CDF Collaboration(Aaltonen, T. et al), & Cabrera, S. (2010). Improved Search for a Higgs Boson Produced in Association with Z -> l(+)l(-) in p(p)over-bar Collisions at root s=1.96 TeV. Phys. Rev. Lett., 105(25), 251802–7pp.
Abstract: We search for the standard model Higgs boson produced with a Z boson in 4: 1 fb(-1) of integrated luminosity collected with the CDF II detector at the Tevatron. In events consistent with the decay of the Higgs boson to a bottom-quark pair and the Z boson to electrons or muons, we set 95% credibility level upper limits on the ZH production cross section multiplied by the H -> b (b) over bar branching ratio. Improved analysis methods enhance signal sensitivity by 20% relative to previous searches. At a Higgs boson mass of 115 GeV/c(2) we set a limit of 5.9 times the standard model cross section.
|
CDF Collaboration(Aaltonen, T. et al), Cabrera, S., & Cuenca Almenar, C. (2010). Measurements of the top-quark mass using charged particle tracking. Phys. Rev. D, 81(3), 032002–21pp.
Abstract: We present three measurements of the top-quark mass in the lepton plus jets channel with approximately 1.9 fb(-1) of integrated luminosity collected with the CDF II detector using quantities with minimal dependence on the jet energy scale. One measurement exploits the transverse decay length of b-tagged jets to determine a top-quark mass of 166.9(-8.5)(+9.5)(stat) +/- 2.9(syst) GeV/c(2), and another the transverse momentum of electrons and muons from W-boson decays to determine a top-quark mass of 173.5(-8.9)(+8.8)(stat) +/- 3.8(syst) GeV/c(2). These quantities are combined in a third, simultaneous mass measurement to determine a top-quark mass of 170.7 +/- 6.3(stat) +/- 2.6(syst) GeV/c(2) .
|
CDF Collaboration(Aaltonen, T. et al), & Cabrera, S. (2010). Combination of Tevatron Searches for the Standard Model Higgs Boson in the W+W- Decay Mode. Phys. Rev. Lett., 104(6), 061802–11pp.
Abstract: We combine searches by the CDF and D0 Collaborations for a Higgs boson decaying to W+W-. The data correspond to an integrated total luminosity of 4.8 (CDF) and 5.4 (D0) fb(-1) of p (p) over bar collisions at root s = 1.96 TeV at the Fermilab Tevatron collider. No excess is observed above background expectation, and resulting limits on Higgs boson production exclude a standard model Higgs boson in the mass range 162-166 GeV at the 95% C.L.
|
CDF Collaboration(Aaltonen, T. et al), & Cabrera, S. (2010). Inclusive Search for Standard Model Higgs Boson Production in the WW Decay Channel Using the CDF II Detector. Phys. Rev. Lett., 104(6), 061803–8pp.
Abstract: We present a search for standard model (SM) Higgs boson production using p (p) over bar collision data at root s = 1. 96 TeV, collected with the CDF II detector and corresponding to an integrated luminosity of 4. 8 fb(-1). We search for Higgs bosons produced in all processes with a significant production rate and decaying to two W bosons. We find no evidence for SM Higgs boson production and place upper limits at the 95% confidence level on the SM production cross section (sigma(H)) for values of the Higgs boson mass (m(H)) in the range from 110 to 200 GeV. These limits are the most stringent for m(H) > 130 GeV and are 1.29 above the predicted value of sigma(H) for m(H) 165 GeV.
|
CDF Collaboration(Aaltonen, T. et al), & Cabrera, S. (2010). Search for Supersymmetry with Gauge-Mediated Breaking in Diphoton Events with Missing Transverse Energy at CDF II. Phys. Rev. Lett., 104(1), 011801–8pp.
Abstract: We present the results of a search for supersymmetry with gauge-mediated breaking and (chi) over tilde (1)(0) -> gamma(G) over tilde in the gamma gamma + missing transverse energy final state. In 2.6 +/- 0.2 fb(-1) of p (p) over bar collisions at root s 1.96 TeV recorded by the CDF II detector we observe no candidate events, consistent with a standard model background expectation of 1.4 +/- 0.4 events. We set limits on the cross section at the 95% C.L. and place the world's best limit of 149 GeV/c(2) on the (chi) over tilde (1)(0) mass at tau((chi) over tilde 01) << 1 ns. We also exclude regions in the (chi) over tilde (1)(0) mass-lifetime plane for tau((chi) over tilde 01) less than or similar to 2 ns.
|
CDF Collaboration(Aaltonen, T. et al), & Cabrera, S. (2010). Observation of single top quark production and measurement of vertical bar V-tb vertical bar with CDF. Phys. Rev. D, 82(11), 112005–59pp.
