|
BABAR Collaboration(Lees, J. P. et al), Martinez-Vidal, F., Oyanguren, A., & Villanueva-Perez, P. (2013). Measurement of the D*(2010)(+) Meson Width and the D*(2010)(+) – D-0 Mass Difference. Phys. Rev. Lett., 111(11), 111801–8pp.
Abstract: We measure the mass difference Delta m(0) between the D*(2010)(+) and the D-0 and the natural linewidth Gamma of the transition D*(2010)(+) -> D-0 pi(+). The data were recorded with the BABAR detector at center-of-mass energies at and near the gamma(4S) resonance, and correspond to an integrated luminosity of approximately 477 fb(-1). The D-0 is reconstructed in the decay modes D-0 -> K-pi(+) and D-0 -> K-pi(+) and D-0 -> K-pi(+)pi(-)pi(+). For the decay mode D-0 -> K-pi(+) we obtain Gamma = (83.4 +/- 1.7 +/- 1.5) keV and Delta m(0) = (145425.6 +/- 0.6 +/- 18) keV, where the quoted errors are statistical and systematic, respectively. For the D-0 -> K-pi(+)pi(-)pi(+) mode we obtain Gamma = (83.2 +/- 1.5 +/- 2.6) keV and Delta m(0) = (145426.6 +/- 0.5 +/- 2.0) keV. The combined measurements yield Gamma = (83.3 +/- 1.2 +/- 1.4) keV and Delta m(0) (145425.9 +/- 0.4 +/- 1.7) keV; the width is a factor of approximately 12 times more precise than the previous value, while the mass difference is a factor of approximately 6 times more precise.
|
|
|
Watanabe, H. et al, & Montaner-Piza, A. (2013). Isomers in Pd-128 and Pd-126: Evidence for a Robust Shell Closure at the Neutron Magic Number 82 in Exotic Palladium Isotopes. Phys. Rev. Lett., 111(15), 152501–5pp.
Abstract: The level structures of the very neutron-rich nuclei Pd-128 and Pd-126 have been investigated for the first time. In the r-process waiting-point nucleus Pd-128, a new isomer with a half-life of 5.8(8) μs is proposed to have a spin and parity of 8(+) and is associated with a maximally aligned configuration arising from the g(9/2) proton subshell with seniority v = 2. For Pd-126, two new isomers have been identified with half-lives of 0.33(4) and 0.44(3) μs. The yrast 2(+) energy is much higher in Pd-128 than in Pd-126, while the level sequence below the 8(+) isomer in Pd-128 is similar to that in the N = 82 isotone Cd-130. The electric quadrupole transition that depopulates the 8(+) isomer in Pd-128 is more hindered than the corresponding transition in Cd-130, as expected in the seniority scheme for a semimagic, spherical nucleus. These experimental findings indicate that the shell closure at the neutron number N = 82 is fairly robust in the neutron-rich Pd isotopes.
|
|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2013). Measurement of the Azimuthal Angle Dependence of Inclusive Jet Yields in Pb plus Pb Collisions at root s(NN)=2.76 TeV with the ATLAS Detector. Phys. Rev. Lett., 111(15), 152301–18pp.
Abstract: Measurements of the variation of inclusive jet suppression as a function of relative azimuthal angle, Delta phi, with respect to the elliptic event plane provide insight into the path-length dependence of jet quenching. ATLAS has measured the Delta phi dependence of jet yields in 0.14 nb(-1) of root s(NN) = 2.76 TeV Pb + Pb collisions at the LHC for jet transverse momenta p(T) > 45 GeV in different collision centrality bins using an underlying event subtraction procedure that accounts for elliptic flow. The variation of the jet yield with Delta phi was characterized by the parameter, nu(jet)(2), and the ratio of out-of-plane (Delta phi similar to pi/2) to in-plane (Delta phi similar to 0) yields. Nonzero nu(jet)(2) values were measured in all centrality bins for p(T) < 160 GeV. The jet yields are observed to vary by as much as 20% between in-plane and out-of-plane directions.
|
|
|
T2K Collaboration(Abe, K. et al), Cervera-Villanueva, A., Escudero, L., Gomez-Cadenas, J. J., Izmaylov, A., Monfregola, L., et al. (2013). Measurement of Neutrino Oscillation Parameters from Muon Neutrino Disappearance with an Off-Axis Beam. Phys. Rev. Lett., 111(21), 211803–7pp.
