|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Ferrer, A., Fiorini, L., et al. (2014). Measurement of the t(t)over-bar production cross-section using e μevents with b-tagged jets in pp collisions at root s=7 and 8 TeV with the ATLAS detector. Eur. Phys. J. C, 74(10), 3109–32pp.
Abstract: The inclusive top quark pair (t (t) over tilde) production cross-section sigma(t (t) over bar) has been measured in proton-proton collisions at root s = 7 TeV and root s = 8 TeV with the ATLAS experiment at the LHC, using t (t) over bar events with an opposite-charge e μpair in the final state. The measurement was performed with the 2011 7 TeV dataset corresponding to an integrated luminosity of 4.6 fb(-1) and the 2012 8 TeV dataset of 20.3 fb(-1). The numbers of events with exactly one and exactly two b-tagged jets were counted and used to simultaneously determine sigma(t (t) over bar) and the efficiency to reconstruct and b-tag a jet from a top quark decay, thereby minimising the associated systematic uncertainties. The cross-section was measured to be: sigma(t (t) over bar) = 182.9 +/- 3.1 +/- 4.2 +/- 3.6 +/- 3.3 pb (root s = 7 TeV) and sigma(t (t) over bar) = 242.4 +/- 1.7 +/- 5.5 +/- 7.5 +/- 4.2 pb (root s = 8 TeV), where the four uncertainties arise from data statistics, experimental and theoretical systematic effects, knowledge of the integrated luminosity and of the LHC beam energy. The results are consistent with recent theoretical QCD calculations at next-to-next-to-leading order. Fiducial measurements corresponding to the experimental acceptance of the leptons are also reported, together with the ratio of cross-sections measured at the two centre-of-mass energies. The inclusive cross-section results were used to determine the top quark pole mass via the dependence of the theoretically predicted cross-section on m(t)(pole) giving a result of m(t)(pole) = 172.9(-2.6)(+2.5) GeV. By looking for an excess of t (t) over bar production with respect to the QCD prediction, the results were also used to place limits on the pair-production of supersymmetric top squarks (t) over tilde (1) with masses close to the top quarkmass, decaying via (t) over tilde (1) -> t (chi) over tilde (0)(1) 1 to predominantly right-handed top quarks and a light neutralino (chi) over tilde (0)(1) 1, the lightest supersymmetric particle. Top squarks with masses between the top quark mass and 177 GeV are excluded at the 95% confidence level.
|
|
|
|
LHCb Collaboration(Aaij, R. et al), Martinez-Vidal, F., Oyanguren, A., Ruiz Valls, P., & Sanchez Mayordomo, C. (2014). Study of chi(b) meson production in pp collisions at root s=7 and 8 TeV and observation of the decay chi(b) (3P) -> gamma(3S)gamma. Eur. Phys. J. C, 74(10), 3092–13pp.
Abstract: A study of chi(b) meson production at LHCb is performed on proton-proton collision data, corresponding to 3.0 fb(-1) of integrated luminosity collected at centre-of-mass energies root s = 7 and 8 TeV. The fraction of gamma(nS) mesons originating from chi(b) decays is measured as a function of the gamma transverse momentum in the rapidity range 2.0 < y(gamma) < 4.5. The radiative transition of the chi(b) (3P) meson to gamma(3S) is observed for the first time. The chi(b)1 (3P) mass is determined to be m chi(b1) (3P) = 10 511.3 +/- 1.7 +/- 2.5MeV/c(2), where the first uncertainty is statistical and the second is systematic.
|
|
|
|
Campanario, F., Kerner, M., Ninh, L. D., & Zeppenfeld, D. (2014). Z gamma production in association with two jets at next-to-leading order QCD. Eur. Phys. J. C, 74(9), 3085–7pp.
Abstract: Next-to-leading order QCD corrections to the QCD-induced pp -> l(+)l(-)gamma j j + X and pp -> <(nu)lover bar>(l)nu(l)gamma(jj) + X processes are presented. The latter is used to find an optimal cut to reduce the contribution of radiative photon emission off the charged leptons in the first channel. As expected, the scale uncertainties are significantly reduced at NLO and the QCD corrections are phase-space dependent and important for precise measurements at the LHC.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Ferrer, A., Fiorini, L., et al. (2014). Electron and photon energy calibration with the ATLAS detector using LHC Run 1 data. Eur. Phys. J. C, 74(10), 3071–48pp.
Abstract: This paper presents the electron and photon energy calibration achieved with the ATLAS detector using about 25 fb(-1) of LHC proton-proton collision data taken at centre-of-mass energies of root s = 7 and 8 TeV. The reconstruction of electron and photon energies is optimised using multivariate algorithms. The response of the calorimeter layers is equalised in data and simulation, and the longitudinal profile of the electromagnetic showers is exploited to estimate the passive material in front of the calorimeter and reoptimise the detector simulation. After all corrections, the Z resonance is used to set the absolute energy scale. For electrons from Z decays, the achieved calibration is typically accurate to 0.05% in most of the detector acceptance, rising to 0.2% in regions with large amounts of passive material. The remaining inaccuracy is less than 0.2-1% for electrons with a transverse energy of 10 GeV, and is on average 0.3% for photons. The detector resolution is determined with a relative inaccuracy of less than 10% for electrons and photons up to 60 GeV transverse energy, rising to 40% for transverse energies above 500 GeV.
|
|
|
|
KM3NeT Collaboration(Adrian-Martinez, S. et al), Calvo Diaz-Aldagalan, D., Hernandez-Rey, J. J., Martinez-Mora, J. A., Real, D., Zornoza, J. D., et al. (2014). Deep sea tests of a prototype of the KM3NeT digital optical module. Eur. Phys. J. C, 74(9), 3056–8pp.
