Abstract: Dielectric Assist Accelerating (DAA) structures based on ultralow-loss ceramic are being studied as an alternative to conventional disk-loaded copper cavities. This accelerating structure consists of dielectric disks with irises arranged periodically in metallic structures working under the TM02-pi mode. In this paper, the numerical design of an S-band DAA structure for low beta particles, such as protons or carbon ions used for Hadrontherapy treatments, is shown. Four dielectric materials with different permittivity and loss tangent are studied as well as different particle velocities. Through optimization, a design that concentrates most of the RF power in the vacuum space near the beam axis is obtained, leading to a significant reduction of power loss on the metallic walls. This allows to fabricate cavities with an extremely high quality factor, over 100,000, and shunt impedance over 300 M omega/m at room temperature. During the numerical study, the design optimization has been improved by adjusting some of the cell parameters in order to both increase the shunt impedance and reduce the peak electric field in certain locations of the cavity, which can lead to instabilities in its normal functioning.

Abstract: The production rate of B-s(0) mesons relative to B-0 mesons is measured by the LHCb experiment in pp collisions at a center-of-mass energy root s = 13 TeV over the forward rapidity interval 2 < y < 4.5 as a function of the charged particle multiplicity measured in the event. Evidence at the 3.4 sigma level is found for an increase of the ratio of B-s(0) to B-0 cross sections with multiplicity at transverse momenta below 6 GeV=c, with no significant multiplicity dependence at higher transverse momentum. Comparison with data from e(+)e(-) collisions implies that the density of the hadronic medium may affect the production rates of B mesons. This is qualitatively consistent with the emergence of quark coalescence as an additional hadronization mechanism in high-multiplicity collisions.

Abstract: The inclusive Higgs boson production cross-section is measured in the di-photon and the ZZ -> 4l decay channels using 31.4 and 29.0 fb-1 of pp collision data respectively, collected with the ATLAS detector at a centre-of-mass energy of <mml:msqrt>s</mml:msqrt>=13.6 TeV. To reduce the model dependence, the measurement in each channel is restricted to a particle-level phase space that closely matches the channel's detector-level kinematic selection, and it is corrected for detector effects. These measured fiducial cross-sections are sigma fid,gamma gamma= 76-13+14</mml:msubsup> fb, and sigma fid,4l= 2.80<mml:mspace width=“0.166667em”></mml:mspace>+/- <mml:mspace width=“0.166667em”></mml:mspace>0.74 fb, in agreement with the corresponding Standard Model predictions of 67.6 +/- 3.7 fb and 3.67 +/- 0.19 fb. Assuming Standard Model acceptances and branching fractions for the two channels, the fiducial measurements are extrapolated to the full phase space yielding total cross-sections of sigma (pp -> H)=67-11+12 pb and 46 +/- 12 pb at 13.6 TeV from the di-photon and ZZ -> 4l measurements respectively. The two measurements are combined into a total cross-section measurement of sigma (pp -> H)=58.2 +/- 8.7 pb, to be compared with the Standard Model prediction of sigma <mml:msub>(pp -> H)SM=59.9 +/- 2.6 pb.