Abstract: We report the observation of electroweak single top quark production in 3: 2 fb(-1) of p (p) over bar collision data collected by the Collider Detector at Fermilab at root s = 1.96 TeV. Candidate events in the W + jets topology with a leptonically decaying W boson are classified as signal-like by four parallel analyses based on likelihood functions, matrix elements, neural networks, and boosted decision trees. These results are combined using a super discriminant analysis based on genetically evolved neural networks in order to improve the sensitivity. This combined result is further combined with that of a search for a single top quark signal in an orthogonal sample of events with missing transverse energy plus jets and no charged lepton. We observe a signal consistent with the standard model prediction but inconsistent with the background-only model by 5.0 standard deviations, with a median expected sensitivity in excess of 5.9 standard deviations. We measure a production cross section of 2.3-(+0.6)(0.5) (stat + sys) pb, extract the value of the Cabibbo-Kobayashi-Maskawa matrix element vertical bar V-tb vertical bar = 0.91(-0.11)(+0.11) (stat + sys) +/- 0.07 (theory), and set a lower limit vertical bar V-tb vertical bar > 0.71 at the 95% C. L., assuming m(t) = 175 GeV/c(2).
|
CDF Collaboration(Aaltonen, T. et al), & Cabrera, S. (2011). Measurement of b Hadron Lifetimes in Exclusive Decays Containing a J/Psi in p(p)over-bar Collisions at sqrt(s)=1.96 TeV. Phys. Rev. Lett., 106(12), 121804–8pp.
Abstract: We report on a measurement of b-hadron lifetimes in the fully reconstructed decay modes B+-> J/psi K+, B-0 -> J/psi K*(892)(0), B-0 -> J/psi K-s(0), and Lambda(0)(b)-> J/psi Lambda(0) using data corresponding to an integrated luminosity of 4.3 fb(-1), collected by the CDF II detector at the Fermilab Tevatron. The measured lifetimes are tau(B+)=[1.639 +/- 0.009(stat)+/- 0.009(syst)]ps, tau(B-0)=[1.507 +/- 0.010(stat)+/- 0.008(syst)]ps, and tau(Lambda(0)(b))=[1.537 +/- 0.045(stat)+/- 0.014(syst)]ps. The lifetime ratios are tau(B+)/tau(B-0)=[1.088 +/- 0.009(stat)+/- 0.004(syst)] and tau(Lambda(0)(b))/tau(B-0)=[1.020 +/- 0.030(stat)+/- 0.008(syst)]. These are the most precise determinations of these quantities from a single experiment.
|
CDF Collaboration(Aaltonen, T. et al), & Cabrera, S. (2010). Measurement of the WW plus WZ production cross section using a matrix element technique in lepton plus jets events. Phys. Rev. D, 82(11), 112001–15pp.
Abstract: We present a measurement of the WW + WZ production cross section observed in a final state consisting of an identified electron or muon, two jets, and missing transverse energy. The measurement is carried out in a data sample corresponding to up to 4.6 fb(-1) of integrated luminosity at root s = 1.96 TeV collected by the CDF II detector. Matrix element calculations are used to separate the diboson signal from the large backgrounds. The WW + WZ cross section is measured to be 17.4 +/- 3.3 pb in agreement with standard model predictions. A fit to the dijet invariant mass spectrum yields a compatible cross section measurement.
|
CDF Collaboration(Aaltonen, T. et al), & Cabrera, S. (2011). Measurement of the B- lifetime using a simulation free approach for trigger bias correction. Phys. Rev. D, 83(3), 032008–30pp.
Abstract: The collection of a large number of B-hadron decays to hadronic final states at the CDF II Detector is possible due to the presence of a trigger that selects events based on track impact parameters. However, the nature of the selection requirements of the trigger introduces a large bias in the observed proper-decay-time distribution. A lifetime measurement must correct for this bias, and the conventional approach has been to use a Monte Carlo simulation. The leading sources of systematic uncertainty in the conventional approach are due to differences between the data and the Monte Carlo simulation. In this paper, we present an analytic method for bias correction without using simulation, thereby removing any uncertainty due to the differences between data and simulation. This method is presented in the form of a measurement of the lifetime of the B- using the mode B- -> D-0 pi(-). The B- lifetime is measured as tau(-)(B) = 1.663 +/- 0.023 +/- 0.015 ps, where the first uncertainty is statistical and the second systematic. This new method results in a smaller systematic uncertainty in comparison to methods that use simulation to correct for the trigger bias.
|
CDF Collaboration(Aaltonen, T. et al), & Cabrera, S. (2011). Measurement of the t(t)over-bar production cross section with an in situ calibration of b-jet identification efficiency. Phys. Rev. D, 83(7), 071102–8pp.
Abstract: A measurement of the top-quark pair-production cross section in p (p) over bar collisions at root s = 1.96 TeV using data corresponding to an integrated luminosity of 1.12 fb(-1) collected with the Collider Detector at Fermilab is presented. Decays of top-quark pairs into the final states ev + jets and μv+ jets are selected, and the cross section and the b-jet identification efficiency are determined using a new measurement technique which requires agreement between the measured cross sections with exactly one and with multiple identified b quarks from the top-quark decays. Assuming a top-quark mass of 175 GeV/c(2), a cross section of 8.5 +/- 0.6(stat) +/- 0.7(syst)pb is measured.
|
