ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Aparisi Pozo, J. A., Bailey, A. J., Barranco Navarro, L., Cabrera Urban, S., et al. (2019). Measurement of the top quark mass in the t(t)over-bar -> lepton plus jets channel from root s=8 TeV ATLAS data and combination with previous results. Eur. Phys. J. C, 79(4), 290–51pp.
Abstract: The top quark mass is measured using a template method in the ttlepton+jets channel (lepton is e or ) using ATLAS data recorded in 2012 at the LHC. The data were taken at a proton-proton centre-of-mass energy of =8 TeV and correspond to an integrated luminosity of 20.2 fb-1. The ttlepton+jets channel is characterized by the presence of a charged lepton, a neutrino and four jets, two of which originate from bottom quarks(b). Exploiting a three-dimensional template technique, the top quark mass is determined together with a global jet energy scale factor and a relative b-to-light-jet energy scale factor. The mass of the top quark is measured to be mtop=172.08 (syst)GeV. A combination with previous ATLAS mtop measurements gives mtop=172.69 +/- 0.25 0.41 (syst) GeV.
|
ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Aparisi Pozo, J. A., Bailey, A. J., Barranco Navarro, L., Cabrera Urban, S., et al. (2019). Measurement of the top-quark mass in tt 1-jet events collected with the ATLAS detector in pp collisions at=8 TeV. J. High Energy Phys., 11(11), 150–40pp.
Abstract: A determination of the top-quark mass is presented using 20.2 fb-1 of 8 TeV proton-proton collision data produced by the Large Hadron Collider and collected by the ATLAS experiment. The normalised differential cross section of top-quark pair production in association with an energetic jet is measured in the lepton+jets final state and unfolded to parton and particle levels. The unfolded distribution at parton level can be described using next-to-leading-order QCD predictions in terms of either the top-quark pole mass or the running mass as defined in the (modified) minimal subtraction scheme. A comparison between the experimental distribution and the theoretical prediction allows the top-quark mass to be extracted in the two schemes. The value obtained for the pole-mass scheme is: rnirle 171.1 0.4 (stat) 0.9 (syst) 173 (theo) GeV. The extracted value in the running-mass scheme is: rnt(rnt) = 162.9 0.5 (stat) 1.0 (syst) 1:12 (theo) GeV. The results for the top -quark mass using the two schemes are consistent, when translated from one scheme to the other.
|
ATLAS Collaboration(Aad, G. et al), Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Castillo Gimenez, V., Cerda Alberich, L., et al. (2023). Measurement of the top-quark mass using a leptonic invariant mass in pp collisions at root s=13 TeV with the ATLAS detector. J. High Energy Phys., 06(6), 019–56pp.
Abstract: A measurement of the top-quark mass (m(t)) in the t (t) over bar -> lepton+ jets channel is presented, with an experimental technique which exploits semileptonic decays of b-hadrons produced in the top-quark decay chain. The distribution of the invariant mass m(l mu) of the lepton, l (with l = e, mu), from the W-boson decay and the muon, mu, originating from the b-hadron decay is reconstructed, and a binned-template profile likelihood fit is performed to extract mt. The measurement is based on data corresponding to an integrated luminosity of 36.1 fb(-1) of root s = 13 TeV pp collisions provided by the Large Hadron Collider and recorded by the ATLAS detector. The measured value of the top-quark mass is mt = 174.41 +/- 0.39 (stat.) +/- 0.66 (syst.) +/- 0.25 (recoil) GeV, where the third uncertainty arises from changing the Pythia8 parton shower gluon-recoil scheme, used in top-quark decays, to a recently developed setup.
|
ATLAS Collaboration(Aad, G. et al), Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Castillo, F. L., Castillo Gimenez, V., et al. (2020). Measurement of the transverse momentum distribution of Drell-Yan lepton pairs in proton-proton collisions at root s=13 TeV with the ATLAS detector. Eur. Phys. J. C, 80(7), 616–28pp.
Abstract: This paper describes precision measurements of the transverse momentum p(T)(ll) (l = e, mu) and of the angular variable phi(eta)*. distributions of Drell-Yan lepton pairs in a mass range of 66-116 GeV. The analysis uses data from 36.1 fb(-1) ovf proton-proton collisions at a centre-of-mass energy of root s = 13 TeV collected by the ATLAS experiment at the LHC in 2015 and 2016. Measurements in electron-pair and muon-pair final states are performed in the same fiducial volumes, corrected for detector effects, and combined. Compared to previous measurements in proton-proton collisions at root s = 7 and 8 TeV, these new measurements probe perturbative QCD at a higher centre-of-mass energy with a different composition of initial states. They reach a precision of 0.2% for the normalized spectra at low values of p(T)(ll). The data are compared with different QCD predictions, where it is found that predictions based on resummation approaches can describe the full spectrum within uncertainties.
|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Castillo, F. L., et al. (2020). Measurement of the ttbar production cross-section and lepton differential distributions in e mu dilepton events from pp collisions at root s=13 TeV with the ATLAS detector. Eur. Phys. J. C, 80(6), 528–70pp.
Abstract: The inclusive top quark pair (tt<overbar></mml:mover>) production cross-section sigma tt<overbar></mml:mover> has been measured in proton-proton collisions at <mml:msqrt>s</mml:msqrt>=13<mml:mspace width=“0.166667em”></mml:mspace>TeV, using 36.1 fb-1 of data collected in 2015-2016 by the ATLAS experiment at the LHC. Using events with an opposite-charge e μpair and b-tagged jets, the cross-section is measured to be: <disp-formula id=“Equ10”><mml:mtable><mml:mtr><mml:mtd columnalign=“right”>sigma tt<overbar></mml:mover>=826.4 +/- 3.6<mml:mspace width=“0.166667em”></mml:mspace>(stat)<mml:mspace width=“4pt”></mml:mspace>+/- 11.5<mml:mspace width=“0.166667em”></mml:mspace>(syst)<mml:mspace width=“4pt”></mml:mspace>+/- 15.7<mml:mspace width=“0.166667em”></mml:mspace>(lumi)<mml:mspace width=“4pt”></mml:mspace>+/- 1.9<mml:mspace width=“0.166667em”></mml:mspace>(beam)<mml:mspace width=“0.166667em”></mml:mspace>pb,</mml:mtd></mml:mtr></mml:mtable><graphic xmlns:xlink=“http://www.w3.org/1999/xlink” xlink:href=“1005220207907ArticleEqu10.gif” position=“anchor”></graphic></disp-formula>where the uncertainties reflect the limited size of the data sample, experimental and theoretical systematic effects, the integrated luminosity, and the LHC beam energy, giving a total uncertainty of 2.4%. The result is consistent with theoretical QCD calculations at next-to-next-to-leading order. It is used to determine the top quark pole mass via the dependence of the predicted cross-section on mtpole, giving mtpole=173.1-2.1+2.0<mml:mspace width=“0.166667em”></mml:mspace>GeV. It is also combined with measurements at <mml:msqrt>s</mml:msqrt><mml:mo>=7<mml:mspace width=“0.166667em”></mml:mspace>TeV and <mml:msqrt>s</mml:msqrt><mml:mo>=8<mml:mspace width=“0.166667em”></mml:mspace>TeV to derive ratios and double ratios of t<mml:mover accent=“true”>t<mml:mo stretchy=“false”><overbar></mml:mover> and Z cross-sections at different energies. The same event sample is used to measure absolute and normalised differential cross-sections as functions of single-lepton and dilepton kinematic variables, and the results are compared with predictions from various Monte Carlo event generators.
|
