|
BABAR Collaboration(Lees, J. P. et al), Martinez-Vidal, F., & Oyanguren, A. (2020). Search for a Dark Leptophilic Scalar in e(+) e(-) Collisions. Phys. Rev. Lett., 125(18), 181801–8pp.
Abstract: Many scenarios of physics beyond the standard model predict the existence of new gauge singlets, which might be substantially lighter than the weak scale. The experimental constraints on additional scalars with masses in the MeV to GeV range could be significantly weakened if they interact predominantly with leptons rather than quarks. At an e(+) e(-) collider, such a leptophilic scalar (phi(L)) would be produced predominantly through radiation from a tau lepton. We report herein a search for e(+) e(- )-> tau(+) tau(-)phi(L), phi(L)-> l(+) l(-) (l = e, mu) using data collected by the BABAR experiment at SLAC. No significant signal is observed, and we set limits on the phi(L) coupling to leptons in the range 0.04 < m phi(L) < 7.0 GeV. These bounds significantly improve upon the current constraints, excluding almost entirely the parameter space favored by the observed discrepancy in the muon anomalous magnetic moment below 4 GeV at 90% confidence level.
|
|
|
BABAR Collaboration(Lees, J. P. et al), Martinez-Vidal, F., & Oyanguren, A. (2020). Precision Measurement of the Ratio B(gamma(3S) -> tau(+)tau(-))/B(gamma(3S) -> mu(+)mu(-)). Phys. Rev. Lett., 125(24), 241801–7pp.
Abstract: We report on a precision measurement of the ratio R-tau mu(gamma(3s)) = B(gamma(3S) -> tau(+)tau(-))/B(tau(gamma(3S) ->mu(+)mu(-)) using data collected with the BABAR detector at the SLAC PEP-II e(+)e(-) collider. The measurement is based on a 28 fb(-1) data sample collected at a center-of-mass energy of 10.355 GeV corresponding to a sample of 122 million gamma(35) mesons. The ratio is measured to be R-tau mu(gamma(3s)) = 0.966 +/- 0.008(stat) +/- 0.014(syst) and is in agreement with the standard model prediction of 0.9948 within 2 standard deviations. The uncertainty in R-tau mu(gamma(3s)) is almost an order of magnitude smaller than the only previous measurement.
|
|
|
BABAR Collaboration(Lees, J. P. et al), Martinez-Vidal, F., & Oyanguren, A. (2019). Search for B- -> Lambda(p)over-bar nu(nu)over-bar with the BABAR experiment. Phys. Rev. D, 100(11), 111101–8pp.
Abstract: A search for the rare flavor-changing neutral current process B- -> Lambda(p) over bar nu(nu) over bar using data from the BABAR experiment has been performed. A total of 424 fb(-1) of e(+) e(-) collision data collected at the center-of-mass energy of the Upsilon(4S) resonance is used in this study, corresponding to a sample of (471 +/- 3) x 10(6) B (B) over bar pairs. Signal B- -> Lambda(p) over bar nu(nu) over bar candidates arc identified by fast fully reconstructing a B+ decay in one of many possible exclusive decays to hadronic final states, then examining detector activity that is not associated with this reconstructed B+ decay for evidence of a signal B- -> Lambda(p) over bar nu(nu) over bar decay. The data yield is found to be consistent with the expected background contribution under a null signal hypothesis, resulting in an upper limit of B(B- -> Lambda(p) over bar nu(nu) over bar) < 3.0 x 10(-5) at the 90% confidence level.
|
|
|
BABAR Collaboration(Lees, J. P. et al), Martinez-Vidal, F., & Oyanguren, A. (2019). Observation of the Decay D-0 -> K- pi(+) e(+) e(-). Phys. Rev. Lett., 122(8), 081802–8pp.
Abstract: We report the observation of the rare charm decay D-0 -> K-pi(+)e(+)e(-), based on 468 fb(-1) of e(+)e(-) annihilation data collected at or close to the center-of-mass energy of the (sic)(4S) resonance with the BABAR detector at the SLAC National Accelerator Laboratory. We find the branching fraction in the invariant mass range 0.675 < m(e(+)e(-)) < 0.875 GeV/c(2) of the electron-positron pair to be B(D-0 -> K-pi(+)e(+)e(-)) = (4.0 +/- 0.5 +/- 0.2 +/- 0.1) x 10(-6), where the first uncertainty is statistical, the second systematic, and the third due to the uncertainty in the branching fraction of the decay D-0 -> K-pi(+)pi(+)pi(-) used as a normalization mode. The significance of the observation corresponds to 9.7 standard deviations including systematic uncertainties. This result is consistent with the recently reported D-0 -> K-pi(+)mu(+)mu(-) branching fraction, measured in the same invariant mass range, and with the value expected in the standard model. In a set of regions of m(e(+)e(-)), where long-distance effects are potentially small, we determine a 90% confidence level upper limit on the branching fraction B(D-0 -> K-pi(+)e(+)e(-)) < 3.1 x 10(-6).
