|
|
CDF Collaboration(Aaltonen, T. et al), & Cabrera, S. (2011). Measurement of the B- lifetime using a simulation free approach for trigger bias correction. Phys. Rev. D, 83(3), 032008–30pp.
Abstract: The collection of a large number of B-hadron decays to hadronic final states at the CDF II Detector is possible due to the presence of a trigger that selects events based on track impact parameters. However, the nature of the selection requirements of the trigger introduces a large bias in the observed proper-decay-time distribution. A lifetime measurement must correct for this bias, and the conventional approach has been to use a Monte Carlo simulation. The leading sources of systematic uncertainty in the conventional approach are due to differences between the data and the Monte Carlo simulation. In this paper, we present an analytic method for bias correction without using simulation, thereby removing any uncertainty due to the differences between data and simulation. This method is presented in the form of a measurement of the lifetime of the B- using the mode B- -> D-0 pi(-). The B- lifetime is measured as tau(-)(B) = 1.663 +/- 0.023 +/- 0.015 ps, where the first uncertainty is statistical and the second systematic. This new method results in a smaller systematic uncertainty in comparison to methods that use simulation to correct for the trigger bias.
|
|
|
|
BABAR Collaboration(del Amo Sanchez, P. et al), Azzolini, V., Lopez-March, N., Martinez-Vidal, F., Milanes, D. A., & Oyanguren, A. (2011). Study of B -> pi lv and B -> rho lv decays and determination of |Vub|. Phys. Rev. D, 83(3), 032007–45pp.
Abstract: We present an analysis of exclusive charmless semileptonic B-meson decays based on 377 x 10(6) B (B) over bar pairs recorded with the BABAR detector at the Y(4S) resonance. We select four event samples corresponding to the decay modes B-0 -> pi(-)l(+)v, B+ -> pi(0)l(+)v, B-0 -> rho(-)l(+)v, and B+ -> rho(0)l(+)v and find the measured branching fractions to be consistent with isospin symmetry. Assuming isospin symmetry, we combine the two B -> pi lv samples, and similarly the two B -> rho lv samples, and measure the branching fractions B(B-0 -> pi(-)l(+)v) = (1.41 +/- 0.05 +/- 0.07) x 10(-4) and B(B-0 -> rho(-)l(+)v) = (1.75 +/- 0.15 +/- 0.27) x 10(-4), where the errors are statistical and systematic. We compare the measured distribution in q(2), the momentum transfer squared, with predictions for the form factors from QCD calculations and determine the Cabibbo-Kobayashi-Maskawa matrix element vertical bar V-ub vertical bar. Based on the measured partial branching fraction for B -> pi lv in the range q(2) < 12 GeV2 and the most recent QCD light-cone sum-rule calculations, we obtain vertical bar V-ub vertical bar = (3.78 +/- 0.13(-0.40)(+0.55)10(-3), where the errors refer to the experimental and theoretical uncertainties. From a simultaneous fit to the data over the full q(2) range and the FNAL/MILC lattice QCD results, we obtain vertical bar V-ub vertical bar = (2.95 +/- 0.31) x 10(-3) from B -> pi lv, where the error is the combined experimental and theoretical uncertainty.
|
|
|
|
Blennow, M., Dasgupta, B., Fernandez-Martinez, E., & Rius, N. (2011). Aidnogenesis via leptogenesis and dark sphalerons. J. High Energy Phys., 03(3), 014–14pp.
Abstract: We discuss aidnogenesis,(1) i.e. the generation of a dark matter asymmetry, via new sphaleron processes associated to an extra non-abelian gauge symmetry common to both the visible and the dark sectors. Such a theory can naturally produce an abundance of asymmetric dark matter which is of the same size as the lepton and baryon asymmetries, as suggested by the similar sizes of the observed baryonic and dark matter energy content, and provide a definite prediction for the mass of the dark matter particle. We discuss in detail a minimal realization in which the Standard Model is only extended by dark matter fermions which form “dark baryons” through an SU(3) interaction, and a (broken) horizontal symmetry that induces the new sphalerons. The dark matter mass is predicted to be similar to 6GeV, close to the region favored by DAMA and CoGeNT. Furthermore, a remnant of the horizontal symmetry should be broken at a lower scale and can also explain the Tevatron dimuon anomaly.
|
|
|
|
BABAR Collaboration(del Amo Sanchez, P. et al), Lopez-March, N., Martinez-Vidal, F., Milanes, D. A., & Oyanguren, A. (2011). Studies of tau(-) -> eta K- nu(tau) and tau(-) -> eta pi(-) nu(tau) at BABAR and a search for a second-class current. Phys. Rev. D, 83(3), 032002–10pp.
