T2K Collaboration(Abe, K. et al), Cervera-Villanueva, A., Escudero, L., Izmaylov, A., Sorel, M., & Stamoulis, P. (2015). Neutrino oscillation physics potential of the T2K experiment. Prog. Theor. Exp. Phys., (4), 043C01–36pp.
Abstract: The observation of the recent electron neutrino appearance in a muon neutrino beam and the high-precision measurement of the mixing angle theta(13) have led to a re-evaluation of the physics potential of the T2K long-baseline neutrino oscillation experiment. Sensitivities are explored for CP violation in neutrinos, non-maximal sin(2) 2 theta(23), the octant of theta(23), and the mass hierarchy, in addition to the measurements of delta CP, sin(2) theta(23), and Delta m(32)(2), for various combinations of nu-mode and (nu) over bar -mode data-taking. With an exposure of 7.8 x 10(21) protons-on-target, T2K can achieve 1 sigma resolution of 0.050 (0.054) on sin(2) theta(23) and 0.040 (0.045) x 10(-3) eV(2) on Delta m(32)(2) for 100% (50%) neutrino beam mode running assuming sin(2) theta(23) = 0.5 and Delta m(32)(2) = 2.4 x 10(-3) eV(2). T2K will have sensitivity to the CP-violating phase delta(CP) at 90% C.L. or better over a significant range. For example, if sin(2) 2 theta(23) is maximal (i.e.theta(23) = 45 degrees) the range is -115 degrees < delta(CP) < -60 degrees for normal hierarchy and +50 degrees < delta(CP) < + 130 degrees for inverted hierarchy. When T2K data is combined with data from the NO nu A experiment, the region of oscillation parameter space where there is sensitivity to observe a non-zero delta CP is substantially increased compared to if each experiment is analyzed alone.
|
Abgrall, N. et al, Cervera-Villanueva, A., Escudero, L., Monfregola, L., & Stamoulis, P. (2011). Time projection chambers for the T2K near detectors. Nucl. Instrum. Methods Phys. Res. A, 637(1), 25–46.
Abstract: The T2K experiment is designed to study neutrino oscillation properties by directing a high intensity neutrino beam produced at J-PARC in Tokai, Japan, towards the large Super-Kamiokande detector located 295 km away, in Kamioka, Japan. The experiment includes a sophisticated near detector complex, 280 m downstream of the neutrino production target in order to measure the properties of the neutrino beam and to better understand neutrino interactions at the energy scale below a few GeV. A key element of the near detectors is the ND280 tracker, consisting of two active scintillator-bar target systems surrounded by three large time projection chambers (TPCs) for charged particle tracking. The data collected with the tracker are used to study charged current neutrino interaction rates and kinematics prior to oscillation, in order to reduce uncertainties in the oscillation measurements by the far detector. The tracker is surrounded by the former UA1/NOMAD dipole magnet and the TPCs measure the charges, momenta, and particle types of charged particles passing through them. Novel features of the TPC design include its rectangular box layout constructed from composite panels, the use of bulk micromegas detectors for gas amplification, electronics readout based on a new ASIC, and a photoelectron calibration system. This paper describes the design and construction of the TPCs, the micromegas modules, the readout electronics, the gas handling system, and shows the performance of the TPCs as deduced from measurements with particle beams, cosmic rays, and the calibration system.
|