|
LHCb Collaboration(Aaij, R. et al), Jaimes Elles, S. J., Jashal, B. K., Martinez-Vidal, F., Oyanguren, A., Rebollo De Miguel, M., et al. (2024). A search for rare B → D μ+ μ- decays. J. High Energy Phys., 02(2), 032–23pp.
Abstract: A search for rare B. D mu+ mu- decays is performed using proton-proton collision data collected by the LHCb experiment, corresponding to an integrated luminosity of 9 fb-1. No significant signals are observed in the non-resonant mu+ mu- modes, and upper limits of B -> B0. D0 mu+ mu- < 5.1 x 10-8, B B+. D+ s mu+ mu- -> < 3.2 x 10-8, B -> B0 s. D0 mu+ mu--> < 1.6 x 10-7 and fc/fu center dot B B+ c. D+ s mu+ mu--> < 9.6 x 10-8 are set at the 95% confidence level, where fc and fu are the fragmentation fractions of a B meson with a c and u quark respectively in proton-proton collisions. Each result is either the first such measurement or an improvement by three orders of magnitude on an existing limit. Separate upper limits are calculated when the muon pair originates from a J/.. mu+ mu- decay. The branching fraction of B+ c. D+ s J/. multiplied by the fragmentation-fraction ratio is measured to be fc fu center dot B -> B+ c. D+ s J/.-> = (1.63 +/- 0.15 +/- 0.13) x 10-5, where the first uncertainty is statistical and the second systematic.
|
|
|
Hirsch, M., Kernreiter, T., Romao, J. C., & del Moral, A. V. (2010). Minimal supersymmetric inverse seesaw: neutrino masses, lepton flavour violation and LHC phenomenology. J. High Energy Phys., 01(1), 103–21pp.
Abstract: We study neutrino masses in the framework of the supersymmetric inverse seesaw model. Different from the non-supersymmetric version a minimal realization with just one pair of singlets is sufficient to explain all neutrino data. We compute the neutrino mass matrix up to 1-loop order and show how neutrino data can be described in terms of the model parameters. We then calculate rates for lepton flavour violating (LFV) processes, such as μ-> e gamma and chargino decays to singlet scalar neutrinos. The latter decays are potentially observable at the LHC and show a characteristic decay pattern dictated by the same parameters which generate the observed large neutrino angles.
|
|
|
Li, X. Q., Yang, Y. D., & Yuan, X. B. (2012). Anomalous tqZ coupling effects in rare B- and K-meson decays. J. High Energy Phys., 03(3), 018–22pp.
Abstract: As a top-factory, the LHC is performing a direct study of top-quark anomalous FCNC couplings, which are, however, correlated closely with the rare B- and K-meson decays. In this paper, we study the effects of anomalous tqZ (with q = u, c) couplings in the rare decays B-s,B-d -> mu(+)mu(-), B -> X-s nu(nu) over bar, B -> K(*)nu(nu) over bar, K+ -> pi(+)nu(nu) over bar, and K-L -> pi(0)nu(nu) over bar. With the up-to-date experimental bounds on the branching ratios of these channels, constraints on the left-handed anomalous couplings X-ct(L), and X-ut(L) are derived, respectively. With these low-energy constraints taken into account, we find that, for real couplings X-ct(L) and X-ut(L), the indirect upper bounds on B(t -> qZ) are much lower than that from the D0 collaboration, but are still compatible with the 5 sigma discovery potential of ATLAS with an integrated luminosity of 10 fb(-1). With refined measurements to be available at the LHCb, the future super-B factories, the NA62 at CERN, and the KOTO at J-PARC, closer correlations between the t -> qZ and the rare B- and K-meson decays are expected in the near future, which will be helpful for the searches of thu e top-quark FCNC decays at the LHC.
|
|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Ferrer, A., Fiorini, L., et al. (2012). A search for flavour changing neutral currents in top-quark decays in pp collision data collected with the ATLAS detector at root s=7 TeV. J. High Energy Phys., 09(9), 139–37pp.
Abstract: A search for flavour changing neutral current (FCNC) processes in top-quark decays by the ATLAS Collaboration is presented. Data collected from pp collisions at the LHC at a centre-of-mass energy of root s = 7 TeV during 2011, corresponding to an integrated luminosity of 2.1 fb(-1), were used. A search was performed for top-quark pair-production events, with one top quark decaying through the t -> Zq FCNC (q = u, c) channel, and the other through the Standard Model dominant mode t -> Wb. Only the decays of the Z boson to charged leptons and leptonic W-boson decays were considered as signal. Consequently, the final-state topology is characterised by the presence of three isolated charged leptons, at least two jets and missing transverse momentum from the undetected neutrino. No evidence for an FCNC signal was found. An upper limit on the t -> Zq branching ratio of BR(t -> Zq) < 0.73% is set at the 95% confidence level.
|
|
|
Hirsch, M., Joaquim, F. R., & Vicente, A. (2012). Constrained SUSY seesaws with a 125 GeV Higgs. J. High Energy Phys., 11(11), 105–33pp.
Abstract: Motivated by the ATLAS and CMS discovery of a Higgs-like boson with a mass around 125 GeV, and by the need of explaining neutrino masses, we analyse the three canonical SUSY versions of the seesaw mechanism (type I, II and III) with CMSSM boundary conditions. In type II and III cases, SUSY particles are lighter than in the CMSSM (or the constrained type I seesaw), for the same set of input parameters at the universality scale. Thus, to explain m(h0) similar or equal to 125 GeV at low energies, one is forced into regions of parameter space with very large values of m(0), M-1/2 or A(0). We compare the squark and gluino masses allowed by the ATLAS and CMS ranges for m(h0) (extracted from the 2011-2012 data), and discuss the possibility of distinguishing seesaw models in view of future results on SUSY searches. In particular, we briefly comment on the discovery potential of LHC upgrades, for squark/gluino mass ranges required by present Higgs mass constraints. A discrimination between different seesaw models cannot rely on the Higgs mass data alone, therefore we also take into account the MEG upper limit on BR(mu -> e gamma) and show that, in some cases, this may help to restrict the SUSY parameter space, as well as to set complementary limits on the seesaw scale.
|
|