|
|
ATLAS Collaboration(Aad, G. et al), Amoros, G., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Escobar, C., et al. (2011). Search for massive long-lived highly ionising particles with the ATLAS detector at the LHC. Phys. Lett. B, 698(5), 353–370.
Abstract: A search is made for massive highly ionising particles with lifetimes in excess of 100 ns, with the ATLAS experiment at the Large Hadron Collider, using 3.1 pb(-1) of pp collision data taken at root s = 7 TeV. The signature of energy loss in the ATLAS inner detector and electromagnetic calorimeter is used. No such particles are found and limits on the production cross section for electric charges 6e <= vertical bar q vertical bar <= 17e and masses 200 GeV <= m <= 1000 GeV are set in the range 1-12 pb for different hypotheses on the production mechanism.
|
|
|
|
Agarwalla, S. K., Huber, P., Tang, J. A., & Winter, W. (2011). Optimization of the Neutrino Factory, revisited. J. High Energy Phys., 01(1), 120–45pp.
Abstract: We perform the baseline and energy optimization of the Neutrino Factory including the latest simulation results on the magnetized iron detector (MIND). We also consider the impact of tau decays, generated by v(mu) -> v(tau) or v(e) -> v(tau) appearance, on the mass hierarchy, CP violation, and theta(13) discovery reaches, which we find to be negligible for the considered detector. For the baseline-energy optimization for small sin(2) 2 theta(13), we qualitatively recover the results with earlier simulations of the MIND detector. We find optimal baselines of about 2 500km to 5 000km for the CP violation measurement, where now values of E-mu as low as about 12 GeV may be possible. However, for large sin(2) 2 theta(13), we demonstrate that the lower threshold and the backgrounds reconstructed at lower energies allow in fact for muon energies as low as 5 GeV at considerably shorter baselines, such as FNAL-Homestake. This implies that with the latest MIND analysis, low-and high-energy versions of the Neutrino Factory are just two different versions of the same experiment optimized for different parts of the parameter space. Apart from a green-field study of the updated detector performance, we discuss specific implementations for the two-baseline Neutrino Factory, where the considered detector sites are taken to be currently discussed underground laboratories. We find that reasonable setups can be found for the Neutrino Factory source in Asia, Europe, and North America, and that a triangular-shaped storage ring is possible in all cases based on geometrical arguments only.
|
|
|
|
Jido, D., Oset, E., & Sekihara, T. (2011). Kaon-induced Lambda(1405) production on a deuteron target at DAFNE. Eur. Phys. J. A, 47(3), 42–7pp.
Abstract: The K-- induced production of.(1405) in the K(-)d -> pi Sigma n reaction is investigated having in mind the conditions of the DAFNE facility at Frascati where kaons are obtained from the decay of slow-moving phi mesons. We find that the K(-)d -> Lambda(1405)n process favors the production of Lambda(1405) initiated by the K(-)p channel, which gives largest weight to the higher mass Lambda(1405) appearing at 1420MeV in chiral theories. We find that the fastest kaons from the decay of the phi are well suited to see this resonance, particularly if one selects forward going neutrons in the center of mass, which reduce the contribution of single scattering and make the double scattering dominate where the signal of the resonance appears clearer.
|
|
|
|
Li, X. Q., Su, F., & Yang, Y. D. (2011). Determination of the strong coupling gB*B pi from semileptonic B -> pi l nu decay. Phys. Rev. D, 83(5), 054019–8pp.
Abstract: According to heavy-meson chiral perturbation theory, the vector form factor f+(q(2)) of exclusive semileptonic decay B -> pi l nu is closely related, at least in the soft-pion region ( i.e., q(2) similar to (m(B) – m(pi))(2)), to the strong coupling g(B*B pi) or the normalized coupling (g)over-cap. Combining the precisely measured q2 spectrum of B -> pi l nu decay by the BABAR and Belle collaborations with several parametrizations of the form factor f +(q(2)), we can extract these couplings from the residue of the form factor at the B* pole, which relies on an extrapolation of the form factor from the semileptonic region to the unphysical point q(2) = m(B*)(2). Comparing the extracted values with the other experimental and theoretical estimates, we can test these various form-factor parametrizations, which differ from each other by the amount of physical information embedded in. It is found that the extracted values based on the Becirevic-Kaidalov, Ball-Zwicky and Bourrely-Caprini-Lellouch parametrizations are consistent with each other and roughly in agreement with the other theoretical and lattice estimates, while the Boyd-Grinstein-Lebed ansatz, featured by a spurious, unwanted pole at the threshold of the cut, gives a neatly larger value.
|
|
|
|
Binosi, D., & Papavassiliou, J. (2011). Gauge invariant Ansatz for a special three-gluon vertex. J. High Energy Phys., 03(3), 121–23pp.
Abstract: We construct a general Ansatz for the three-particle vertex describing the interaction of one background and two quantum gluons, by simultaneously solving the Ward and Slavnov-Taylor identities it satisfies. This vertex is known to be essential for the gauge-invariant truncation of the Schwinger-Dyson equations of QCD, based on the pinch technique and the background field method. A key step in this construction is the formal derivation of a set of crucial constraints (shown to be valid to all orders), relating the various form factors of the ghost Green's functions appearing in the aforementioned Slavnov-Taylor identity. When inserted into the Schwinger-Dyson equation for the gluon propagator, this vertex gives rise to a number of highly non-trivial cancellations, which are absolutely indispensable for the self-consistency of the entire approach.
|
|
