Abstract: We show that, if they exist, lepton number asymmetries (L-alpha) of neutrino flavors should be distinguished from the ones (L-i) of mass eigenstates, since Big Bang Nucleosynthesis (BBN) bounds on the flavor eigenstates cannot be directly applied to the mass eigenstates. Similarly, Cosmic Microwave Background (CMB) constraints on the mass eigenstates do not directly constrain flavor asymmetries. Due to the difference of mass and flavor eigenstates, the cosmological constraint on the asymmetries of neutrino flavors can be much stronger than the conventional expectation, but they are not uniquely determined unless at least the asymmetry of the heaviest neutrino is well constrained. The cosmological constraint on L-i for a specific case is presented as an illustration.

Abstract: Using decays to f-meson pairs, the inclusive production of charmonium states in b-hadron decays is studied with pp collision data corresponding to an integrated luminosity of 3.0 fb(-1), collected by the LHCb experiment at centre-of-mass energies of 7 and 8 TeV. Denoting by B-C = B(b -> CX) x B(C -> phi phi) the inclusive branching fraction of a b hadron to a charmonium state C that decays into a pair of phi mesons, ratios R-C2(C1) = B-C1/B-C2 are determined as R-eta c(1S)(chi c0) = 0.147 +/- 0.023 +/- 0.011, R-eta c(1S)(chi c1) = 0.073 +/- 0.016 +/- 0.006, R-eta c(1S)(chi c2) = 0.081 +/- 0.013 +/- 0.005, R-chi c0(chi c1) = 0.50 +/- 0.11 +/- 0.01, R-chi c0(chi c2) = 0.56 +/- 0.10 +/- 0.01 and R-eta c(1S)(eta c(2S)) = 0.040 +/- 0.011 +/- 0.004. Here and below the first uncertainties are statistical and the second systematic. Upper limits at 90% confidence level for the inclusive production of X(3872), X(3915) and.c2(2P) states are obtained as R-chi c1(X(3872)) < 0.34, R-chi c0(X(3915)) < 0.12 and R-chi c2(chi c2(2P)) < 0.16. Differential cross-sections as a function of transverse momentum are measured for the eta(c)(1S) and chi(c) states. The branching fraction of the decay B-s(0). phi phi phi is measured for the first time, B(B-s(0) -> phi phi phi) = (2.15 +/- 0.54 +/- 0.28 +/- 0.21 B) x10(-6). Here the third uncertainty is due to the branching fraction of the decay B-s(0) -> phi phi, which is used for normalization. No evidence for intermediate resonances is seen. A preferentially transverse phi polarization is observed. Themeasurements allow the determination of the ratio of the branching fractions for the eta(c)(1S) decays to ff and p (p) over bar as B(eta(c)(1S) -> phi phi)/B(eta(c)(1S) -> p (p) over bar) = 1.79 +/- 0.14 +/- 0.32.

Abstract: A low-noise head amplifier has been developed for the extra low energy antiproton ring beam trajectory, orbit, and intensity measurement system at CERN. This system is based on 24 double-electrode electrostatic beam position monitors installed around the ring. A head amplifier is placed close to each beam position monitor to amplify the electrode signals and generate a difference and a sum signal. These signals are sent to the digital acquisition system, about 50 m away from the ring, where they are digitized and further processed. The beam position can be measured by dividing the difference signal by the sum signal while the sum signal gives information relative to the beam intensity. The head amplifier consists of two discrete charge preamplifiers with junction field effect transistor (JFET) inputs, a sum and a difference stage, and two cable drivers. Special attention has been paid to the amplifier printed circuit board design to minimize the parasitic capacitances and inductances at the charge amplifier stages to meet the gain and noise requirements. The measurements carried out on the head amplifier showed a gain of 40.5 and 46.5 dB for the sum and difference outputs with a bandwidth from 200 Hz to 75 MHz and an input voltage noise density lower than 400 pV/v Hz. Twenty head amplifiers have been already installed in the ring and they have been used to detect the first beam signals during the first commissioning stage in November 2016.