Abstract: The T2K Collaboration reports a precision measurement of muon neutrino disappearance with an off-axis neutrino beam with a peak energy of 0.6 GeV. Near detector measurements are used to constrain the neutrino flux and cross section parameters. The Super-Kamiokande far detector, which is 295 km downstream of the neutrino production target, collected data corresponding to 3.01 x 10(20) protons on target. In the absence of neutrino oscillations, 205 +/- 17 (syst) events are expected to be detected while only 58 muon neutrino event candidates are observed. A fit to the neutrino rate and energy spectrum, assuming three neutrino flavors and normal mass hierarchy yields a best-fit mixing angle sin(2) (theta(23)) = 0.514 +/- 0.082 and mass splitting vertical bar Delta m(32)(2)vertical bar = 2.44(-0.15)(+0.17) x 10(-3) eV(2)/c(4). Our result corresponds to the maximal oscillation disappearance probability.
|
|
|
Campanario, F., Figy, T. M., Platzer, S., & Sjodahl, M. (2013). Electroweak Higgs Boson Plus Three Jet Production at Next-to-Leading-Order QCD. Phys. Rev. Lett., 111(21), 211802–4pp.
Abstract: We calculate next-to-leading order (NLO) QCD corrections to electroweak Higgs boson plus three jet production. Both vector boson fusion (VBF) and Higgs-strahlung type contributions are included along with all interferences. The calculation is implemented within the MATCHBOX NLO framework of the HERWIG++ event generator.
|
|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2013). Measurement of top quark polarization in top-antitop events from proton-proton collisions at root s=7 TeV using the ATLAS detector. Phys. Rev. Lett., 111(23), 232002–19pp.
Abstract: This Letter presents measurements of the polarization of the top quark in top-antitop quark pair events, using 4: 7 fb(-1) of proton-proton collision data recorded with the ATLAS detector at the Large Hadron Collider at root s = 7 TeV. Final states containing one or two isolated leptons ( electrons or muons) and jets are considered. Two measurements of alpha P-l, the product of the leptonic spin-analyzing power and the top quark polarization, are performed assuming that the polarization is introduced by either a CP conserving or a maximally CP violating production process. The measurements obtained, alpha P-l(CPC) = -0: 035 +/- 0: 014(stat) +/- 0: 037(syst) and alpha P-l(CPV) = 0: 020 +/- 0: 016(stat)(-0.017)(+0.013)(syst), are in good agreement with the standard model prediction of negligible top quark polarization.
|
|
|
Edgecock, T. R. et al, Agarwalla, S. K., Cervera-Villanueva, A., Donini, A., Ghosh, T., Gomez-Cadenas, J. J., et al. (2013). High intensity neutrino oscillation facilities in Europe. Phys. Rev. Spec. Top.-Accel. Beams, 16(2), 021002–18pp.
Abstract: The EUROnu project has studied three possible options for future, high intensity neutrino oscillation facilities in Europe. The first is a Super Beam, in which the neutrinos come from the decay of pions created by bombarding targets with a 4 MW proton beam from the CERN High Power Superconducting Proton Linac. The far detector for this facility is the 500 kt MEMPHYS water Cherenkov, located in the Frejus tunnel. The second facility is the Neutrino Factory, in which the neutrinos come from the decay of mu(+) and mu(-) beams in a storage ring. The far detector in this case is a 100 kt magnetized iron neutrino detector at a baseline of 2000 km. The third option is a Beta Beam, in which the neutrinos come from the decay of beta emitting isotopes, in particular He-6 and Ne-18, also stored in a ring. The far detector is also the MEMPHYS detector in the Frejus tunnel. EUROnu has undertaken conceptual designs of these facilities and studied the performance of the detectors. Based on this, it has determined the physics reach of each facility, in particular for the measurement of CP violation in the lepton sector, and estimated the cost of construction. These have demonstrated that the best facility to build is the Neutrino Factory. However, if a powerful proton driver is constructed for another purpose or if the MEMPHYS detector is built for astroparticle physics, the Super Beam also becomes very attractive.
|
|
|
Bross, A., Wands, R., Bayes, R., Laing, A., Soler, F. J. P., Cervera-Villanueva, A., et al. (2013). Toroidal magnetized iron neutrino detector for a neutrino factory. Phys. Rev. Spec. Top.-Accel. Beams, 16(8), 081002–16pp.
