|
|
Taprogge, J. et al, Gadea, A., & Montaner-Piza, A. (2014). Identification of a millisecond isomeric state in Cd-129(81) via the detection of internal conversion and Compton electrons. Phys. Lett. B, 738, 223–227.
Abstract: The decay of an isomeric state in the neutron-rich nucleus Cd-129 has been observed via the detection of internal conversion and Compton electrons providing first experimental information on excited states in this nucleus. The isomer was populated in the projectile fission of a U-238 beam at the Radioactive Isotope Beam Factory at RIKEN. From the measured yields of gamma-rays and internal conversion electrons, a multipolarity of E3 was tentatively assigned to the isomeric transition. A half-life of T-1/2 = 3.6(2) ms was determined for the new state which was assigned a spin of (21/2(+)), based on a comparison to shell model calculations performed using state-of-the-art realistic effective interactions.
|
|
|
|
Albertus, C., Hernandez, E., Hidalgo-Duque, C., & Nieves, J. (2014). (B)over-bar(s) -> K semileptonic decay from an Omnes improved constituent quark model. Phys. Lett. B, 738, 144–149.
Abstract: We study the f(+) form factor for the semileptonic (B) over bar (s) -> K+ l(-) (V) over bar (l) decay in a constituent quark model. The valence quark estimate is supplemented with the contribution from the (B) over bar* pole that dominates the high q(2) region. We use a multiply-subtracted Omnes dispersion relation to extend the quark model predictions from its region of applicability near q(max)(2) = (M-Bs – M-K)(2) similar to 23.75 GeV2 to all q(2) values accessible in the physical decay. To better constrain the dependence of f(+) on q(2), we fit the subtraction constants to a combined input from previous light cone sum rule by Duplancic and Melic (2008) [11] and the present quark model results. From this analysis, we obtain Gamma ( (B) over bar (s) -> K+ l(-) (V) over bar (l)) = (5.47(-0.46)(+0.54)) vertical bar Vub vertical bar(2) x 10(-9) MeV, which is about 10% and 20% higher than the predictions based on Lattice QCD and QCD light cone sum rules respectively. The former predictions, for both the form factor f(+) (q(2)) and the differential decay width, lie within the 1 sigma band of our estimated uncertainties for all q(2) values accessible in the physical decay, except for a quite small region very close to q(max)(2). Differences with the light cone sum results for the form factor f(+) are larger than 20% in the region above q(2) = 15 GeV2.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Ferrer, A., Fiorini, L., et al. (2014). Search for the Standard Model Higgs boson decay to mu(+)mu(-) with the ATLAS detector. Phys. Lett. B, 738, 68–86.
Abstract: A search is reported for Higgs boson decay to mu(+)mu(-) using data with an integrated luminosity of 24.8 fb(-1) collected with the ATLAS detector in pp collisions at root s = 7 and 8 TeV at the CERN Large Hadron Collider. The observed dimuon invariant mass distribution is consistent with the Standard Model background-only hypothesis in the 120-150 GeV search range. For a Higgs boson with a mass of 125.5 GeV, the observed (expected) upper limit at the 95% confidence level is 7.0 (7.2) times the Standard Model expectation. This corresponds to an upper limit on the branching ratio BR(H -> mu(+)mu(-)) of 1.5 x10(-3).
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2014). Measurement of the cross section of high transverse momentum Z -> b(b)over-bar production in proton-proton collisions at root s=8 TeV with the ATLAS detector. Phys. Lett. B, 738, 25–43.
Abstract: This Letter reports the observation of a high transverse momentum Z -> b (b) over bar signal in proton-proton collisions at root s = 8TeVand the measurement of its production cross section. The data analysed were collected in 2012 with the ATLAS detector at the LHC and correspond to an integrated luminosity of 19.5 fb(-1). The Z -> b (b) over bar decay is reconstructed from a pair of b-tagged jets, clustered with the anti- k(t) jet algorithm with R = 0.4, that have low angular separation and form a dijet with p(T) > 200 GeV. The signal yield is extracted from a fit to the dijet invariant mass distribution, with the dominant, multi-jet background mass shape estimated by employing a fully data-driven technique that reduces the dependence of the analysis on simulation. The fiducial cross section is determined to be sigma(fid)(Z -> b (b) over bar) = 2.02 +/- 0.20 (stat.) +/- 0.25 (syst.) +/- 0.06 (lumi.) pb = 2.02 +/- 0.33 pb, in good agreement with next-to-leading-order theoretical predictions.
|
|
|
|
Ullan, M., Benitez, V., Quirion, D., Zabala, M., Pellegrini, G., Lozano, M., et al. (2014). Low-resistance strip sensors for beam-loss event protection. Nucl. Instrum. Methods Phys. Res. A, 765, 252–257.
Abstract: AC coupled silicon strip sensors can be damaged in case of a beam loss due to the possibility of a large charge accumulation in the bulk, developing very high voltages across the coupling capacitors which can destroy them. Punch-through structures are currently used to avoid this problem helping to evacuate the accumulated charge as large voltages are developing. Nevertheless, previous experiments, performed with laser pulses, have shown that these structures can become ineffective in relatively long strips. The large value of the implant resistance can effectively isolate the “far” end of the strip from the punchthrough structure leading to large voltages. We present here our developments to fabricate lowresistance strip sensors to avoid this problem. The deposition of a conducting material in contact with the implants drastically reduces the strip resistance, assuring the effectiveness of the punch-through structures. First devices have been fabricated with this new technology. Initial results with laser tests show the expected reduction in peak voltages on the low resistivity implants. Other aspects of the sensor performance, including the signal formation, are not affected by the new technology.
|
|
