|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Cabrera Urban, S., Castillo Gimenez, V., Cerda Alberich, L., Costa, M. J., et al. (2016). Measurement of the production cross-section of a single top quark in association with a W boson at 8 TeV with the ATLAS experiment. J. High Energy Phys., 01(1), 064–48pp.
Abstract: The cross-section for the production of a single top quark in association with a W boson in proton-proton collisions at is measured. The dataset corresponds to an integrated luminosity of 20.3 fb(-1), collected by the ATLAS detector in 2012 at the Large Hadron Collider at CERN. Events containing two leptons and one central b-jet are selected. The W t signal is separated from the backgrounds using boosted decision trees, each of which combines a number of discriminating variables into one classifier. Production of W t events is observed with a significance of 7.7 sigma. The cross-section is extracted in a profile likelihood fit to the classifier output distributions. The W t cross-section, inclusive of decay modes, is measured to be 23.0 +/- 1.3(stat.) (-aEuro parts per thousand 3.5) (+ 3.2) (syst.)+/- 1.1(lumi.) pb. The measured cross-section is used to extract a value for the CKM matrix element |V (tb) | of 1.01 +/- 0.10 and a lower limit of 0.80 at the 95% confidence level. The cross-section for the production of a top quark and a W boson is also measured in a fiducial acceptance requiring two leptons with p (T) > 25 GeV and |eta| < 2.5, one jet with p (T) > 20 GeV and |eta| < 2.5, and E (T) (miss) > 20 GeV, including both W t and top-quark pair events as signal. The measured value of the fiducial cross-section is 0.85 +/- A 0.01(stat.) (-aEuro parts per thousand 0.07) (+ 0.07) (syst.)+/- 0.03(lumi.) pb.
|
|
|
ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Barranco Navarro, L., Cabrera Urban, S., Castillo Gimenez, V., Cerda Alberich, L., et al. (2016). Measurement of the photon identification efficiencies with the ATLAS detector using LHC Run-1 data. Eur. Phys. J. C, 76(12), 666–42pp.
Abstract: The algorithms used by the ATLAS Collaboration to reconstruct and identify prompt photons are described. Measurements of the photon identification efficiencies are reported, using 4.9 fb(-1) of pp collision data collected at the LHC at root s = 7 TeV and 20.3 fb-1 at root s = 8 TeV. The efficiencies are measured separately for converted and unconverted photons, in four different pseudorapidity regions, for transverse momenta between 10 GeV and 1.5 TeV. The results from the combination of three data-driven techniques are compared to the predictions from a simulation of the detector response, after correcting the electromagnetic shower momenta in the simulation for the average differences observed with respect to data. Data-to-simulation efficiency ratios used as correction factors in physics measurements are determined to account for the small residual efficiency differences. These factors are measured with uncertainties between 0.5% and 10% in 7 TeV data and between 0.5% and 5.6% in 8 TeV data, depending on the photon transverse momentum and pseudorapidity.
|
|
|
BABAR Collaboration(Lees, J. P. et al), Martinez-Vidal, F., & Oyanguren, A. (2016). Measurement of the neutral D meson mixing parameters in a time-dependent amplitude analysis of the D-0 -> pi(+)pi(-)pi(0) decay. Phys. Rev. D, 93(11), 112014–10pp.
Abstract: We perform the first measurement on the D-0 – (D) over bar (0) mixing parameters using a time-dependent amplitude analysis of the decay D-0 -> pi(+)pi(-)pi(0). The data were recorded with the BABAR detector at center-of-mass energies at and near the Upsilon(4S) resonance, and correspond to an integrated luminosity of approximately 468.1 fb(-1). The neutral D meson candidates are selected from D*(2010)(+) -> D-0 pi(+)(s) decays where the flavor at the production is identified by the charge of the low-momentum pion, pi(+)(s). The measured mixing parameters are x = (1.5 +/- 1.2 +/- 0.6)% and y = (0.2 +/- 0.9 +/- 0.5)%, where the quoted uncertainties are statistical and systematic, respectively.
|
|
|
T2K Collaboration(Abe, K. et al), Cervera-Villanueva, A., Izmaylov, A., Sorel, M., & Stamoulis, P. (2016). Measurement of the muon neutrino inclusive charged-current cross section in the energy range of 1-3 GeV with the T2K INGRID detector. Phys. Rev. D, 93(7), 072002–23pp.
Abstract: We report a measurement of the nu(mu)-nucleus inclusive charged-current cross section (= sigma(cc)) on iron using data from the INGRID detector exposed to the J-PARC neutrino beam. The detector consists of 14 modules in total, which are spread over a range of off-axis angles from 0 degrees to 1.1 degrees. The variation in the neutrino energy spectrum as a function of the off-axis angle, combined with event topology information, is used to calculate this cross section as a function of neutrino energy. The cross section is measured to be sigma(cc) (1.1 GeV) = 1.10 +/- 0.15 (10(-38) cm(2)/nucleon), sigma(cc) (2.0 GeV) = 2.07 +/- 0.27 (10(-38) cm(2)/nucleon), and sigma(cc) (3.3 GeV) = 2.29 +/- 0.45 (10(-38) cm(2)/nucleon), at energies of 1.1, 2.0, and 3.3 GeV, respectively. These results are consistent with the cross section calculated by the neutrino interaction generators currently used by T2K. More importantly, the method described here opens up a new way to determine the energy dependence of neutrino-nucleus cross sections.
|
|
|
LHCb Collaboration(Aaij, R. et al), Martinez-Vidal, F., Oyanguren, A., Ruiz Valls, P., & Sanchez Mayordomo, C. (2016). Measurement of the mass and lifetime of the Omega(-)(b) baryon. Phys. Rev. D, 93(9), 092007–12pp.
Abstract: A proton-proton collision data sample, corresponding to an integrated luminosity of 3 fb(-1) collected by LHCb at root s = 7 and 8 TeV, is used to reconstruct 63 +/- 9 Omega(-)(b) -> Omega(0)(c)pi(-), Omega(0)(c) -> pK(-)K(-)pi(+) decays. Using the Xi(-)(b) ->Xi(0)(c)pi(-), Xi(0)(c) -> pK(-)K(-)pi(+) decay mode for calibration, the lifetime ratio and the absolute lifetime of the Omega(-)(b) baryon are measured to be tau(Omega b-)/tau(Xi b-) = 1.11 +/- 0.16 +/- 0.03, tau(Omega b-) = 1.78 +/- 0.26 +/- 0.05 +/- 0.06 ps, where the uncertainties are statistical, systematic and from the calibration mode (for tau(Omega b-) only). A measurement is also made of the mass difference, m(Omega b-) – m(Xi b-), and the corresponding Omega(-)(b) mass, which yields m(Omega b-) – m(Xi b-) = 247.4 +/- 3.2 +/- 0.5 MeV/c(2), m(Omega b-) = 6045.1 +/- 3.2 +/- 0.5 +/- 0.6 MeV/c(2). These results are consistent with previous measurements.
|
|