|
Fujita, H. et al, Algora, A., Estevez-Aguado, E., Molina, F., & Rubio, B. (2019). Experimental study of Gamow-Teller transitions via the high-energy-resolution O-18(He-3, t)F-18 reaction: Identification of the low-energy “super” -Gamow-Teller state. Phys. Rev. C, 100(3), 034618–13pp.
Abstract: Using the high-resolution O-18(He-3, t)F-18 reaction at 0 degrees and at 140 MeV/nucleon, Gamow-Teller (GT) transitions were studied. A high energy resolution of 31 keV was achieved by applying dispersion matching techniques. The main part of the observed GT transition strength is concentrated in the transition to the F-18 ground state (g.s.). The absolute values of the reduced GT transition strengths, B(GT), were derived up to E-x = 12 MeV assuming proportionality between the B(GT) values and the reaction cross sections at 0 degrees. The B(GT) value obtained from the beta decay of F-18 (g.s.) -> O-18 (g.s.) was used to determine the proportionality constant. A total B(GT) of 4.06(5) was found and 76(1)% of the strength is concentrated to the ground state of F-18. The obtained B(GT) values were compared with those from the O-18(p, n) F-18 reaction and the mirror symmetric beta(+) decay of Ne-18 -> F-18. The candidates for 1(+) states with isospin T = 1 were identified by comparison with the O-18(p, p') data. The results of shell-model and quasiparticle-random-phase approximation calculations suggest constructive contributions of various configurations to the F-18 ground state, suggesting that this state is the low-energy super GT state.
|
|
|
Romero-Barrientos, J., Marquez Damian, J. I., Molina, F., Zambra, M., Aguilera, P., Lopez-Usquiano, F., et al. (2022). Calculation of kinetic parameters beta eff and L with modified open source Monte Carlo code OpenMC(TD). Nucl. Eng. Technol., 54(3), 811–816.
Abstract: This work presents the methodology used to expand the capabilities of the Monte Carlo code OpenMC for the calculation of reactor kinetic parameters: effective delayed neutron fraction beff and neutron generation time L. The modified code, OpenMC(Time-Dependent) or OpenMC(TD), was then used to calculate the effective delayed neutron fraction by using the prompt method, while the neutron generation time was estimated using the pulsed method, fitting L to the decay of the neutron population. OpenMC(TD) is intended to serve as an alternative for the estimation of kinetic parameters when licensed codes are not available. The results obtained are compared to experimental data and MCNP calculated values for 18 benchmark configurations.
|
|