Bayar, M., Liang, W. H., & Oset, E. (2014). B-0 and B-s(0) decays into J/psi plus a scalar or vector meson. Phys. Rev. D, 90(11), 114004–9pp.
Abstract: We extend a recent approach to describe the B-0 and B-s(0) decays into J/psi f(0)(500) and J/psi f(0)(980), relating it to the B-0 and B-s(0) decays into J/psi and a vector meson, phi, rho, K*. In addition, the B-0 and B-s(0) decays into J/psi and kappa(800) are evaluated and compared to the K* vector production. The rates obtained are in agreement with the available experiment while predictions are made for the J/psi plus kappa(800) decay.
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Ferrer, A., Fiorini, L., et al. (2014). Measurement of the t(t)over-bar production cross-section using e μevents with b-tagged jets in pp collisions at root s=7 and 8 TeV with the ATLAS detector. Eur. Phys. J. C, 74(10), 3109–32pp.
Abstract: The inclusive top quark pair (t (t) over tilde) production cross-section sigma(t (t) over bar) has been measured in proton-proton collisions at root s = 7 TeV and root s = 8 TeV with the ATLAS experiment at the LHC, using t (t) over bar events with an opposite-charge e μpair in the final state. The measurement was performed with the 2011 7 TeV dataset corresponding to an integrated luminosity of 4.6 fb(-1) and the 2012 8 TeV dataset of 20.3 fb(-1). The numbers of events with exactly one and exactly two b-tagged jets were counted and used to simultaneously determine sigma(t (t) over bar) and the efficiency to reconstruct and b-tag a jet from a top quark decay, thereby minimising the associated systematic uncertainties. The cross-section was measured to be: sigma(t (t) over bar) = 182.9 +/- 3.1 +/- 4.2 +/- 3.6 +/- 3.3 pb (root s = 7 TeV) and sigma(t (t) over bar) = 242.4 +/- 1.7 +/- 5.5 +/- 7.5 +/- 4.2 pb (root s = 8 TeV), where the four uncertainties arise from data statistics, experimental and theoretical systematic effects, knowledge of the integrated luminosity and of the LHC beam energy. The results are consistent with recent theoretical QCD calculations at next-to-next-to-leading order. Fiducial measurements corresponding to the experimental acceptance of the leptons are also reported, together with the ratio of cross-sections measured at the two centre-of-mass energies. The inclusive cross-section results were used to determine the top quark pole mass via the dependence of the theoretically predicted cross-section on m(t)(pole) giving a result of m(t)(pole) = 172.9(-2.6)(+2.5) GeV. By looking for an excess of t (t) over bar production with respect to the QCD prediction, the results were also used to place limits on the pair-production of supersymmetric top squarks (t) over tilde (1) with masses close to the top quarkmass, decaying via (t) over tilde (1) -> t (chi) over tilde (0)(1) 1 to predominantly right-handed top quarks and a light neutralino (chi) over tilde (0)(1) 1, the lightest supersymmetric particle. Top squarks with masses between the top quark mass and 177 GeV are excluded at the 95% confidence level.
|
LHCb Collaboration(Aaij, R. et al), Martinez-Vidal, F., Oyanguren, A., Ruiz Valls, P., & Sanchez Mayordomo, C. (2014). Study of chi(b) meson production in pp collisions at root s=7 and 8 TeV and observation of the decay chi(b) (3P) -> gamma(3S)gamma. Eur. Phys. J. C, 74(10), 3092–13pp.
Abstract: A study of chi(b) meson production at LHCb is performed on proton-proton collision data, corresponding to 3.0 fb(-1) of integrated luminosity collected at centre-of-mass energies root s = 7 and 8 TeV. The fraction of gamma(nS) mesons originating from chi(b) decays is measured as a function of the gamma transverse momentum in the rapidity range 2.0 < y(gamma) < 4.5. The radiative transition of the chi(b) (3P) meson to gamma(3S) is observed for the first time. The chi(b)1 (3P) mass is determined to be m chi(b1) (3P) = 10 511.3 +/- 1.7 +/- 2.5MeV/c(2), where the first uncertainty is statistical and the second is systematic.
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Ferrer, A., Fiorini, L., et al. (2014). Electron and photon energy calibration with the ATLAS detector using LHC Run 1 data. Eur. Phys. J. C, 74(10), 3071–48pp.
Abstract: This paper presents the electron and photon energy calibration achieved with the ATLAS detector using about 25 fb(-1) of LHC proton-proton collision data taken at centre-of-mass energies of root s = 7 and 8 TeV. The reconstruction of electron and photon energies is optimised using multivariate algorithms. The response of the calorimeter layers is equalised in data and simulation, and the longitudinal profile of the electromagnetic showers is exploited to estimate the passive material in front of the calorimeter and reoptimise the detector simulation. After all corrections, the Z resonance is used to set the absolute energy scale. For electrons from Z decays, the achieved calibration is typically accurate to 0.05% in most of the detector acceptance, rising to 0.2% in regions with large amounts of passive material. The remaining inaccuracy is less than 0.2-1% for electrons with a transverse energy of 10 GeV, and is on average 0.3% for photons. The detector resolution is determined with a relative inaccuracy of less than 10% for electrons and photons up to 60 GeV transverse energy, rising to 40% for transverse energies above 500 GeV.
|
NEXT Collaboration(Lorca, D. et al), Martin-Albo, J., Laing, A., Ferrario, P., Gomez-Cadenas, J. J., Alvarez, V., et al. (2014). Characterisation of NEXT-DEMO using xenon K-alpha X-rays. J. Instrum., 9, P10007–20pp.
Abstract: The NEXT experiment aims to observe the neutrinoless double beta decay of Xe-136 in a high-pressure xenon gas TPC using electroluminescence (EL) to amplify the signal from ionization. Understanding the response of the detector is imperative in achieving a consistent and well understood energy measurement. The abundance of xenon K-shell X-ray emission during data taking has been identified as a multitool for the characterisation of the fundamental parameters of the gas as well as the equalisation of the response of the detector. The NEXT-DEMO prototype is a similar to 1.5 kg volume TPC filled with natural xenon. It employs an array of 19 PMTs as an energy plane and of 256 SiPMs as a tracking plane with the TPC light tube and SiPM surfaces being coated with tetraphenyl butadiene (TPB) which acts as a wavelength shifter for the VUV scintillation light produced by xenon. This paper presents the measurement of the properties of the drift of electrons in the TPC, the effects of the EL production region, and the extraction of position dependent correction constants using K-alpha X-ray deposits. These constants were used to equalise the response of the detector to deposits left by gammas from Na-22.
|
