LHCb Collaboration(Aaij, R. et al), Jaimes Elles, S. J., Jashal, B. K., Martinez-Vidal, F., Oyanguren, A., Rebollo De Miguel, M., et al. (2023). Observation of New Baryons in the Ξb- π+π- and Ξb0π+π- Systems. Phys. Rev. Lett., 131(17), 171901–11pp.
Abstract: The first observation and study of two new baryonic structures in the final state Xi(0)(b)pi(+)pi(-) and the confirmation of the Xi(b)(6100)(-) state in the Xi(-)(b)pi(+)pi(-) decay mode are reported using proton-proton collision data collected by the LHCb experiment, corresponding to an integrated luminosity of 9 fb(-1). In addition, the properties of the known Xi(b)*(0), Xi(b)'(-) and Xi(b)*(-) resonances are measured with improved precision. The new decay mode of the Xi(0)(b) baryon to the Xi(+)(c) pi(-) pi(+) pi(-) final state is observed and exploited for the first time in these measurements.
|
LHCb Collaboration(Aaij, R. et al), Jaimes Elles, S. J., Jashal, B. K., Martinez-Vidal, F., Oyanguren, A., Rebollo De Miguel, M., et al. (2023). Precision Measurement of CP Violation in the Penguin-Mediated Decay B0s → φφ. Phys. Rev. Lett., 131(17), 171802–12pp.
Abstract: A flavor-tagged time-dependent angular analysis of the decay B0s -> phi phi is performed using pp collision integrated luminosity of 6 fb-1. The CP-violating phase and direct CP-violation parameter are measured to s = -0.042 +/- 0.075 +/- 0.009 rad and l lambda l = 1.004 +/- 0.030 +/- 0.009, respectively, assuming the same values for all polarization states of the phi phi system. In these results, the first uncertainties are statistical and the second systematic. These parameters are also determined separately for each polarization state, showing no evidence for polarization dependence. The results are combined with previous LHCb measurements using pp collisions at center-of-mass energies of 7 and 8 TeV, yielding phi sss over bar s = -0.074 +/- 0.069 rad and l lambda l = 1.009 +/- 0.030. This is the most precise study of time-dependent CP violation in a penguindominated B meson decay. The results are consistent with CP symmetry and with the standard model predictions.
|
Garcia Soto, A., Zhelnin, P., Safa, I., & Arguelles, C. A. (2022). Tau Appearance from High-Energy Neutrino Interactions. Phys. Rev. Lett., 128(17), 171101–7pp.
Abstract: High-energy muon and electron neutrinos yield a non-negligible flux of tau neutrinos as they propagate through Earth. In this Letter, we address the impact of this additional component in the PeV and EeV energy regimes for the first time. Above 300 TeV, this contribution is predicted to be significantly larger than the atmospheric background, and it alters current and future neutrino telescopes' capabilities to discover a cosmic tau-neutrino flux. Further, we demonstrate that Earth-skimming neutrino experiments, designed to observe tau neutrinos, will be sensitive to cosmogenic neutrinos even in extreme scenarios without a primary tau-neutrino component.
|
Miyagawa, P. S. et al, Bernabeu, P., Lacasta, C., Solaz, C., & Soldevila, U. (2024). Analysis of the results from Quality Control tests performed on ATLAS18 Strip Sensors during on-going production. Nucl. Instrum. Methods Phys. Res. A, 1064, 169457–9pp.
Abstract: The ATLAS experiment will replace its existing Inner Detector with the new all -silicon Inner Tracker (ITk) to cope with the operating conditions of the forthcoming high -luminosity phase of the LHC (HL-LHC). The outer regions of the ITk will be instrumented with similar to 18000 ATLAS18 strip sensors fabricated by Hamamatsu Photonics K.K. (HPK). With the launch of full-scale sensor production in 2021, the ITk strip sensor community has undertaken quality control (QC) testing of these sensors to ensure compliance with mechanical and electrical specifications agreed with HPK. The testing is conducted at seven QC sites on each of the monthly deliveries of similar to 500 sensors. This contribution will give an overview of the QC procedures and analysis; the tests most likely to determine pass/fail for a sensor are IV, long-term leakage current stability, full strip test and visual inspection. The contribution will then present trends in the results and properties following completion of similar to 60% of production testing. It will also mention challenges overcome through collaborative efforts with HPK during the early phases of production. With less than 5% of sensors rejected by QC testing, the overall production quality has been very good.
|
Andreev, Y. M. et al, Molina Bueno, L., & Tuzi, M. (2023). Measurement of the intrinsic hadronic contamination in the NA64-e high-purity e+/e- beam at CERN. Nucl. Instrum. Methods Phys. Res. A, 1057, 168776–8pp.
Abstract: We present the measurement of the intrinsic hadronic contamination at the CERN SPS H4 beamline configured to transport electrons and positrons at 100 GeV/c. The analysis, performed using data collected by the NA64-e experiment in 2022, is based on calorimetric measurements, exploiting the different interaction mechanisms of electrons and hadrons in the NA64 detector. We determined the contamination by comparing the results obtained using the nominal electron/positron beamline configuration with those from a dedicated setup, in which only hadrons impinged on the detector. We also obtained an estimate of the relative protons, antiprotons and pions yield by exploiting the different absorption probabilities of these particles in matter. We cross-checked our results with a dedicated Monte Carlo simulation for the hadron production at the primary T2 target, finding a good agreement with the experimental measurements.
|
