|
|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fernandez Martinez, P., et al. (2016). Performance of pile-up mitigation techniques for jets in pp collisions at root s=8 TeV using the ATLAS detector. Eur. Phys. J. C, 76(11), 581–36pp.
Abstract: The large rate of multiple simultaneous protonproton interactions, or pile-up, generated by the Large Hadron Collider in Run 1 required the development of many new techniques to mitigate the adverse effects of these conditions. This paper describes the methods employed in the ATLAS experiment to correct for the impact of pile-up on jet energy and jet shapes, and for the presence of spurious additional jets, with a primary focus on the large 20.3 fb(-1) data sample collected at a centre-of-mass energy of root s = 8 TeV. The energy correction techniques that incorporate sophisticated estimates of the average pile-up energy density and tracking information are presented. Jet-to-vertex association techniques are discussed and projections of performance for the future are considered. Lastly, the extension of these techniques to mitigate the effect of pile-up on jet shapes using subtraction and grooming procedures is presented.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fernandez Martinez, P., et al. (2016). A new method to distinguish hadronically decaying boosted Z bosons from W bosons using the ATLAS detector. Eur. Phys. J. C, 76(5), 238–33pp.
Abstract: The distribution of particles inside hadronic jets produced in the decay of boosted W and Z bosons can be used to discriminate such jets from the continuum background. Given that a jet has been identified as likely resulting from the hadronic decay of a boosted W or Z boson, this paper presents a technique for further differentiating Z bosons from W bosons. The variables used are jet mass, jet charge, and a b-tagging discriminant. A likelihood tagger is constructed from these variables and tested in the simulation of W' -> WZ for bosons in the transverse momentum range 200 GeV < p(T) < 400 GeV in root s = 8 TeV pp collisions with the ATLAS detector at the LHC. For Z-boson tagging efficiencies of epsilon(Z) = 90, 50, and 10 %, one can achieve W+-boson tagging rejection factors (1/epsilon(W+)) of 1.7, 8.3 and 1000, respectively. It is not possible to measure these efficiencies in the data due to the lack of a pure sample of high p(T), hadronically decaying Z bosons. However, the modelling of the tagger inputs for boosted W bosons is studied in data using a t (t) over bar -enriched sample of events in 20.3 fb(-1) of data at root s = 8 TeV. The inputs are well modelled within uncertainties, which builds confidence in the expected tagger performance.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fernandez Martinez, P., et al. (2016). Measurement of the CP-violating phase phi(s) and the B-s(0) meson decay width difference with B-s(0) -> J/psi phi decays in ATLAS. J. High Energy Phys., 08(8), 147–45pp.
Abstract: A measurement of the B-s(0) decay parameters in the B-s(0) -> J/psi/phi channel using an integrated luminosity of 14.3 fb(-1) collected by the ATLAS detector from 8TeV pp collisions at the LHC is presented. The measured parameters include the CP-violating phase phi(s), the decay width Gamma(s) and the width di ff erence between the mass eigenstates Delta Gamma(s). The values measured for the physical parameters are statistically combined with those from 4.9 fb-1 of 7TeV data, leading to the following: phi(s) = -0.090 +/- 0.078 (stat.) +/- 0.041 (syst.) rad Delta Gamma s = 0.085 +/- 0.011 (stat.) +/- 0.007 (syst.) ps(-1) Gamma(s) = 0.675 +/- 0.003 (stat.) +/- 0.003 (syst:) ps(-1). In the analysis the parameter Delta Gamma(s) is constrained to be positive. Results for phi(s) and Delta Gamma(s) are also presented as 68% and 95% likelihood contours in the phi(s)-Delta Gamma(s) plane. Also measured in this decay channel are the transversity amplitudes and corresponding strong phases. All measurements are in agreement with the Standard Model predictions.
|
|
|
|
ATLAS Tile Calorimeter System(Abdallah, J. et al), Ferrer, A., Fiorini, L., Hernandez Jimenez, Y., Higon-Rodriguez, E., Ruiz-Martinez, A., et al. (2016). The Laser calibration of the ATLAS Tile Calorimeter during the LHC run 1. J. Instrum., 11, T10005–29pp.
Abstract: This article describes the Laser calibration system of the ATLAS hadronic Tile Calorimeter that has been used during the run 1 of the LHC. First, the stability of the system associated readout electronics is studied. It is found to be stable with variations smaller than 0.6 %. Then, the method developed to compute the calibration constants, to correct for the variations of the gain of the calorimeter photomultipliers, is described. These constants were determined with a statistical uncertainty of 0.3 % and a systematic uncertainty of 0.2 % for the central part of the calorimeter and 0.5 % for the end-caps. Finally, the detection and correction of timing mis-configuration of the Tile Calorimeter using the Laser system are also presented.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fernandez Martinez, P., et al. (2015). ATLAS Run 1 searches for direct pair production of third-generation squarks at the Large Hadron Collider. Eur. Phys. J. C, 75(10), 510–48pp.
Abstract: This paper reviews and extends searches for the direct pair production of the scalar supersymmetric partners of the top and bottom quarks in proton-proton collisions collected by the ATLAS collaboration during the LHC Run 1. Most of the analyses use 20 fb(-1) of collisions at a centre-of-mass energy of root s = 8 TeV, although in some case an additional 4.7 fb(-1) of collision data at root s = 7 TeV are used. New analyses are introduced to improve the sensitivity to specific regions of the model parameter space. Since no evidence of third-generation squarks is found, exclusion limits are derived by combining several analyses and are presented in both a simplified model framework, assuming simple decay chains, as well as within the context of more elaborate phenomenological supersymmetric models.
|
|