Abstract: We report on analyses of tau lepton decays tau(-) -> eta K- nu(tau) and tau(-) -> eta pi(-) nu(tau), with eta -> pi(+) pi(-) pi(0), using 470 fb(-1) of data from the BABAR experiment at PEP-II, collected at center-of-mass energies at and near the Y(4S) resonance. We measure the branching fraction for the tau(-) -> eta K- nu(tau) decay mode, B(tau(-) -> eta K- nu(tau)) = (1.42 +/- 0.11(stat) +/- 0.07(syst)) x 10(-4), and report a 95% confidence level upper limit for the second-class current process tau(-) -> eta pi(-) nu(tau), B(tau(-) -> eta pi(-) nu(tau)) < 9.9 x 10(-5).
|
|
|
|
Das, S. P., & Drees, M. (2011). CP-violating supersymmetric Higgs boson at the Tevatron and LHC. Phys. Rev. D, 83(3), 035003–17pp.
Abstract: We analyze the prospect for observing the intermediate neutral Higgs boson (h(2))in its decay to two lighter Higgs bosons (h(1)) at the presently operating hadron colliders in the framework of the CP-violating minimal supersymmetric standard model using the PYTHIA event generator. We consider the lepton + 4-jets + E-T channel from associate Wh(2) production, with Wh(2) -> Wh(1)h(1) -> l -> l nu lb (b) over barb (b) over bar. We require two, three or four tagged b jets. We explicitly consider all relevant standard model backgrounds, treating c jets separately from light flavor and gluon jets and allowing for mistagging. We find that it is very hard to observe this signature at the Tevatron, even with 20 fb(-1) of data, in the LEP-allowed region of parameter space due to the small signal efficiency, even though the background is manageable. At the LHC, a priori huge standard model backgrounds can be suppressed by applying judiciously chosen kinematical selections. After all cuts, we are left with a signal cross section of around 0.5 fb, and a signal to background ratio between 1.2 and 2.9. According to our analysis this Higgs signal should be viable at the LHC in the vicinity of present LEP exclusion once 20 to 50 fb(-1) of data have been accumulated at root s = 14 TeV.
|
|
|
|
Nguyen, C. V., Gillam, J. E., Brown, J. M. C., Martin, D. V., Nikulin, D. A., & Dimmock, M. R. (2011). Towards Optimal Collimator Design for the PEDRO Hybrid Imaging System. IEEE Trans. Nucl. Sci., 58(3), 639–650.
Abstract: The Pixelated Emission Detector for RadiOisotopes (PEDRO) is a hybrid imaging system designed for the measurement of single photon emission from small animal models. The proof-of-principle device consists of a Compton-camera situated behind a mechanical collimator and is intended to provide optimal detection characteristics over a broad spectral range, from 30 to 511 keV. An automated routine has been developed for the optimization of large-area slits in the outer regions of a collimator which has a central region allocated for pinholes. The optimization was tested with a GEANT4 model of the experimental prototype. The data were blurred with the expected position and energy resolution parameters and a Bayesian interaction ordering algorithm was applied. Images were reconstructed using cone back-projection. The results show that the optimization technique allows the large-area slits to both sample fully and extend the primary field of view (FoV) determined by the pinholes. The slits were found to provide truncation of the back-projected cones of response and also an increase in the success rate of the interaction ordering algorithm. These factors resulted in an increase in the contrast and signal-to-noise ratio of the reconstructed image estimates. Of the two configurations tested, the cylindrical geometry outperformed the square geometry, primarily because of a decrease in artifacts. This was due to isotropic modulation of the cone surfaces, that can be achieved with a circular shape. Also, the cylindrical geometry provided increased sampling of the FoV due to more optimal positioning of the slits. The use of the cylindrical collimator and application of the transmission function in the reconstruction was found to improve the resolution of the system by a factor of 20, as compared to the uncollimated Compton camera. Although this system is designed for small animal imaging, the technique can be applied to any application of single photon imaging.
|
|
|
|
Miñano, M. (2011). Radiation Hard Silicon Strips Detectors for the SLHC. IEEE Trans. Nucl. Sci., 58(3), 1135–1140.
