ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Bailey, A. J., Barranco Navarro, L., Cabrera Urban, S., Castillo Gimenez, V., et al. (2018). Search for new phenomena using the invariant mass distribution of same-flavour opposite-sign dilepton pairs in events with missing transverse momentum in root s=13 TeV pp collisions with the ATLAS detector. Eur. Phys. J. C, 78(8), 625–38pp.
Abstract: A search for new phenomena in final states containing an e(+)e(-) or m(+)m(-) pair, jets, and large missing transverse momentum is presented. This analysis makes use of proton-proton collision data with an integrated luminosity of 36.1 fb(-1), collected during 2015 and 2016 at a centre of-mass energy Os = 13 TeV with the ATLAS detector at the Large Hadron Collider. The search targets the pair production of supersymmetric coloured particles (squarks or gluinos) and their decays into final states containing an e(+)e(-) or m(+)m(-) pair and the lightest neutralino ((c) over tilde (0)(1)) via one of two next-to-lightest neutralino ((c) over tilde (0)(2)) decay mechanisms: (c) over tilde (0)(2) Z (c) over tilde (0)(1), where the Z boson decays leptonically leading to a peak in the dilepton invariant mass distribution around the Z boson mass; and (c) over tilde (0)(2) l(+)1(-) (c) over tilde (0)(1) with no intermediate l(+)l(-) resonance, yielding a kinematic endpoint in the dilepton invariant mass spectrum. The data are found to be consistent with the Standard Model expectation. Results are interpreted using simplified models, and exclude gluinos and squarks with masses as large as 1.85 and 1.3 TeV at 95% confidence level, respectively.
|
ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Barranco Navarro, L., Cabrera Urban, S., Castillo Gimenez, V., Cerda Alberich, L., et al. (2018). Measurement of tau polarisation in Z/gamma* -> tau tau decays in proton-proton collisions at root s=8 TeV with the ATLAS detector. Eur. Phys. J. C, 78(2), 163–30pp.
Abstract: This paper presents a measurement of the polarisation of tau leptons produced in Z/gamma* -> tau tau decays which is performed with a dataset of proton-proton collisions at root s = 8 TeV, corresponding to an integrated luminosity of 20.2 fb(-1) recorded with the ATLAS detector at the LHC in 2012. The Z/gamma* -> tau tau decays are reconstructed from a hadronically decaying tau lepton with a single charged particle in the final state, accompanied by a tau lepton that decays leptonically. The tau polarisation is inferred from the relative fraction of energy carried by charged and neutral hadrons in the hadronic tau decays. The polarisation is measured in a fiducial region that corresponds to the kinematic region accessible to this analysis. The tau polarisation extracted over the full phase space within the Z/gamma* mass range of 66 < mZ/gamma* < 116GeVis found to be P-tau = -0.14 +/- 0.02(stat)+/- 0.04(syst). It is in agreement with the Standard Model prediction of Pt = -0.1517 +/- 0.0019, which is obtained from the ALP-GEN event generator interfaced with the PYTHIA 6 parton shower modelling and the TAUOLA tau decay library.
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Ferrer, A., Fiorini, L., et al. (2012). A search for flavour changing neutral currents in top-quark decays in pp collision data collected with the ATLAS detector at root s=7 TeV. J. High Energy Phys., 09(9), 139–37pp.
Abstract: A search for flavour changing neutral current (FCNC) processes in top-quark decays by the ATLAS Collaboration is presented. Data collected from pp collisions at the LHC at a centre-of-mass energy of root s = 7 TeV during 2011, corresponding to an integrated luminosity of 2.1 fb(-1), were used. A search was performed for top-quark pair-production events, with one top quark decaying through the t -> Zq FCNC (q = u, c) channel, and the other through the Standard Model dominant mode t -> Wb. Only the decays of the Z boson to charged leptons and leptonic W-boson decays were considered as signal. Consequently, the final-state topology is characterised by the presence of three isolated charged leptons, at least two jets and missing transverse momentum from the undetected neutrino. No evidence for an FCNC signal was found. An upper limit on the t -> Zq branching ratio of BR(t -> Zq) < 0.73% is set at the 95% confidence level.
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2012). ATLAS search for a heavy gauge boson decaying to a charged lepton and a neutrino in pp collisions at root s=7 TeV. Eur. Phys. J. C, 72(12), 2241–23pp.
Abstract: The ATLAS detector at the LHC is used to search for high-mass states, such as heavy charged gauge bosons (W'), decaying to a charged lepton (electron or muon) and a neutrino. Results are presented based on the analysis of pp collisions at a center-of-mass energy of 7 TeV corresponding to an integrated luminosity of 4.7 fb(-1). No excess beyond Standard Model expectations is observed. A W' with Sequential Standard Model couplings is excluded at the 95 % credibility level for masses up to 2.55 TeV. Excited chiral bosons (W*) with equivalent coupling strength are excluded for masses up to 2.42 TeV.
|
Bach, E. et al, Bernabeu, J., Lacasta, C., Solaz, C., & Soldevila, U. (2024). Analysis of the quality assurance results from the initial part of production of the ATLAS18 ITK strip sensors. Nucl. Instrum. Methods Phys. Res. A, 1064, 169435–8pp.
Abstract: The production of strip sensors for the ATLAS Inner Tracker (ITk) started in 2021. Since then, a Quality Assurance (QA) program has been carried out continuously, by using specific test structures, in parallel to the Quality Control (QC) inspection of the sensors. The QA program consists of monitoring sensor-specific characteristics and the technological process variability, before and after the irradiation with gammas, neutrons, and protons. After two years, half of the full production volume has been reached and we present an analysis of the parameters measured as part of the QA process. The main devices used for QA purposes are miniature strip sensors, monitor diodes, and the ATLAS test chip, which contains several test structures. Such devices are tested by several sites across the collaboration depending on the type of samples (non-irradiated components or irradiated with protons, neutrons, or gammas). The parameters extracted from the tests are then uploaded to a database and analyzed by Python scripts. These parameters are mainly examined through histograms and timeevolution plots to obtain parameter distributions, production trends, and meaningful parameter-to-parameter correlations. The purpose of this analysis is to identify possible deviations in the fabrication or the sensor quality, changes in the behavior of the test equipment at different test sites, or possible variability in the irradiation processes. The conclusions extracted from the QA program have allowed test optimization, establishment of control limits for the parameters, and a better understanding of device properties and fabrication trends. In addition, any abnormal results prompt immediate feedback to a vendor.
|