ATLAS Collaboration(Aad, G. et al), Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Castillo, F. L., Castillo Gimenez, V., et al. (2020). Measurement of azimuthal anisotropy of muons from charm and bottom hadrons Pb plus Pb collisions at root s(NN)=5.02 TeV with the ATLAS detector. Phys. Lett. B, 807, 135595–23pp.
Abstract: Azimuthal anisotropies of muons from charm and bottom hadron decays are measured in Pb+Pb collisions at root s(NN) = 5.02 TeV. The data were collected with the ATLAS detector at the Large Hadron Collider in 2015 and 2018 with integrated luminosities of 0.5 nb(-1) and 1.4 nb(-1), respectively. The kinematic selection for heavy-flavor muons requires transverse momentum 4 < p(T) < 30 GeV and pseudorapidity vertical bar eta vertical bar < 2.0. The dominant sources of muons in this p -r range are semi-leptonic decays of charm and bottom hadrons. These heavy-flavor muons are separated from light-hadron decay muons and punch-through hadrons using the momentum imbalance between the measurements in the tracking detector and in the muon spectrometers. Azimuthal anisotropies, quantified by flow coefficients, are measured via the eventplane method for inclusive heavy-flavor muons as a function of the muon p(T) and in intervals of Pb+Pb collision centrality. Heavy-flavor muons are separated into contributions from charm and bottom hadron decays using the muon transverse impact parameter with respect to the event primary vertex. Non-zero elliptic (v(2)) and triangular (v(3)) flow coefficients are extracted for charm and bottom muons, with the charm muon coefficients larger than those for bottom muons for all Pb+Pb collision centralities. The results indicate substantial modification to the charm and bottom quark angular distributions through interactions in the quark-gluon plasma produced in these Pb+Pb collisions, with smaller modifications for the bottom quarks as expected theoretically due to their larger mass.
|
Ruhr, F. et al, Escobar, C., & Miñano, M. (2020). Testbeam studies of barrel and end-cap modules for the ATLAS ITk strip detector before and after irradiation. Nucl. Instrum. Methods Phys. Res. A, 979, 164430–6pp.
Abstract: In order to cope with the occupancy and radiation doses expected at the High-Luminosity LHC, the ATLAS experiment will replace its Inner Detector with an all-silicon Inner Tracker (ITk), consisting of pixel and strip subsystems. In the last two years, several prototype ITk strip modules have been tested using beams of high energy electrons produced at the DESY-II testbeam facility. Tracking was provided by EUDET telescopes. The modules tested are built from two sensor types: the rectangular ATLAS17LS, which will be used in the outer layers of the central barrel region of the detector, and the annular ATLAS12EC, which will be used in the innermost ring (R0) of the forward region. Additionally, a structure with two RO modules positioned back-to-back has been measured, demonstrating space point reconstruction using the stereo angle of the strips. Finally, one barrel and one RO module have been measured after irradiation to 40% beyond the expected end-of-lifetime fluence. The data obtained allow for thorough tests of the module performance, including charge collection, noise occupancy, detection efficiency, and tracking performance. The results give confidence that the ITk strip detector will meet the requirements of the ATLAS experiment.
|
ATLAS Collaboration(Aad, G. et al), Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Castillo, F. L., Castillo Gimenez, V., et al. (2020). Measurement of the t(t)over-bar production cross-section in the lepton plus jets channel at root s=13 TeV with the ATLAS experiment. Phys. Lett. B, 810, 135797–22pp.
Abstract: The top anti-top quark production cross-section is measured in the lepton+jets channel using proton-proton collision data at a centre-of-mass energy of root s = 13 TeV collected with the ATLAS detector at the LHC. The dataset corresponds to an integrated luminosity of 139 fb(-1). Events with exactly one charged lepton and four or more jets in the final state, with at least one jet containing b-hadrons, are used to determine the a production cross-section through a profile-likelihood t (t) over bar. The inclusive cross-section is measured to be alpha(inc) = 830 +/- 0.4 (stat.) +/- 36 (syst.) +/- 14 (lumi.) pb with a relative uncertainty of 4.6%. The result is consistent with theoretical calculations at next-to-next-to-leading order in perturbative QCD. The fiducial t (t) over bar cross-section within the experimental acceptance is also measured.
|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Aparisi Pozo, J. A., Bailey, A. J., Barranco Navarro, L., Cabrera Urban, S., et al. (2020). A search for the Z gamma decay mode of the Higgs boson in pp collisions at root s=13 TeV with the ATLAS detector. Phys. Lett. B, 809, 135754–21pp.
Abstract: A search for the Z gamma decay of the Higgs boson, with Z boson decays into pairs of electrons or muons is presented. The analysis uses proton-proton collision data at root s = 13 TeV corresponding to an integrated luminosity of 139 fb(-1) recorded by the ATLAS detector at the Large Hadron Collider. The observed data are consistent with the expected background with a p-value of 1.3%. An upper limit at 95% confidence level on the production cross-section times the branching ratio for pp -> H -> Z gamma is set at 3.6 times the Standard Model prediction while 2.6 times is expected in the presence of the Standard Model Higgs boson. The best-fit value for the signal yield normalised to the Standard Model prediction is 2.0(-0.9)(+1.0) where the statistical component of the uncertainty is dominant.
|
Hara, K. et al, Escobar, C., Garcia, C., Lacasta, C., Miñano, M., & Soldevila, U. (2020). Charge collection study with the ATLAS ITk prototype silicon strip sensors ATLAS17LS. Nucl. Instrum. Methods Phys. Res. A, 983, 164422–6pp.
Abstract: The inner tracker of the ATLAS detector is scheduled to be replaced by a completely new silicon-based inner tracker (ITk) for the Phase-II of the CERN LHC (HL-LHC). The silicon strip detector covers the volume 40 < R < 100 cm in the radial and vertical bar z vertical bar <300 cm in the longitudinal directions. The silicon sensors for the detector will be fabricated using the n(+)-on-p 6-inch wafer technology, for a total of 22,000 wafers. Intensive studies were carried out on the final prototype sensors ATLAS17LS fabricated by Hamamatsu Photonics (HPK). The charge collection properties were examined using penetrating Sr-90 beta-rays and the ALIBAVA fast readout system for the miniature sensors of 1 cm xl cm in area. The samples were irradiated by protons in the 27 MeV Birmingham Cyclotron, the 70 MeV CYRIC at Tohoku University, and the 24 GeV CERN-PS, and by neutrons at Ljubljana TAIGA reactor for fluence values up to 2 x 10(15) n(eq)/cm(2). The change in the charge collection with fluence was found to be similar to the previous prototype ATLAS12, and acceptable for the ITk. Sensors with two active thicknesses, 300 μm (standard) and 240 μm (thin), were compared and the difference in the charge collection was observed to be small for bias voltages up to 500 V. Some samples were also irradiated with gamma radiation up to 2 MGy, and the full depletion voltage was found to decrease with the dose. This was caused by the Compton electrons due to the( 60)Co gamma radiation. To summarize, the design of the ATLAS17LS and technology for its fabrication have been verified for implementation in the ITk. We are in the stage of sensor pre-production with the first sensors already delivered in January of 2020.
|
