ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., Cabrera Urban, S., et al. (2023). Integrated and differential fiducial cross-section measurements for the vector boson fusion production of the Higgs boson in the H → WW* → eνμν decay channel at 13 TeV with the ATLAS detector. Phys. Rev. D, 108(7), 072003–52pp.
Abstract: The vector-boson production cross section for the Higgs boson decay in the H -> WW* -> e nu μnu channel is measured as a function of kinematic observables sensitive to the Higgs boson production and decay properties as well as integrated in a fiducial phase space. The analysis is performed using the proton-proton collision data collected by the ATLAS detector in Run 2 of the LHC at root s = 13 TeV center-of-mass energy, corresponding to an integrated luminosity of 139 fb(-1). The different flavor final state is studied by selecting an electron and a muon originating from a pair of W bosons and compatible with the Higgs boson decay. The data are corrected for the effects of detector inefficiency and resolution, and the measurements are compared with different state-of-the-art theoretical predictions. The differential cross sections are used to constrain anomalous interactions described by dimension-six operators in an effective field theory.
|
Andricek, L., Boronat, M., Fuster, J., Garcia, I., Gomis, P., Marinas, C., et al. (2016). Integrated cooling channels in position-sensitive silicon detectors. J. Instrum., 11, P06018–15pp.
Abstract: We present an approach to construct position-sensitive silicon detectors with an integrated cooling circuit. Tests on samples demonstrate that a very modest liquid flow very effectively cool the devices up to a power dissipation of over 10 W/cm(2). The liquid flow is found to have a negligible impact on the mechanical stability. A finite-element simulation predicts the cooling performance to an accuracy of approximately 10%.
|
Andricek, L. et al, Lacasta, C., Marinas, C., & Vos, M. (2011). Intrinsic resolutions of DEPFET detector prototypes measured at beam tests. Nucl. Instrum. Methods Phys. Res. A, 638(1), 24–32.
Abstract: The paper is based on the data of the 2009 DEPFET beam test at CERN SPS. The beam test used beams of pions and electrons with energies between 40 and 120 GeV, and the sensors tested were prototypes with thickness of 450 μm and pixel pitch between 20 and 32 μm. Intrinsic resolutions of the detectors are calculated by disentangling the contributions of measurement errors and multiple scattering in tracking residuals. Properties of the intrinsic resolution estimates and factors that influence them are discussed. For the DEPFET detectors in the beam test, the calculation yields intrinsic resolutions of approximate to 1 μm, with a typical accuracy of 0.1 μm. Bias scan, angle scan, and energy scan are used as example studies to show that the intrinsic resolutions are a useful tool in studies of detector properties. With sufficiently precise telescopes, detailed resolution maps can be constructed and used to study and optimize detector performance.
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2015). Jet energy measurement and its systematic uncertainty in proton-proton collisions at root s=7 TeV with the ATLAS detector. Eur. Phys. J. C, 75(1), 17–101pp.
Abstract: The jet energy scale (JES) and its systematic uncertainty are determined for jetsmeasured with the ATLAS detector using proton-proton collision data with a centre-of-mass energy of root s = 7 TeV corresponding to an integrated luminosity of 4.7 fb(-1). Jets are reconstructed from energy deposits forming topological clusters of calorimeter cells using the anti-kt algorithmwith distance parameters R = 0.4 or R = 0.6, and are calibrated using MC simulations. A residual JES correction is applied to account for differences between data and MC simulations. This correction and its systematic uncertainty are estimated using a combination of in situ techniques exploiting the transverse momentum balance between a jet and a reference object such as a photon or a Z boson, for 20 <= p(T)(jet) < 1000 GeV and pseudorapidities vertical bar eta vertical bar < 4.5. The effect of multiple proton-proton interactions is corrected for, and an uncertainty is evaluated using in situ techniques. The smallest JES uncertainty of less than 1% is found in the central calorimeter region (vertical bar eta vertical bar| < 1.2) for jets with 55 = p(T)(jet) < 500 GeV. For central jets at lower p(T), the uncertainty is about 3%. A consistent JES estimate is found using measurements of the calorimeter response of single hadrons in proton-proton collisions and test-beam data, which also provide the estimate for p(T)(jet) > 1 TeV. The calibration of forward jets is derived from dijet p(T) balance measurements. The resulting uncertainty reaches its largest value of 6% for low-p(T) jets at vertical bar eta vertical bar| = 4.5. Additional JES uncertainties due to specific event topologies, such as close-by jets or selections of event samples with an enhanced content of jets originating from light quarks or gluons, are also discussed. The magnitude of these uncertainties depends on the event sample used in a given physics analysis, but typically amounts to 0.5-3%.
|
ATLAS Collaboration(Aad, G. et al), Amoros, G., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Ferrer, A., et al. (2013). Jet energy measurement with the ATLAS detector in proton-proton collisions at root s=7 TeV. Eur. Phys. J. C, 73(3), 2304–118pp.
Abstract: The jet energy scale and its systematic uncertainty are determined for jets measured with the ATLAS detector at the LHC in proton-proton collision data at a centre-of-mass energy of root s = 7 TeV corresponding to an integrated luminosity of 38 pb(-1). Jets are reconstructed with the anti-k(t) algorithm with distance parameters R = 0.4 or R = 0.6. Jet energy and angle corrections are determined from Monte Carlo simulations to calibrate jets with transverse momenta pT >= 20 GeV and pseudorapidities vertical bar eta vertical bar < 4.5. The jet energy systematic uncertainty is estimated using the single isolated hadron response measured in situ and in test-beams, exploiting the transverse momentum balance between central and forward jets in events with dijet topologies and studying systematic variations in Monte Carlo simulations. The jet energy uncertainty is less than 2.5 % in the central calorimeter region (vertical bar eta vertical bar < 0.8) for jets with 60 <= p(T) < 800 GeV, and is maximally 14 % for p(T) < 30 GeV in the most forward region 3.2 <= vertical bar eta vertical bar < 4.5. The jet energy is validated for jet transverse momenta up to 1 TeV to the level of a few percent using several in situ techniques by comparing a well-known reference such as the recoiling photon p(T), the sum of the transverse momenta of tracks associated to the jet, or a system of low-p(T) jets recoiling against a high-p(T) jet. More sophisticated jet calibration schemes are presented based on calorimeter cell energy density weighting or hadronic properties of jets, aiming for an improved jet energy resolution and a reduced flavour dependence of the jet response. The systematic uncertainty of the jet energy determined from a combination of in situ techniques is consistent with the one derived from single hadron response measurements over a wide kinematic range. The nominal corrections and uncertainties are derived for isolated jets in an inclusive sample of high-p(T) jets. Special cases such as event topologies with close-by jets, or selections of samples with an enhanced content of jets originating from light quarks, heavy quarks or gluons are also discussed and the corresponding uncertainties are determined.
|
