|
|
ANTARES Collaboration(Albert, A. et al), Alves, S., Calvo, D., Carretero, V., Gozzini, R., Hernandez-Rey, J. J., et al. (2022). Search for solar atmospheric neutrinos with the ANTARES neutrino telescope. J. Cosmol. Astropart. Phys., 06(6), 018–17pp.
Abstract: Solar Atmospheric Neutrinos (SA nu s) are produced by the interaction of cosmic rays with the solar medium. The detection of SA nu s would provide useful information on the composition of primary cosmic rays as well as the solar density. These neutrinos represent an irreducible source of background for indirect searches for dark matter towards the Sun and the measurement of their flux would allow for a better assessment of the uncertainties related to these searches. In this paper we report on the analysis performed, based on an unbinned likelihood maximisation, to search for SA nu s with the ANTARES neutrino telescope. After analysing the data collected over 11 years, no evidence for a solar atmospheric neutrino signal has been found. An upper limit at 90% confidence level on the flux of solar atmospheric neutrinos has been obtained, equal to 7x10(-11) [TeV-1 cm(-2) s(-1)] b at E-nu = 1 TeV for the reference cosmic ray model assumed.
|
|
|
|
Gololo, M. G. D., Carrio Argos, F., & Mellado, B. (2022). Tile Computer-on-Module for the ATLAS Tile Calorimeter Phase-II upgrades. J. Instrum., 17(6), P06020–14pp.
Abstract: The Tile PreProcessor (TilePPr) is the core element of the Tile Calorimeter (TileCal) off-detector electronics for High-luminosity Large Hadron Collider (HL-LHC). The TilePPr comprises FPGA-based boards to operate and read out the TileCal on-detector electronics. The Tile Computer on Module (TileCoM) mezzanine is embedded within TilePPr to carry out three main functionalities. These include remote configuration of on-detector electronics and TilePPr FPGAs, interface the TilePPr with the ATLAS Trigger and Data Acquisition (TDAQ) system, and interfacing the TilePPr with the ATLAS Detector Control System (DCS) by providing monitoring data. The TileCoM is a 10-layer board with a Zynq UltraScale+ ZU2CG for processing data, interface components to integrate with TilePPr and the power supply to be connected to the Advanced Telecommunication Computing Architecture carrier. A CentOS embedded Linux is deployed on the TileCoM to implement the required functionalities for the HL-LHC. In this paper we present the hardware and firmware developments of the TileCoM system in terms of remote programming, interface with ATLAS TDAQ system and DCS system.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Cardillo, F., et al. (2022). Observation of WWW Production in pp Collisions at p=13 TeV with the ATLAS Detector. Phys. Rev. Lett., 129(6), 061803–20pp.
Abstract: This Letter reports the observation of WWW production and a measurement of its cross section using detector at the Large Hadron Collider. Events with two same-sign leptons (electrons or muons) and at least two jets, as well as events with three charged leptons, are selected. A multivariate technique is then used to discriminate between signal and background events. Events from WWW production are observed with a significance of 8.0 standard deviations, where the expectation is 5.4 standard deviations. The inclusive WWW production cross section is measured to be 820 ± 100 (stat) ± 80 (syst) fb, approximately 2.6 standard deviations from the predicted cross section of 511 ± 18 fb calculated at next-to-leading-order QCD and leading-order electroweak accuracy.
|
|
|
|
Figueroa, D. G., Florio, A., Loayza, N., & Pieroni, M. (2022). Spectroscopy of particle couplings with gravitational waves. Phys. Rev. D, 106(6), 063522–8pp.
Abstract: We discuss the possibility to measure particle couplings with stochastic gravitational wave backgrounds (SGWBs). Under certain circumstances a sequence of peaks of different amplitude and frequency-a stairway-emerges in a SGWB spectrum, with each peak probing a different coupling. The detection of such signature opens the possibility to reconstruct couplings (spectroscopy) of particle species involved in high energy phenomena generating SGWBs. Stairwaylike signatures may arise in causally produced backgrounds in the early Universe, e.g., from preheating or first order phase transitions. As a proof of principle we study a preheating scenario with an inflaton 0 coupled to multiple daughter fields f chi jg with different coupling strengths. As a clear stairway signature is imprinted in the SGWB spectrum, we reconstruct the relevant couplings with various detectors.
|
|
|
|
Ferreiro, A., & Pla, S. (2022). Adiabatic regularization and preferred vacuum state for the lambda phi^4 field theory in cosmological spacetimes. Phys. Rev. D, 106(6), 065015–12pp.
Abstract: We extend the method of adiabatic regularization by introducing an arbitrary parameter μfor a scalar field with quartic self-coupling in a Friedmann-Lemaitre-Robertson-Walker spacetime at one-loop order. The subtraction terms constructed from this extended version allow us to define a preferred vacuum state at a fixed time ri 1/4 ri0 for this theory. We compute this vacuum state for two commonly used background fields in cosmology, specially in the context of preheating. We also give a possible prescription for an adequate value for mu.
|
|
