ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Barranco Navarro, L., Cabrera Urban, S., Castillo Gimenez, V., Cerda Alberich, L., et al. (2016). Measurement of the Inelastic Proton-Proton Cross Section at root s=13 TeV with the ATLAS Detector at the LHC. Phys. Rev. Lett., 117(18), 182002–19pp.
Abstract: This Letter presents a measurement of the inelastic proton-proton cross section using 60 μb(-1) of pp collisions at a center-of-mass energy root s of 13 TeV with the ATLAS detector at the LHC. Inelastic interactions are selected using rings of plastic scintillators in the forward region (2.07 <vertical bar eta vertical bar < 3.86) of the detector. A cross section of 68.1 +/- 1.4 mb is measured in the fiducial region. xi = M-X(2) > s > 10(-6), where M-X is the larger invariant mass of the two hadronic systems separated by the largest rapidity gap in the event. In this xi range the scintillators are highly efficient. For diffractive events this corresponds to cases where at least one proton dissociates to a system with M-X > 13 GeV. The measured cross section is compared with a range of theoretical predictions. When extrapolated to the full phase space, a cross section of 78.1 +/- 2.9 mb is measured, consistent with the inelastic cross section increasing with center-of-mass energy.
|
LHCb Collaboration(Aaij, R. et al), Martinez-Vidal, F., Oyanguren, A., Ruiz Valls, P., & Sanchez Mayordomo, C. (2016). Measurement of the mass and lifetime of the Omega(-)(b) baryon. Phys. Rev. D, 93(9), 092007–12pp.
Abstract: A proton-proton collision data sample, corresponding to an integrated luminosity of 3 fb(-1) collected by LHCb at root s = 7 and 8 TeV, is used to reconstruct 63 +/- 9 Omega(-)(b) -> Omega(0)(c)pi(-), Omega(0)(c) -> pK(-)K(-)pi(+) decays. Using the Xi(-)(b) ->Xi(0)(c)pi(-), Xi(0)(c) -> pK(-)K(-)pi(+) decay mode for calibration, the lifetime ratio and the absolute lifetime of the Omega(-)(b) baryon are measured to be tau(Omega b-)/tau(Xi b-) = 1.11 +/- 0.16 +/- 0.03, tau(Omega b-) = 1.78 +/- 0.26 +/- 0.05 +/- 0.06 ps, where the uncertainties are statistical, systematic and from the calibration mode (for tau(Omega b-) only). A measurement is also made of the mass difference, m(Omega b-) – m(Xi b-), and the corresponding Omega(-)(b) mass, which yields m(Omega b-) – m(Xi b-) = 247.4 +/- 3.2 +/- 0.5 MeV/c(2), m(Omega b-) = 6045.1 +/- 3.2 +/- 0.5 +/- 0.6 MeV/c(2). These results are consistent with previous measurements.
|
T2K Collaboration(Abe, K. et al), Cervera-Villanueva, A., Izmaylov, A., Sorel, M., & Stamoulis, P. (2016). Measurement of the muon neutrino inclusive charged-current cross section in the energy range of 1-3 GeV with the T2K INGRID detector. Phys. Rev. D, 93(7), 072002–23pp.
Abstract: We report a measurement of the nu(mu)-nucleus inclusive charged-current cross section (= sigma(cc)) on iron using data from the INGRID detector exposed to the J-PARC neutrino beam. The detector consists of 14 modules in total, which are spread over a range of off-axis angles from 0 degrees to 1.1 degrees. The variation in the neutrino energy spectrum as a function of the off-axis angle, combined with event topology information, is used to calculate this cross section as a function of neutrino energy. The cross section is measured to be sigma(cc) (1.1 GeV) = 1.10 +/- 0.15 (10(-38) cm(2)/nucleon), sigma(cc) (2.0 GeV) = 2.07 +/- 0.27 (10(-38) cm(2)/nucleon), and sigma(cc) (3.3 GeV) = 2.29 +/- 0.45 (10(-38) cm(2)/nucleon), at energies of 1.1, 2.0, and 3.3 GeV, respectively. These results are consistent with the cross section calculated by the neutrino interaction generators currently used by T2K. More importantly, the method described here opens up a new way to determine the energy dependence of neutrino-nucleus cross sections.
|
BABAR Collaboration(Lees, J. P. et al), Martinez-Vidal, F., & Oyanguren, A. (2016). Measurement of the neutral D meson mixing parameters in a time-dependent amplitude analysis of the D-0 -> pi(+)pi(-)pi(0) decay. Phys. Rev. D, 93(11), 112014–10pp.
Abstract: We perform the first measurement on the D-0 – (D) over bar (0) mixing parameters using a time-dependent amplitude analysis of the decay D-0 -> pi(+)pi(-)pi(0). The data were recorded with the BABAR detector at center-of-mass energies at and near the Upsilon(4S) resonance, and correspond to an integrated luminosity of approximately 468.1 fb(-1). The neutral D meson candidates are selected from D*(2010)(+) -> D-0 pi(+)(s) decays where the flavor at the production is identified by the charge of the low-momentum pion, pi(+)(s). The measured mixing parameters are x = (1.5 +/- 1.2 +/- 0.6)% and y = (0.2 +/- 0.9 +/- 0.5)%, where the quoted uncertainties are statistical and systematic, respectively.
|
ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Barranco Navarro, L., Cabrera Urban, S., Castillo Gimenez, V., Cerda Alberich, L., et al. (2016). Measurement of the photon identification efficiencies with the ATLAS detector using LHC Run-1 data. Eur. Phys. J. C, 76(12), 666–42pp.
Abstract: The algorithms used by the ATLAS Collaboration to reconstruct and identify prompt photons are described. Measurements of the photon identification efficiencies are reported, using 4.9 fb(-1) of pp collision data collected at the LHC at root s = 7 TeV and 20.3 fb-1 at root s = 8 TeV. The efficiencies are measured separately for converted and unconverted photons, in four different pseudorapidity regions, for transverse momenta between 10 GeV and 1.5 TeV. The results from the combination of three data-driven techniques are compared to the predictions from a simulation of the detector response, after correcting the electromagnetic shower momenta in the simulation for the average differences observed with respect to data. Data-to-simulation efficiency ratios used as correction factors in physics measurements are determined to account for the small residual efficiency differences. These factors are measured with uncertainties between 0.5% and 10% in 7 TeV data and between 0.5% and 5.6% in 8 TeV data, depending on the photon transverse momentum and pseudorapidity.
|
