|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fernandez Martinez, P., et al. (2015). Measurement of the top quark mass in the t(t)over-bar -> lepton plus jets and t(t)over-bar -> dilepton channels using root s=7 TeV ATLAS data. Eur. Phys. J. C, 75(7), 330–36pp.
Abstract: The top quark mass was measured in the channels t (t) over bar -> lepton+jets and t (t) over bar -> dilepton (lepton = e, mu) based on ATLAS data recorded in 2011. The data were taken at the LHC with a proton-proton centre-of-mass energy of root s = 7 TeV and correspond to an integrated luminosity of 4.6 fb(-1). The t (t) over bar -> lepton+jets analysis uses a three-dimensional template technique which determines the top quark mass together with a global jet energy scale factor (JSF), and a relative b-to-light-jet energy scale factor (bJSF), where the terms b-jets and light-jets refer to jets originating from b-quarks and u,d,c, s-quarks or gluons, respectively. The analysis of the t (t) over bar -> dilepton channel exploits a one-dimensional template method using the m(lb) observable, defined as the average invariant mass of the two lepton+b-jet pairs in each event. The top quark mass is measured to be 172.33 +/- 0.75(stat + JSF + bJSF) +/- 1.02(syst) GeV, and 173.79 +/- 0.54(stat) +/- 1.30(syst) GeV in the t (t) over bar -> lepton+jets and t (t) over bar -> dilepton channels, respectively. The combination of the two results yields m(top) = 172.99 +/- 0.48(stat) +/- 0.78(syst) GeV, with a total uncertainty of 0.91 GeV.
|
|
|
ATLAS Collaboration(Aad, G. et al), Amoros, G., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Ferrer, A., et al. (2012). Measurement of the top quark mass with the template method in the t(t)over-bar -> lepton plus jets channel using ATLAS data. Eur. Phys. J. C, 72(6), 2046–30pp.
Abstract: The top quark mass has been measured using the template method in the t (t) over bar -> lepton + jets channel based on data recorded in 2011 with the ATLAS detector at the LHC. The data were taken at a proton-proton centre-of-mass energy of root s = 7 TeV and correspond to an integrated luminosity of 1.04 fb(-1). The analyses in the e + jets and μ+ jets decay channels yield consistent results. The top quark mass is measured to be m(top) = 174.5 +/- 0.6(stat) +/- 2.3(syst) GeV.
|
|
|
ATLAS Collaboration(Aad, G. et al), Amoros, G., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Escobar, C., et al. (2010). Readiness of the ATLAS Tile Calorimeter for LHC collisions. Eur. Phys. J. C, 70(4), 1193–1236.
Abstract: The Tile hadronic calorimeter of the ATLAS detector has undergone extensive testing in the experimental hall since its installation in late 2005. The readout, control and calibration systems have been fully operational since 2007 and the detector has successfully collected data from the LHC single beams in 2008 and first collisions in 2009. This paper gives an overview of the Tile Calorimeter performance as measured using random triggers, calibration data, data from cosmic ray muons and single beam data. The detector operation status, noise characteristics and performance of the calibration systems are presented, as well as the validation of the timing and energy calibration carried out with minimum ionising cosmic ray muons data. The calibration systems' precision is well below the design value of 1%. The determination of the global energy scale was performed with an uncertainty of 4%.
|
|
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fassi, F., Ferrer, A., et al. (2015). Measurement of the t(t)over-bar production cross-section as a function of jet multiplicity and jet transverse momentum in 7 TeV proton-proton collisions with the ATLAS detector. J. High Energy Phys., 01(1), 020–67pp.
Abstract: The t (t) over bar production cross-section dependence on jet multiplicity and jet transverse momentum is reported for proton-proton collisions at a centre-of-mass energy of 7 TeV in the single-lepton channel. The data were collected with the ATLAS detector at the CERN Large Hadron Collider and comprise the full 2011 data sample corresponding to an integrated luminosity of 4.6 fb(-1). Differential cross-sections are presented as a function of the jet multiplicity for up to eight jets using jet transverse momentum thresholds of 25, 40, 60, and 80 GeV, and as a function of jet transverse momentum up to the fifth jet. The results are shown after background subtraction and corrections for all known detector effects, within a kinematic range closely matched to the experimental acceptance. Several QCD-based Monte Carlo models are compared with the results. Sensitivity to the parton shower modelling is found at the higher jet multiplicities, at high transverse momentum of the leading jet and in the transverse momentum spectrum of the fifth leading jet. The MC@NLO+HERWIG MC is found to predict too few events at higher jet multiplicities.
|
|
|
ATLAS Collaboration(Aad, G. et al), Amoros, G., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Escobar, C., et al. (2010). The ATLAS Simulation Infrastructure. Eur. Phys. J. C, 70(3), 823–874.
Abstract: The simulation software for the ATLAS Experiment at the Large Hadron Collider is being used for large-scale production of events on the LHC Computing Grid. This simulation requires many components, from the generators that simulate particle collisions, through packages simulating the response of the various detectors and triggers. All of these components come together under the ATLAS simulation infrastructure. In this paper, that infrastructure is discussed, including that supporting the detector description, interfacing the event generation, and combining the GEANT4 simulation of the response of the individual detectors. Also described are the tools allowing the software validation, performance testing, and the validation of the simulated output against known physics processes.
|
|