|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2014). Search for direct top-squark pair production in final states with two leptons in pp collisions at root s=8 TeV with the ATLAS detector. J. High Energy Phys., 06(6), 124–66pp.
Abstract: A search is presented for direct top-squark pair production in final states with two leptons (electrons or muons) of opposite charge using 20.3 fb(-1) of pp collision data at root s = 8 TeV, collected by the ATLAS experiment at the Large Hadron Collider in 2012. No excess over the Standard Model expectation is found. The results are interpreted under the separate assumptions (i) that the top squark decays to a b-quark in addition to an on-shell chargino whose decay occurs via a real or virtual W boson, or (ii) that the top squark decays to a t-quark and the lightest neutralino. A top squark with a mass between 150 GeV and 445 GeV decaying to a b-quark and an on-shell chargino is excluded at 95% confidence level for a top squark mass equal to the chargino mass plus 10 GeV, in the case of a 1 GeV lightest neutralino. Top squarks with masses between 215 (90) GeV and 530 (170) GeV decaying to an on-shell (off-shell) t-quark and a neutralino are excluded at 95% confidence level for a 1 GeV neutralino.
|
|
|
|
LHCb Collaboration(Aaij, R. et al), Martinez-Vidal, F., Oyanguren, A., Ruiz Valls, P., & Sanchez Mayordomo, C. (2014). Differential branching fractions and isospin asymmetries of B -> K ((*)) μ(+) μ(-) decays. J. High Energy Phys., 06(6), 133–22pp.
Abstract: The isospin asymmetries of B -> K μ(+) μ(-) and B -> K (*) μ(+) μ(-) decays and the partial branching fractions of the B (0) -> K (0) μ(+) μ(-), B (+) -> K (+) μ(+) μ(-) and B (+) -> K (*+) μ(+) μ(-) decays are measured as functions of the dimuon mass squared, q (2). The data used correspond to an integrated luminosity of 3 fb(-1) from proton-proton collisions collected with the LHCb detector at centre-of-mass energies of 7 TeV and 8 TeV in 2011 and 2012, respectively. The isospin asymmetries are both consistent with the Standard Model expectations. The three measured branching fractions favour lower values than their respective theoretical predictions, however they are all individually consistent with the Standard Model.
|
|
|
|
Aceti, F., Bayar, M., Dias, J. M., & Oset, E. (2014). Prediction of a Z(c)(4000) state and relationship with the claimed Z(c)(4025). Eur. Phys. J. A, 50(6), 103–13pp.
Abstract: After discussing the OZI suppression of one light meson exchange in the interaction of with isospin I = 1 , we study the contribution of the two-pion exchange to the interaction and the exchange of heavy vectors, J/psi for diagonal transitions and D-* for transitions of to J/psi rho. We find these latter mechanisms to be weak, but enough to barely bind the system in J = 2 with a mass around 4000 MeV, while the effect of the two-pion exchange is a net attraction, though weaker than that from heavy-vector exchange. We discuss this state and try to relate it to the Z (c) (4025) state, above the threshold, claimed in an experiment at BES from an enhancement of the distribution close to threshold. Together with the results from a recent reanalysis of the BES experiment showing that it is compatible with a J = 2 state below threshold around 3990 MeV, we conclude that the BES experiment could show the existence of the state that we find in our approach.
|
|
|
|
Carrasco, N., Ciuchini, M., Dimopoulos, P., Frezzotti, R., Gimenez, V., Lubicz, V., et al. (2014). D-0-(D)over-bar(0) mixing in the standard model and beyond from N-f=2 twisted mass QCD. Phys. Rev. D, 90(1), 014502–9pp.
