuss in some detail the accuracies which need to be achieved for the most important LHC and ILC observables before an analysis, such as the one presented here, can find any hints for type-II or type-III seesaw in SUSY spectra.
|
|
|
Esteves, J. N., Romao, J. C., Hirsch, M., Staub, F., & Porod, W. (2011). Supersymmetric type-III seesaw mechanism: Lepton flavor violating decays and dark matter. Phys. Rev. D, 83(1), 013003–21pp.
Abstract: We study a supersymmetric version of the seesaw mechanism type III. The model consists of the minimal supersymmetric extension of the standard model particle content plus three copies of 24 superfields. The fermionic part of the SU(2) triplet contained in the 24 is responsible for the type-III seesaw, which is used to explain the observed neutrino masses and mixings. Complete copies of 24 are introduced to maintain gauge coupling unification. These additional states change the beta functions of the gauge couplings above the seesaw scale. Using minimal Supergravity boundary conditions, we calculate the resulting supersymmetric mass spectra at the electroweak scale using full 2-loop renormalization group equations. We show that the resulting spectrum can be quite different compared to the usual minimal Supergravity spectrum. We discuss how this might be used to obtain information on the seesaw scale from mass measurements. Constraints on the model space due to limits on lepton flavour violating decays are discussed. The main constraints come from the bounds on μ-> e gamma but there are also regions where the decay tau -> μgamma gives stronger constraints. We also calculate the regions allowed by the dark matter constraint. For the sake of completeness, we compare our results with those for the supersymmetric seesaw type II and, to some extent, with type I.
|
|
|
Bustamante, M., Gago, A. M., & Jones Perez, J. (2011). SUSY renormalization group effects in ultra high energy neutrinos. J. High Energy Phys., 05(5), 133–26pp.
Abstract: We have explored the question of whether the renormalization group running of the neutrino mixing parameters in the Minimal Supersymmetric Standard Model is detectable with ultra-high energy neutrinos from active galactic nuclei (AGN). We use as observables the ratios of neutrino fluxes produced at the AGN, focusing on four different neutrino production models: (Phi(0)(v epsilon+(v) over bar epsilon) : Phi(0)(v mu+(v) over bar mu) : Phi(0)(v tau+(v) over bar tau)) = (1 : 2 : 0), (0 : 1 : 0), (1 : 0 : 0), and (1 : 1 : 0). The prospects for observing deviations experimentally are taken into consideration, and we find out that it is necessary to impose a cut-off on the transferred momentum of Q(2) >= 10(7) GeV(2). However, this condition, together with the expected low value of the diffuse AGN neutrino flux, yields a negligible event rate at a km-scale. Cerenkov detector such as IceCube.
|
|
|
Rodejohann, W., & Valle, J. W. F. (2011). Symmetrical parametrizations of the lepton mixing matrix. Phys. Rev. D, 84(7), 073011–6pp.
Abstract: Advantages of the original symmetrical form of the parametrization of the lepton mixing matrix are discussed. It provides a conceptually more transparent description of neutrino oscillations and lepton number violating processes like neutrinoless double beta decay, clarifying the significance of Dirac and Majorana phases. It is also ideal for parametrizing scenarios with light sterile neutrinos.
|
|