|
|
|
BABAR Collaboration(Lees, J. P. et al), Martinez-Vidal, F., & Oyanguren, A. (2019). Search for a Stable Six-Quark State at BABAR. Phys. Rev. Lett., 122(7), 072002–7pp.
Abstract: Recent investigations have suggested that the six-quark combination uuddss could be a deeply bound state (S) that has eluded detection so far, and a potential dark matter candidate. We report the first search for a stable, doubly strange six-quark state in (sic) > S (Lambda) over bar(Lambda) over bar decays based on a sample of 90 x 10(6)(sic)(2S) and 110 x 10(6)(sic)(3S) decays collected by the BABAR experiment. No signal is observed, and 90% confidence level limits on the combined (sic)(2S, 3S) -> S (Lambda) over bar(Lambda) over bar branching fraction in the range (1.2-1.4) x 10(-7) are derived for m(s) < 2.05 GeV. These bounds set stringent limits on the existence of such exotic particles.
|
|
|
BABAR Collaboration(Lees, J. P. et al), Martinez-Vidal, F., & Oyanguren, A. (2019). Extraction of form Factors from a Four-Dimensional Angular Analysis of (B)over-bar -> D*l(-)(nu)over-bar(l). Phys. Rev. Lett., 123(9), 091801–8pp.
Abstract: An angular analysis of the decay (B) over bar -> D*l(-)(nu) over bar (l), l is an element of {e, mu}, is reported using the full e(+) e(-) collision data set collected by the BABAR experiment at the Upsilon(4S) resonance. One B meson from the Upsilon(4S) -> B (B) over bar decay is fully reconstructed in a hadronic decay mode, which constrains the kinematics and provides a determination of the neutrino momentum vector. The kinematics of the semileptonic decay is described by the dilepton mass squared, q(2), and three angles. The first unbinned fit to the full four-dimensional decay rate in the standard model is performed in the so-called Boyd-Grinstein-Lebed approach, which employs a generic q(2) parametrization of the underlying form factors based on crossing symmetry, analyticity, and QCD dispersion relations for the amplitudes. A fit using the more model-dependent Caprini-Lellouch-Neubert (CLN) approach is performed as well. Our form factor shapes show deviations from previous fits based on the CLN parametrization. The latest form factors also provide an updated prediction for the branching fraction ratio R(D*) B((B) over bar -> D* tau(-)(nu) over bar (tau)) /B((B) over bar -> D*l(-)(nu) over bar (l)) = 0.253 +/- 0.005. Finally, using the well-measured branching fraction for the (B) over bar -> D*l(-)(nu) over bar (l) decay, a value of vertical bar V-cb vertical bar = (38.36 +/- 0.90) x 10(-3) is obtained that is consistent with the current world average for exclusive (B) over bar -> D(*)l(-)(nu) over bar (l) decays and remains in tension with the determination from inclusive semileptonic B decays to final states with charm.
|
|
|
Babeluk, M. et al, & Marinas, C. (2023). CMOS MAPS upgrade for the Belle II Vertex Detector. Nucl. Instrum. Methods Phys. Res. A, 1048, 168015–5pp.
Abstract: The success of the Belle II experiment in Japan relies on the very high instantaneous luminosity, close to 6x1035 cm-2 s-1, expected from the SuperKEKB collider. The corresponding beam conditions at such luminosity levels generate large rates of background particles and creates stringent constraints on the vertex detector, adding to the physics requirements. Current prospects for the occupancy rates in the present vertex detector (VXD) at full luminosity fall close to the acceptable limits and bear large uncertainties. In this context, the Belle II collaboration is considering the possibility to install an upgraded VXD system around 2027 to provide a sufficient safety margin with respect to the expected background rate and possibly enhance tracking and vertexing performance. The VTX collaboration has started the design of a fully pixelated VXD, called VTX, based on fast and highly granular Depleted Monolithic Active Pixel Sensors (DMAPS) integrated on light support structures. The two main technical features of the VTX proposal are the usage of a single sensor type over all the layers of the system and the overall material budget below 2% of radiation length, compared to the current VXD which has two different sensor technologies and about 3% of radiation length. A dedicated sensor (OBELIX), taylored to the specific needs of Belle II, is under development, evolving from the existing TJ-Monopix2 sensor. The time-stamping precision below 100 ns will allow all VTX layers to take part in the track finding strategy contrary to the current situation. The first two detection layers are designed according to a self-supported all-silicon ladder concept, where 4 contiguous sensors are diced out of a wafer, thinned and interconnected with post-processed redistribution layers. The outermost detection layers follow a more conventional approach with a cold plate and carbon fibre support structure, and light flex cables interconnecting the sensors. This document will review the context, technical details and development status of the proposed Belle II VTX.