Abstract: We present the first unquenched lattice QCD results for the bag parameters controlling the short distance contribution to D meson oscillations in the standard model and beyond. We have used the gauge configurations produced by the European Twisted Mass collaboration with N-f = 2 dynamical quarks, at four lattice spacings and light meson masses in the range 280-500 MeV. Renormalization is carried out nonperturbatively with the regularization-independent momentum subtraction method. The bag-parameter results have been used to constrain new physics effects in D-0 – (D) over bar (0) mixing, to put a lower bound to the generic new physics scale and to constrain off-diagonal squark mass terms for TeV-scale supersymmetry.
|
|
|
|
Barenboim, G., Bosch, C., Lopez-Ibañez, M. L., & Vives, O. (2014). Improved tau-lepton tools for Higgs boson hunting. Phys. Rev. D, 90(1), 015003–14pp.
Abstract: In this work, we use the results from Higgs searches in the gamma gamma and tau tau decay channels at LHC and indirect bounds as BR (B -> X-s gamma) to constrain the parameter space of a generic minimal supersymmetric standard model (MSSM) Higgs sector. In particular, we include the latest CMS results that look for additional Higgs states with masses up to 1 TeV. We show that the tau tau channel is the best and most accurate tool in the hunt for new Higgs states beyond the standard model. We obtain that present experimental results rule out additional neutral Higgs bosons in a generic MSSM below 300 GeV for any value of tan beta and, for instance, values of tan beta above 30 are only possible for Higgs masses above 600 GeV. ATLAS stored data have the potential to render this bound obsolete in the near future.
|
|
|
|
Goasduff, A., Valiente-Dobon, J. J., Lunardi, S., Haas, F., Gadea, A., de Angelis, G., et al. (2014). Counting rate measurements for lifetime experiments using the RDDS method with the new generation gamma-ray array AGATA. Nucl. Instrum. Methods Phys. Res. A, 758, 1–3.
Abstract: The differential Recoil Distance Doppler Shift (RDDS) method after multinucleon transfer (MNT) reactions to measure lifetimes of excited states in neutron-rich nuclei requires the use of a thick energy degrader for the recoiling ejectiles that are then detected in a spectrometer. This type of measurements greatly benefits from the use of the new generation segmented gamma-ray detectors, such as the AGATA demonstrator which offers unprecedented energy and angular resolutions. In order to make an optimized choice of the material and the thickness of the degrader for lifetime measurements using the RODS method after MNT, an experiment has been performed with the AGATA demonstrator. Counting rate measurements for different degraders are presented.
|
|
|
|
n_TOF Collaboration(Zugec, P. et al), Domingo-Pardo, C., Giubrone, G., & Tain, J. L. (2014). GEANT4 simulation of the neutron background of the C6D6 set-up for capture studies at n_TOF. Nucl. Instrum. Methods Phys. Res. A, 760, 57–67.
Abstract: The neutron sensitivity of the Cr6D6 detector setup used at nTOF facility for capture measurements has been studied by means of detailed GEANT4 simulations. A realistic software replica of the entire nTOF experimental hall, including the neutron beam line, sample, detector supports and the walls of the experimental area has been implemented in the simulations. The simulations have been analyzed in the same manner as experimental data, in particular by applying the Pulse Height Weighting Technique. The simulations have been validated against a measurement of the neutron background performed with a(nat)-C sample, showing an excellent agreement above 1 keV. At lower energies, an additional component in the measured C-nat yield has been discovered, which prevents the use of C-nat data for neutron background estimates at neutron energies below a few hundred eV. The origin and time structure of the neutron background have been derived from the simulations. Examples of the neutron background for two different samples are demonstrating the important role of accurate simulations of the neutron background in capture cross-section measurements.
|
|
|
|
BABAR Collaboration(Lees, J. P. et al), Martinez-Vidal, F., Oyanguren, A., & Villanueva-Perez, P. (2014). Measurement of the B -> X(s)l(+)l(-) Branching Fraction and Search for Direct CP Violation from a Sum of Exclusive Final States. Phys. Rev. Lett., 112(21), 211802–8pp.