Abstract: While the Large Hadron Collider (LHC) began taking data in 2009, scenarios for a machine upgrade to achieve a much higher luminosity are being developed. In the current planning, it is foreseen to increase the luminosity of the LHC at CERN around 2018. As radiation damage scales with integrated luminosity, the particle physics experiments will need to be equipped with a new generation of radiation hard detectors. This article reports on the status of the R&D projects on radiation hard silicon strips detectors for particle physics, linked to the Large Hadron Collider Upgrade, super-LHC (sLHC) of the ATLAS microstrip detector. The primary focus of this report is on measuring the radiation hardness of the silicon materials and the detectors under study. This involves designing silicon detectors, irradiating them to the sLHC radiation levels and studying their performance as particle detectors. The most promising silicon detector for the different radiation levels in the different regions of the ATLAS microstrip detector will be presented. Important challenges related to engineering layout, powering, cooling and reading out a very large strip detector are presented. Ideas on possible schemes for the layout and support mechanics will be shown.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Amoros, G., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Escobar, C., et al. (2011). Measurement of the top quark-pair production cross section with ATLAS in pp collisions at sqrt(s)=7 TeV. Eur. Phys. J. C, 71(3), 1577–36pp.
Abstract: A measurement of the production cross-section for top quark pairs (t (t) over bar) in pp collisions at root s = 7 TeV is presented using data recorded with the ATLAS detector at the Large Hadron Collider. Events are selected in two different topologies: single lepton (electron e or muon mu) with large missing transverse energy and at least four jets, and dilepton (ee, μμor e mu) with large missing transverse energy and at least two jets. In a data sample of 2.9 pb(-1), 37 candidate events are observed in the single-lepton topology and 9 events in the dilepton topology. The corresponding expected backgrounds from non-t (t) over bar Standard Model processes are estimated using data-driven methods and determined to be 12.2 +/- 3.9 events and 2.5 +/- 0.6 events, respectively. The kinematic properties of the selected events are consistent with SM t (t) over bar production. The inclusive top quark pair production cross-section is measured to be sigma(t (t) over bar) = 145 +/- 31 (stat.)(-27)(+42) (syst.) pb. The measurement agrees with perturbative QCD calculations.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Amoros, G., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Escobar, C., et al. (2011). Studies of the performance of the ATLAS detector using cosmic-ray muons. Eur. Phys. J. C, 71(3), 1593–36pp.
Abstract: Muons from cosmic-ray interactions in the atmosphere provide a high-statistics source of particles that can be used to study the performance and calibration of the ATLAS detector. Cosmic-ray muons can penetrate to the cavern and deposit energy in all detector subsystems. Such events have played an important role in the commissioning of the detector since the start of the installation phase in 2005 and were particularly important for understanding the detector performance in the time prior to the arrival of the first LHC beams. Global cosmic-ray runs were undertaken in both 2008 and 2009 and these data have been used through to the early phases of collision data-taking as a tool for calibration, alignment and detector monitoring. These large datasets have also been used for detector performance studies, including investigations that rely on the combined performance of different subsystems. This paper presents the results of performance studies related to combined tracking, lepton identification and the reconstruction of jets and missing transverse energy. Results are compared to expectations based on a cosmic-ray event generator and a full simulation of the detector response.
|
|
|
|
Morisi, S., Peinado, E., Shimizu, Y., & Valle, J. W. F. (2011). Relating quarks and leptons without grand unification. Physical Review D, 84(3), 036003.
Abstract: In combination with supersymmetry, flavor symmetry may relate quarks with leptons, even in the absence of a grand-unification group. We propose an SU(3) x SU(2) x U(1) model where both supersymmetry and the assumed A(4) flavor symmetries are softly broken, reproducing well the observed fermion mass hierarchies and predicting: (i) a relation between down-type quarks and charged lepton masses, and (ii) a correlation between the Cabibbo angle in the quark sector and the reactor angle theta(13) characterizing CP violation in neutrino oscillations.
|
|
