|
|
CDF Collaboration(Aaltonen, T. et al), & Cabrera, S. (2011). Measurement of the B- lifetime using a simulation free approach for trigger bias correction. Phys. Rev. D, 83(3), 032008–30pp.
Abstract: The collection of a large number of B-hadron decays to hadronic final states at the CDF II Detector is possible due to the presence of a trigger that selects events based on track impact parameters. However, the nature of the selection requirements of the trigger introduces a large bias in the observed proper-decay-time distribution. A lifetime measurement must correct for this bias, and the conventional approach has been to use a Monte Carlo simulation. The leading sources of systematic uncertainty in the conventional approach are due to differences between the data and the Monte Carlo simulation. In this paper, we present an analytic method for bias correction without using simulation, thereby removing any uncertainty due to the differences between data and simulation. This method is presented in the form of a measurement of the lifetime of the B- using the mode B- -> D-0 pi(-). The B- lifetime is measured as tau(-)(B) = 1.663 +/- 0.023 +/- 0.015 ps, where the first uncertainty is statistical and the second systematic. This new method results in a smaller systematic uncertainty in comparison to methods that use simulation to correct for the trigger bias.
|
|
|
|
CDF Collaboration(Aaltonen, T. et al), & Cabrera, S. (2011). Measurement of the t(t)over-bar production cross section with an in situ calibration of b-jet identification efficiency. Phys. Rev. D, 83(7), 071102–8pp.
Abstract: A measurement of the top-quark pair-production cross section in p (p) over bar collisions at root s = 1.96 TeV using data corresponding to an integrated luminosity of 1.12 fb(-1) collected with the Collider Detector at Fermilab is presented. Decays of top-quark pairs into the final states ev + jets and μv+ jets are selected, and the cross section and the b-jet identification efficiency are determined using a new measurement technique which requires agreement between the measured cross sections with exactly one and with multiple identified b quarks from the top-quark decays. Assuming a top-quark mass of 175 GeV/c(2), a cross section of 8.5 +/- 0.6(stat) +/- 0.7(syst)pb is measured.
|
|
|
|
CDF Collaboration(Aaltonen, T. et al), & Cabrera, S. (2012). Production of Lambda(0), (Lambda)over-bar(0), Xi(+/-), and Omega(+/-) hyperons in p(p)over-bar collisions at root s=1.96 TeV. Phys. Rev. D, 86(1), 012002–10pp.
Abstract: We report a set of measurements of inclusive invariant p(T) differential cross sections of Lambda(0), (Lambda) over bar (0), Xi(+/-), and Omega(+/-) hyperons reconstructed in the central region with pseudorapidity vertical bar eta vertical bar < 1 and p(T) up to 10 GeV/c. Events are collected with a minimum-bias trigger in p<(p)over bar> collisions at a center-of-mass energy of 1.96 TeV using the CDF II detector at the Tevatron Collider. As p(T) increases, the slopes of the differential cross sections of the three particles are similar, which could indicate a universality of the particle production in p(T). The invariant differential cross sections are also presented for different charged-particle multiplicity intervals.
|
|
|
|
CDF Collaboration(Aaltonen, T. et al), Cabrera, S., & Cuenca Almenar, C. (2010). Study of multi-muon events produced in p (p)over-bar interactions at root s=1.96 TeV. Eur. Phys. J. C, 68(1-2), 109–118.
Abstract: We report the results of a study of multi-muon events produced at the Fermilab Tevatron collider and acquired with the CDF II detector using a dedicated dimuon trigger. The production cross section and kinematics of events in which both muon candidates are produced inside the beam pipe of radius 1.5 cm are successfully modeled by known processes which include heavy flavor production. In contrast, we are presently unable to fully account for the number and properties of the remaining events, in which at least one muon candidate is produced outside of the beam pipe, in terms of the same understanding of the CDF II detector, trigger, and event reconstruction.
|
|