Abstract: We measure the total branching fraction of the flavor-changing neutral-current process B -> X(s)l(+)l(-), along with partial branching fractions in bins of dilepton and hadronic system (X-s) mass, using a sample of 471 x 10(6)Upsilon(4S) -> B (B) over bar events recorded with the BABAR detector. The admixture of charged and neutral B mesons produced at PEP-II2 are reconstructed by combining a dilepton pair with 10 different X-s final states. Extrapolating from a sum over these exclusive modes, we measure a lepton-flavor-averaged inclusive branching fraction B(B -> X(s)l(+)l(-)) = [6.73(-0.64)(+0.70)(stat)(-0.25)(+0.34)(exp syst) +/- 0.50(model syst)] x 10(-6) for m(l+l-)(2) > 0.1 GeV2/c(4). Restricting our analysis exclusively to final states from which a decaying B meson's flavor can be inferred, we additionally report measurements of the direct CP asymmetry A(CP) in bins of dilepton mass; over the full dilepton mass range, we find A(CP) = 0.04 +/- 0.11 +/- 0.01 for a leptonflavor-averaged sample.
|
|
|
|
BABAR Collaboration(Lees, J. P. et al), Martinez-Vidal, F., Oyanguren, A., & Villanueva-Perez, P. (2014). Dalitz plot analysis of eta(c) -> K+K-eta and eta(c) -> K+K-pi(0) in two-photon interactions. Phys. Rev. D, 89(11), 112004–16pp.
Abstract: We study the processes gamma gamma -> K+K-eta and gamma gamma -> K+K-pi(0) using a data sample of 519 fb(-1) recorded with the BABAR detector operating at the SLAC PEP-II asymmetric-energy e(+)e(-) collider at center-of-mass energies at and near the Upsilon(nS) (n = 2, 3, 4) resonances. We observe eta(c) -> K+K-pi(0) and eta(c) -> K+K-eta decays, measure their relative branching fraction, and perform a Dalitz plot analysis for each decay. We observe the K*(0)(1430) -> K eta decay and measure its branching fraction relative to the K pi decay mode to be R(K*(0)(1430)) = B(K*(0)(1430)-> K eta)/B(K*(0)(1430)-> K pi) = 0.092 +/- 0.025(- 0.025)(+0.010). The eta(c) -> K+K-eta and K*(0)(1430) -> K eta results correspond to the first observations of these channels. The data also show evidence for eta(c)(2S) -> K+K-pi(0) and first evidence for eta(c)(2S) -> K+K-eta.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2014). Measurement of dijet cross-sections in pp collisions at 7 TeV centre-of-mass energy using the ATLAS detector. J. High Energy Phys., 05(5), 059–67pp.
Abstract: Double-differential dijet cross-sections measured in pp collisions at the LHC with a 7 TeV centre-of-mass energy are presented as functions of dijet mass and half the rapidity separation of the two highest-p(T) jets. These measurements are obtained using data corresponding to an integrated luminosity of 4.5 fb(-1), recorded by the ATLAS detector in 2011. The data are corrected for detector effects so that cross-sections are presented at the particle level. Cross-sections are measured up to 5 TeV dijet mass using jets reconstructed with the anti-k(t) algorithm for values of the jet radius parameter of 0.4 and 0.6. The cross-sections are compared with next-to-leading-order perturbative QCD calculations by NLOJet++ corrected to account for non-perturbative effects. Comparisons with POWHEG predictions, using a next-to-leading-order matrix element calculation interfaced to a parton-shower Monte Carlo simulation, are also shown. Electroweak effects are accounted for in both cases. The quantitative comparison of data and theoretical predictions obtained using various parameterizations of the parton distribution functions is performed using a frequentist method. In general, good agreement with data is observed for the NLOJet++ theoretical predictions when using the CT10, NNPDF2.1 and MSTW 2008 PDF sets. Disagreement is observed when using the ABM11 and HERAPDF1.5 PDF sets for some ranges of dijet mass and half the rapidity separation. An example setting a lower limit on the compositeness scale for a model of contact interactions is presented, showing that the unfolded results can be used to constrain contributions to dijet production beyond that predicted by the Standard Model.
|
|