Abstract: A neutrino factory has unparalleled physics reach for the discovery and measurement of CP violation in the neutrino sector. A far detector for a neutrino factory must have good charge identification with excellent background rejection and a large mass. An elegant solution is to construct a magnetized iron neutrino detector (MIND) along the lines of MINOS, where iron plates provide a toroidal magnetic field and scintillator planes provide 3D space points. In this paper, the current status of a simulation of a toroidal MIND for a neutrino factory is discussed in light of the recent measurements of large theta(13). The response and performance using the 10 GeV neutrino factory configuration are presented. It is shown that this setup has equivalent delta(CP) reach to a MIND with a dipole field and is sensitive to the discovery of CP violation over 85% of the values of delta(CP).
|
|
|
Gillam, J. E., Solevi, P., Oliver, J. F., & Rafecas, M. (2013). Simulated one-pass list-mode: an approach to on-the-fly system matrix calculation. Phys. Med. Biol., 58(7), 2377–2394.
Abstract: In the development of prototype systems for positron emission tomography a valid and robust image reconstruction algorithm is required. However, prototypes often employ novel detector and system geometries which may change rapidly under optimization. In addition, developing systems generally produce highly granular, or possibly continuous detection domains which require some level of on-the-fly calculation for retention of measurement precision. In this investigation a new method of on-the-fly system matrix calculation is proposed that provides advantages in application to such list-mode systems in terms of flexibility in system modeling. The new method is easily adaptable to complicated system geometries and available computational resources. Detection uncertainty models are used as random number generators to produce ensembles of possible photon trajectories at image reconstruction time for each datum in the measurement list. However, the result of this approach is that the system matrix elements change at each iteration in a non-repetitive manner. The resulting algorithm is considered the simulation of a one-pass list (SOPL) which is generated and the list traversed during image reconstruction. SOPL alters the system matrix in use at each iteration and so behavior within the maximum likelihood-expectation maximization algorithm was investigated. A two-pixel system and a small two dimensional imaging model are used to illustrate the process and quantify aspects of the algorithm. The two-dimensional imaging system showed that, while incurring a penalty in image resolution, in comparison to a non-random equal-computation counterpart, SOPL provides much enhanced noise properties. In addition, enhancement in system matrix quality is straightforward (by increasing the number of samples in the ensemble) so that the resolution penalty can be recovered when desired while retaining improvement in noise properties. Finally the approach is tested and validated against a standard (highly accurate) system matrix using experimental data from a prototype system-the AX-PET.
|
|
|
Robert, C., Dedes, G., Battistoni, G., Bohlen, T. T., Buvat, I., Cerutti, F., et al. (2013). Distributions of secondary particles in proton and carbon-ion therapy: a comparison between GATE/Geant4 and FLUKA Monte Carlo codes. Phys. Med. Biol., 58(9), 2879–2899.
Abstract: Monte Carlo simulations play a crucial role for in-vivo treatment monitoring based on PET and prompt gamma imaging in proton and carbon-ion therapies. The accuracy of the nuclear fragmentation models implemented in these codes might affect the quality of the treatment verification. In this paper, we investigate the nuclear models implemented in GATE/Geant4 and FLUKA by comparing the angular and energy distributions of secondary particles exiting a homogeneous target of PMMA. Comparison results were restricted to fragmentation of O-16 and C-12. Despite the very simple target and set-up, substantial discrepancies were observed between the two codes. For instance, the number of high energy (>1 MeV) prompt gammas exiting the target was about twice as large with GATE/Geant4 than with FLUKA both for proton and carbon ion beams. Such differences were not observed for the predicted annihilation photon production yields, for which ratios of 1.09 and 1.20 were obtained between GATE and FLUKA for the proton beam and the carbon ion beam, respectively. For neutrons and protons, discrepancies from 14% (exiting protons-carbon ion beam) to 57% (exiting neutrons-proton beam) have been identified in production yields as well as in the energy spectra for neutrons.
|
|