Abstract: The first prototype of a photo-detection unit of the future KM3NeT neutrino telescope has been deployed in the deepwaters of the Mediterranean Sea. This digital optical module has a novel design with a very large photocathode area segmented by the use of 31 three inch photomultiplier tubes. It has been integrated in the ANTARES detector for in-situ testing and validation. This paper reports on the first months of data taking and rate measurements. The analysis results highlight the capabilities of the new module design in terms of background suppression and signal recognition. The directionality of the optical module enables the recognition of multiple Cherenkov photons from the same (40)Kdecay and the localisation of bioluminescent activity in the neighbourhood. The single unit can cleanly identify atmospheric muons and provide sensitivity to the muon arrival directions.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Ferrer, A., Fiorini, L., et al. (2014). Muon reconstruction efficiency and momentum resolution of the ATLAS experiment in proton-proton collisions at root s=7 TeV in 2010. Eur. Phys. J. C, 74(9), 3034–32pp.
Abstract: This paper presents a study of the performance of the muon reconstruction in the analysis of proton-proton collisions at root s = 7TeV at the LHC, recorded by the ATLAS detector in 2010. This performance is described in terms of reconstruction and isolation efficiencies and momentum resolutions for different classes of reconstructed muons. The results are obtained from an analysis of J/psi meson and Z boson decays to dimuons, reconstructed from a data sample corresponding to an integrated luminosity of 40 pb(-1). The measured performance is compared to Monte Carlo predictions and deviations from the predicted performance are discussed.
|
|
|
|
Bevan, A. J. et al, Martinez-Vidal, F., Pich, A., Azzolini, V., Bernabeu, J., Lopez-March, N., et al. (2014). The Physics of the B Factories. Eur. Phys. J. C, 74(11), 3026–916pp.
|
|
|
|
Carrio, F., Kim, H. Y., Moreno, P., Reed, R., Sandrock, C., Schettino, V., et al. (2014). Design of an FPGA-based embedded system for the ATLAS Tile Calorimeter front-end electronics test-bench. J. Instrum., 9, C03023–12pp.
Abstract: The portable test-bench for the certification of the ATLAS tile hadronic calorimeter front-end electronics has been redesigned for the present Long Shutdown (LS1) of LHC, improving its portability and expanding its functionalities. This paper presents a new test-bench based on a Xilinx Virtex-5 FPGA that implements an embedded system using a PowerPC 440 microprocessor hard core and custom IP cores. A light Linux version runs on the PowerPC microprocessor and handles the IP cores which implement the different functionalities needed to perform the desired tests such as TTCvi emulation, G-Link decoding, ADC control and data reception.
|
|
|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2014). Light-quark and gluon jet discrimination in collisions at root s=7 TeV with the ATLAS detector. Eur. Phys. J. C, 74(8), 3023–29pp.
Abstract: A likelihood-based discriminant for the identification of quark- and gluon-initiated jets is built and validated using 4.7 fb of proton-proton collision data at collected with the ATLAS detector at the LHC. Data samples with enriched quark or gluon content are used in the construction and validation of templates of jet properties that are the input to the likelihood-based discriminant. The discriminating power of the jet tagger is established in both data and Monte Carlo samples within a systematic uncertainty of 10-20 %. In data, light-quark jets can be tagged with an efficiency of while achieving a gluon-jet mis-tag rate of in a range between and for jets in the acceptance of the tracker. The rejection of gluon-jets found in the data is significantly below what is attainable using a Pythia 6 Monte Carlo simulation, where gluon-jet mis-tag rates of 10 % can be reached for a 50 % selection efficiency of light-quark jets using the same jet properties.
|
|
|
|
Diez, S. et al, Bernabeu Verdu, J., Civera, J. V., Garcia, C., Garcia-Argos, C., Lacasta, C., et al. (2014). A double-sided, shield-less stave prototype for the ATLAS Upgrade strip tracker for the High Luminosity LHC. J. Instrum., 9, P03012–16pp.
Abstract: A detailed description of the integration structures for the barrel region of the silicon strips tracker of the ATLAS Phase-II upgrade for the upgrade of the Large Hadron Collider, the so-called High Luminosity LHC (HL-LHC), is presented. This paper focuses on one of the latest demonstrator prototypes recently assembled, with numerous unique features. It consists of a shortened, shield-less, and double sided stave, with two candidate power distributions implemented. Thermal and electrical performances of the prototype are presented, as well as a description of the assembly procedures and tools.
|
|
