ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Cardillo, F., et al. (2022). Direct constraint on the Higgs-charm coupling from a search for Higgs boson decays into charm quarks with the ATLAS detector. Eur. Phys. J. C, 82(8), 717–42pp.
Abstract: A search for the Higgs boson decaying into a pair of charm quarks is presented. The analysis uses proton- proton collisions to target the production of a Higgs boson in association with a leptonically decaying W or Z boson. The dataset delivered by the LHC at a centre-of-mass energy of root s = 13 TeV and recorded by the ATLAS detector corresponds to an integrated luminosity of 139 fb(-1). Flavour-tagging algorithms are used to identify jets originating from the hadronisation of charm quarks. The analysis method is validated with the simultaneous measurement of WW, WZ and ZZ production, with observed (expected) significances of 2.6 (2.2) standard deviations above the background-only prediction for the (W/Z)Z(-> c (c) over bar) process and 3.8 (4.6) standard deviations for the (W/Z)W(-> cq) process. The (WIZ)H(-> c (c) over bar) search yields an observed (expected) upper limit of 26 (31) times the predicted Standard Model crosssection times branching fraction for a Higgs boson with a mass of 125 GeV, corresponding to an observed (expected) constraint on the charm Yukawa coupling modifier vertical bar k(c)vertical bar < 8.5 (12.4), at the 95% confidence level. A combination with the ATLAS (W/Z)H, H -> b<(b)over bar> analysis is performed, allowing the ratio k(c)/k(b) to be constrained to less than 4.5 at the 95% confidence level, smaller than the ratio of the b- and c-quark masses, and therefore determines the Higgs-charm coupling to be weaker than the Higgs-bottom coupling at the 95% confidence level.
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., Cabrera Urban, S., et al. (2023). Studies of the muon momentum calibration and performance of the ATLAS detector with pp collisions at √s=13 TeV. Eur. Phys. J. C, 83(8), 686–37pp.
Abstract: This paper presents the muon momentum calibration and performance studies for the ATLAS detector based on the pp collisions data sample produced at root s = 13 TeV at the LHC during Run 2 and corresponding to an integrated luminosity of 139 fb(-1). An innovative approach is used to correct for potential charge-dependent momentum biases related to the knowledge of the detector geometry, using the Z ->mu(+)mu(-) resonance. The muon momentum scale and resolution are measured using samples of J/psi ->mu(+)mu(-) and Z ->mu(+)mu(-) events. A calibration procedure is defined and applied to simulated data to match the performance measured in real data. The calibration is validated using an independent sample of Upsilon ->mu(+)mu(-) events. At the Z(J/psi) peak, the momentum scale is measured with an uncertainty at the 0.05% (0.1%) level, and the resolution is measured with an uncertainty at the 1.5% (2%) level. The charge-dependent bias is removed with a dedicated in situ correction for momenta up to 450 GeV with a precision better than 0.03 TeV-1.
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., Cabrera Urban, S., et al. (2023). ATLAS flavour-tagging algorithms for the LHC Run 2 pp collision dataset. Eur. Phys. J. C, 83(7), 681–37pp.
Abstract: The flavour-tagging algorithms developed by the AvTLAS Collaboration and used to analyse its dataset of root s = 13 TeV pp collisions from Run 2 of the Large Hadron Collider are presented. These new tagging algorithms are based on recurrent and deep neural networks, and their performance is evaluated in simulated collision events. These developments yield considerable improvements over previous jet-flavour identification strategies. At the 77% b-jet identification efficiency operating point, light-jet (charm-jet) rejection factors of 170 (5) are achieved in a sample of simulated Standard Model t (t) over bar events; similarly, at a c-jet identification efficiency of 30%, a light-jet (b-jet) rejection factor of 70 (9) is obtained.
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Cantero, J., et al. (2023). Search for resonant WZ production in the fully leptonic final state in proton-proton collisions at √s=13 TeV with the ATLAS detector. Eur. Phys. J. C, 83(7), 633–34pp.
Abstract: A search for a WZ resonance, in the fully leptonic final state (electrons or muons), is performed using 139 fb(-1) of data collected at a centre-of-mass energy of 13 TeV by the ATLAS detector at the Large Hadron Collider. The results are interpreted in terms of a singly charged Higgs boson of the Georgi-Machacek model, produced by WZ fusion, and of a Heavy Vector Triplet, with the resonance produced by WZ fusion or the Drell-Yan process. No significant excess over the Standard Model prediction is observed and limits are set on the production cross-section times branching ratio as a function of the resonance mass for these processes.
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., Cabrera Urban, S., et al. (2023). Measurement of exclusive pion pair production in proton-proton collisions at √s=7 TeV with the ATLAS detector. Eur. Phys. J. C, 83(7), 627–28pp.
Abstract: The exclusive production of pion pairs in the process pp -> pp pi(+)pi(-) has been measured at root s = 7 TeV with the ATLAS detector at the LHC, using 80 μb(-1) of low-luminosity data. The pion pairs were detected in the ATLAS central detector while outgoing protons were measured in the forwardATLASALFAdetector system. This represents the first use of proton tagging to measure an exclusive hadronic final state at the LHC. Across-sectionmeasurement is performed in two kinematic regions defined by the proton momenta, the pion rapidities and transverse momenta, and the pion-pion invariant mass. Cross-section values of 4.8 +/- 1.0 (stat)(-0.2) (+0.3)(syst) μb and 9 +/- 6 (stat)(-2)(+2) (syst) μb are obtained in the two regions; they are compared with theoretical models and provide a demonstration of the feasibility of measurements of this type.
|