Abstract: The observation of the decay Xi(-)(b)-> J/psi Lambda K- is reported, using a data sample corresponding to an integrated luminosity of 3 fb(-1), collected by the LHCb detector in pp collisions at centre-of-mass energies of 7 and 8 TeV. The production rate of Xi(-)(b) baryons detected in the decay Xi(-)(b) -> J/psi Lambda K- is measured relative to that of Lambda(0)(b) baryons using the decay Lambda(0)(b) -> J/psi Lambda. Integrated over the b-baryon transverse momentum p(T) < 25 GeV/c and rapidity 2.0 < y < 4.5, the measured ratio is f Xi(-)(b/) f Lambda(0)(b) B(Xi(-)(b)-> J/psi Lambda K-) / B(Lambda(0)(b)-> J/psi Lambda) = (4.19 +/- 0.29 (stat) +/- 0.15 (syst)) x 10(-2), where f(Xi)(b)(-) band f(Lambda)(b)(0)are the fragmentation fractions of b ->Xi(-)(b)and b ->Lambda(0)(b)transitions, and ss represents the branching fraction of the corresponding b- baryon decay. The mass difference between Xi(-)(b) and Lambda(0)(b) baryons is measured to be M(Xi(-)(b))-M(Lambda(0)(b)) = 177.08 +/- 0.47 (stat) +/- 0.16 (syst) MeV/c(2).

Abstract: A search is presented formassive long-lived particles decaying into a muon and two quarks. The dataset consists of proton-proton interactions at centre-of-mass energies of 7 and 8TeV, corresponding to integrated luminosities of 1 and 2fb(-1), respectively. The analysis is performed assuming a set of production mechanisms with simple topologies, including the production of a Higgs-like particle decaying into two long-lived particles. The mass range from 20 to 80GeV/c(2) and lifetimes from 5 to 100 ps are explored. Results are also interpreted in terms of neutralino production in different R-Parity violating supersymmetric models, with masses in the 23-198 GeV/c(2) range. No excess above the background expectation is observed and upper limits are set on the production cross-section for various points in the parameter space of theoretical models.

Abstract: A low-noise head amplifier has been developed for the extra low energy antiproton ring beam trajectory, orbit, and intensity measurement system at CERN. This system is based on 24 double-electrode electrostatic beam position monitors installed around the ring. A head amplifier is placed close to each beam position monitor to amplify the electrode signals and generate a difference and a sum signal. These signals are sent to the digital acquisition system, about 50 m away from the ring, where they are digitized and further processed. The beam position can be measured by dividing the difference signal by the sum signal while the sum signal gives information relative to the beam intensity. The head amplifier consists of two discrete charge preamplifiers with junction field effect transistor (JFET) inputs, a sum and a difference stage, and two cable drivers. Special attention has been paid to the amplifier printed circuit board design to minimize the parasitic capacitances and inductances at the charge amplifier stages to meet the gain and noise requirements. The measurements carried out on the head amplifier showed a gain of 40.5 and 46.5 dB for the sum and difference outputs with a bandwidth from 200 Hz to 75 MHz and an input voltage noise density lower than 400 pV/v Hz. Twenty head amplifiers have been already installed in the ring and they have been used to detect the first beam signals during the first commissioning stage in November 2016.