|
|
|
Babiano, V., Balibrea, J., Caballero, L., Calvo, D., Ladarescu, I., Mira Prats, S., et al. (2020). First i-TED demonstrator: A Compton imager with Dynamic Electronic Collimation. Nucl. Instrum. Methods Phys. Res. A, 953, 163228–9pp.
Abstract: i-TED consists of both a total energy detector and a Compton camera primarily intended for the measurement of neutron capture cross sections by means of the simultaneous combination of neutron time-of-flight (TOF) and gamma-ray imaging techniques. TOF allows one to obtain a neutron-energy differential capture yield, whereas the imaging capability is intended for the discrimination of radiative background sources, that have a spatial origin different from that of the capture sample under investigation. A distinctive feature of i-TED is the embedded Dynamic Electronic Collimation (DEC) concept, which allows for a trade-off between efficiency and image resolution. Here we report on some general design considerations and first performance characterization measurements made with an i-TED demonstrator in order to explore its gamma-ray detection and imaging capabilities.
|
|
|
Babiano, V., Caballero, L., Calvo, D., Ladarescu, I., Olleros, P., & Domingo-Pardo, C. (2019). gamma-Ray position reconstruction in large monolithic LaCl3(Ce) crystals with SiPM readout. Nucl. Instrum. Methods Phys. Res. A, 931, 1–22.
Abstract: We report on the spatial response characterization of large LaCl3(Ce) monolithic crystals optically coupled to 8 x 8 pixel silicon photomultiplier (SiPM) sensors. A systematic study has been carried out for 511 keV gamma-rays using three different crystal thicknesses of 10 mm, 20 mm and 30 mm, all of them with planar geometry and a base size of 50 x 50 mm(2). In this work we investigate and compare two different approaches for the determination of the main gamma-ray hit location. On one hand, methods based on the fit of an analytical model for the scintillation light distribution provide the best results in terms of linearity and field of view, with spatial resolutions close to similar to 1 mm FWHM. On the other hand, position reconstruction techniques based on neural networks provide similar linearity and field-of-view, becoming the attainable spatial resolution similar to 3 mm FWHM. For the third space coordinate z or depth-of-interaction we have implemented an inverse linear calibration approach based on the cross-section of the measured scintillation-light distribution at a certain height. The detectors characterized in this work are intended for the development of so-called Total Energy Detectors with Compton imaging capability (i-TED), aimed at enhanced sensitivity and selectivity measurements of neutron capture cross sections via the time-of-flight (TOF) technique.
|
|
|
Babiano-Suarez, V. et al, Lerendegui-Marco, J., Balibrea-Correa, J., Caballero, L., Calvo, D., Ladarescu, I., et al. (2021). Imaging neutron capture cross sections: i-TED proof-of-concept and future prospects based on Machine-Learning techniques. Eur. Phys. J. A, 57(6), 197–17pp.
Abstract: i-TED is an innovative detection system which exploits Compton imaging techniques to achieve a superior signal-to-background ratio in (n, gamma) cross-section measurements using time-of-flight technique. This work presents the first experimental validation of the i-TED apparatus for high-resolution time-of-flight experiments and demonstrates for the first time the concept proposed for background rejection. To this aim, the Au-197(n, gamma) and Fe-56(n, gamma) reactions were studied at CERN n_TOF using an i-TED demonstrator based on three position-sensitive detectors. Two C6D6 detectors were also used to benchmark the performance of i-TED. The i-TED prototype built for this study shows a factor of similar to 3 higher detection sensitivity than state-of-the-art C6D6 detectors in the 10 keV neutron-energy region of astrophysical interest. This paper explores also the perspectives of further enhancement in performance attainable with the final i-TED array consisting of twenty position-sensitive detectors and newanalysis methodologies based on Machine-Learning techniques.
|
|