Abstract: A search is performed for the process pp -> G* -> B-H(b) over bar/(B) over bar (H)b -> Hb (b) over bar -> b (b) over barb (b) over bar, predicted in composite Higgs scenarios, where G* is a heavy colour octet vector resonance and B-H a vector-like quark of charge -1/3. The data were obtained from pp collisions at a centre-of-mass energy of 8 TeV corresponding to an integrated luminosity of 19.5 fb(-1), recorded by the ATLAS detector at the LHC. The largest background, multijet production, is estimated using a data-driven method. No significant excess of events with respect to Standard Model predictions is observed, and upper limits on the production cross section times branching ratio are set. Comparisons to the predictions from a specific benchmark model are made, resulting in lower mass limits in the two-dimensional mass plane of m(G*) vs. m(BH).

Abstract: The distribution of particles inside hadronic jets produced in the decay of boosted W and Z bosons can be used to discriminate such jets from the continuum background. Given that a jet has been identified as likely resulting from the hadronic decay of a boosted W or Z boson, this paper presents a technique for further differentiating Z bosons from W bosons. The variables used are jet mass, jet charge, and a b-tagging discriminant. A likelihood tagger is constructed from these variables and tested in the simulation of W' -> WZ for bosons in the transverse momentum range 200 GeV < p(T) < 400 GeV in root s = 8 TeV pp collisions with the ATLAS detector at the LHC. For Z-boson tagging efficiencies of epsilon(Z) = 90, 50, and 10 %, one can achieve W+-boson tagging rejection factors (1/epsilon(W+)) of 1.7, 8.3 and 1000, respectively. It is not possible to measure these efficiencies in the data due to the lack of a pure sample of high p(T), hadronically decaying Z bosons. However, the modelling of the tagger inputs for boosted W bosons is studied in data using a t (t) over bar -enriched sample of events in 20.3 fb(-1) of data at root s = 8 TeV. The inputs are well modelled within uncertainties, which builds confidence in the expected tagger performance.

Abstract: The investigation of beam halo transverse distributions is important for the understanding of beam losses and the control of backgrounds in Future Linear Colliders (FLC). A novel in vacuum diamond sensor (DSv) scanner with four strips has been designed and developed for the investigation of the beam halo transverse distributions and also for the diagnostics of Compton recoil electrons after the interaction point (IP) of ATF2, a low energy (1.3 GeV) prototype of the final focus system for the ILC and CLIC linear collider projects. Using the DSv, a dynamic range of similar to 10(6) has been successfully demonstrated and confirmed for the first time in simultaneous beam core (similar to 10(6) electrons) and beam halo (similar to 10(3) electrons) measurements at ATF2. This report presents the characterization, performance studies and tests of diamond sensors using an a source, as well as using the electron beams at PHIL, a low energy (<5 MeV) photo-injector at LAL, and at ATF2. First beam halo measurement results using the DSv at ATF2 with different beam intensities and vacuum levels are also presented. Such measurements not only allow one to evaluate the different sources of beam halo generation but also to define the requirements for a suitable collimation system to be installed at ATF2, as well as to optimize its performance during future operation.