ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Aparisi Pozo, J. A., Bailey, A. J., Barranco Navarro, L., Cabrera Urban, S., et al. (2019). Dijet azimuthal correlations and conditional yields in pp and p plus Pb collisions at root S-NN=5.02 TeV with the ATLAS detector. Phys. Rev. C, 100(3), 034903–24pp.
Abstract: This paper presents a measurement of forward-forward and forward-central dijet azimuthal angular correlations and conditional yields in proton-proton (pp) and proton-lead (p + Pb) collisions as a probe of the nuclear gluon density in regions where the fraction of the average momentum per nucleon carried by the parton entering the hard scattering is low. In these regions, gluon saturation can modify the rapidly increasing parton distribution function of the gluon. The analysis utilizes 25 pb(-1) of pp data and 360 μb(-1) of p + Pb data, both at root S-NN = 5.02 TeV, collected in 2015 and 2016, respectively, with the ATLAS detector at the Large Hadron Collider. The measurement is performed in the center-of-mass frame of the nucleon-nucleon system in the rapidity range between -4.0 and 4.0 using the two highest transverse-momentum jets in each event, with the highest transverse-momentum jet restricted to the forward rapidity range. No significant broadening of azimuthal angular correlations is observed for forward-forward or forward-central dijets in p + Pb compared to pp collisions. For forward-forward jet pairs in the proton-going direction, the ratio of conditional yields in p + Pb collisions to those in pp collisions is suppressed by approximately 20%, with no significant dependence on the transverse momentum of the dijet system. No modification of conditional yields is observed for forward-central dijets.
|
ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Castillo, F. L., et al. (2019). Measurement of angular and momentum distributions of charged particles within and around jets in Pb plus Pb and pp collisions at root s(NN)=5.02 TeV with the ATLAS detector. Phys. Rev. C, 100(6), 064901–29pp.
Abstract: Studies of the fragmentation of jets into charged particles in heavy-ion collisions can provide information about the mechanism of jet quenching by the hot and dense QCD matter created in such collisions, the quark-gluon plasma. This paper presents a measurement of the angular distribution of charged particles around the jet axis in root s(NN) = 5.02 TeV Pb + Pb and pp collisions, using the ATLAS detector at the LHC. The Pb + Pb and pp data sets have integrated luminosities of 0.49 nb(-1) and 25 pb(-1), respectively. The measurement is performed for jets reconstructed with the anti-k(t) algorithm with radius parameter R = 0.4 and is extended to an angular distance of r = 0.8 from the jet axis. Results are presented as a function of Pb + Pb collision centrality and distance from the jet axis for charged particles with transverse momenta in the 1- to 63-GeV range, matched to jets with transverse momenta in the 126- to 316-GeV range and an absolute value of jet rapidity of less than 1.7. Modifications to the measured distributions are quantified by taking a ratio to the measurements in pp collisions. Yields of charged particles with transverse momenta below 4 GeV are observed to be increasingly enhanced as a function of angular distance from the jet axis, reaching a maximum at r = 0.6. Charged particles with transverse momenta above 4 GeV have an enhanced yield in Pb + Pb collisions in the jet core for angular distances up to r = 0.05 from the jet axis, with a suppression at larger distances.
|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Castillo, F. L., et al. (2020). Measurement of the azimuthal anisotropy of charged-particle production in Xe plus Xe collisions at root S-NN=5.44 TeV with the ATLAS detector. Phys. Rev. C, 101(2), 024906–35pp.
Abstract: This paper describes the measurements of flow harmonics v(2)-v(6) in 3 μb(-1) of Xe Xe collisions at root S-NN = 5.44 TeV performed using the ATLAS detector at the Large Hadron Collider (LHC). Measurements of the centrality, multiplicity, and p(T) dependence of the v(n) obtained using two-particle correlations and the scalar product technique are presented. The measurements are also performed using a template-fit procedure, which was developed to remove nonflow correlations in small collision systems. This nonflow removal is shown to have a significant influence on the measured v(n) at high p(T), especially in peripheral events. Comparisons of the measured v(n) with measurements in Pb + Pb collisions and p + Pb collisions at root S-NN = 5.02 TeV are also presented. The v(n) values in Xe + Xe collisions are observed to be larger than those in Pb + Pb collisions for n = 2, 3, and 4 in the most central events. However, with decreasing centrality or increasing harmonic order n, the v(n) values in Xe + Xe collisions become smaller than those in Pb + Pb collisions. The v(n) in Xe + Xe and Pb + Pb collisions are also compared as a function of the mean number of participating nucleons, < N-part >, and the measured charged-particle multiplicity in the detector. The v(3) values in Xe + Xe and Pb + Pb collisions are observed to be similar at the same < N-part > or multiplicity, but the other harmonics are significantly different. The ratios of the measured v(n) in Xe + Xe and Pb + Pb collisions, as a function of centrality, are also compared to theoretical calculations.
|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fernandez Martinez, P., et al. (2015). Modelling Z -> ττ processes in ATLAS with τ-embedded Z -> μμ data. J. Instrum., 10, P09018–41pp.
Abstract: This paper describes the concept, technical realisation and validation of a largely data-driven method to model events with Z -> tau tau decays. In Z -> μμevents selected from proton-proton collision data recorded at root s = 8 TeV with the ATLAS experiment at the LHC in 2012, the Z decay muons are replaced by tau leptons from simulated Z -> tau tau decays at the level of reconstructed tracks and calorimeter cells. The tau lepton kinematics are derived from the kinematics of the original muons. Thus, only the well-understood decays of the Z boson and tau leptons as well as the detector response to the tau decay products are obtained from simulation. All other aspects of the event, such as the Z boson and jet kinematics as well as effects from multiple interactions, are given by the actual data. This so-called tau-embedding method is particularly relevant for Higgs boson searches and analyses in tau tau final states, where Z -> tau tau decays constitute a large irreducible background that cannot be obtained directly from data control samples. In this paper, the relevant concepts are discussed based on the implementation used in the ATLAS Standard Model H -> tau tau analysis of the full datataset recorded during 2011 and 2012.
|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fernandez Martinez, P., et al. (2016). Performance of b-jet identification in the ATLAS experiment. J. Instrum., 11, P04008–126pp.
Abstract: The identification of jets containing b hadrons is important for the physics programme of the ATLAS experiment at the Large Hadron Collider. Several algorithms to identify jets containing b hadrons are described, ranging from those based on the reconstruction of an inclusive secondary vertex or the presence of tracks with large impact parameters to combined tagging algorithms making use of multi-variate discriminants. An independent b-tagging algorithm based on the reconstruction of muons inside jets as well as the b-tagging algorithm used in the online trigger are also presented. The b-jet tagging efficiency, the c-jet tagging efficiency and the mistag rate for light flavour jets in data have been measured with a number of complementary methods. The calibration results are presented as scale factors defined as the ratio of the efficiency (or mistag rate) in data to that in simulation. In the case of b jets, where more than one calibration method exists, the results from the various analyses have been combined taking into account the statistical correlation as well as the correlation of the sources of systematic uncertainty.
|