ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Barranco Navarro, L., Cabrera Urban, S., Castillo Gimenez, V., Cerda Alberich, L., et al. (2017). Search for top quark decays t -> qH,with H -> gamma gamma, in root s=13 TeV pp collisions using the ATLAS detector. J. High Energy Phys., 10(10), 129–43pp.
Abstract: This article presents a search for flavour-changing neutral currents in the decay of a top quark into an up-type (q = c; u) quark and a Higgs boson, where the Higgs boson decays into two photons. The proton-proton collision data set analysed amounts to 36.1 fb(-1) at root s = 13TeV collected by the ATLAS experiment at the LHC. Top quark pair events are searched for, where one top quark decays into qH and the other decays into bW. Both the hadronic and leptonic decay modes of the W boson are used. No significant excess is observed and an upper limit is set on the t -> cH branching ratio of 2 : 2 x 10(-3) at the 95% confidence level, while the expected limit in the absence of signal is 1 : 6 x 10(-3). The corresponding limit on the tcH coupling is 0.090 at the 95% confidence level. The observed upper limit on the t -> uH branching ratio is 2 : 4 x 10(-3).
|
ATLAS Collaboration(Aad, G. et al), Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Cardillo, F., Castillo, F. L., et al. (2021). Determination of the parton distribution functions of the proton from ATLAS measurements of differential W-+/- and Z boson production in association with jets. J. High Energy Phys., 07(7), 223–44pp.
Abstract: This article presents a new set of proton parton distribution functions, AT-LASepWZVjet20, produced in an analysis at next-to-next-to-leading order in QCD. The new data sets considered are the measurements of W+ and W- boson and Z boson production in association with jets in pp collisions at root s = 8 TeV performed by the ATLAS experiment at the LHC with integrated luminosities of 20.2 fb(-1) and 19.9 fb(-1), respectively. The analysis also considers the ATLAS measurements of differential W-+/- and Z boson production at root s = 7 TeV with an integrated luminosity of 4.6 fb(-1) and deep-inelastic-scattering data from e(+/-) p collisions at the HERA accelerator. An improved determination of the sea-quark densities at high Bjorken x is shown, while confirming a strange-quark density similar in size to the up- and down-sea-quark densities in the range x less than or similar to 0.02 found by previous ATLAS analyses.
|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Barranco Navarro, L., Cabrera Urban, S., Castillo Gimenez, V., Cerda Alberich, L., et al. (2016). Muon reconstruction performance of the ATLAS detector in proton-proton collision data at root s=13 TeV. Eur. Phys. J. C, 76(5), 292–30pp.
Abstract: This article documents the performance of the ATLAS muon identification and reconstruction using the LHC dataset recorded at root s = 13 TeVin 2015. Using a large sample of J/.psi -> μμand Z -> μμdecays from 3.2 fb(-1) of pp collision data, measurements of the reconstruction efficiency, as well as of the momentum scale and resolution, are presented and compared to Monte Carlo simulations. The reconstruction efficiency is measured to be close to 99 % over most of the covered phase space (vertical bar eta vertical bar < 2.5 and 5 < p(T) < 100 GeV). The isolation efficiency varies between 93 and 100 % depending on the selection applied and on the momentum of the muon. Both efficiencies are well reproduced in simulation. In the central region of the detector, the momentum resolution is measured to be 1.7 % (2.3 %) for muons from J/psi -> μmu(Z -> μmu) decays, and the momentum scale is known with an uncertainty of 0.05 %. In the region vertical bar eta vertical bar > 2.2, the p(T) resolution for muons from Z -> μdecays is 2.9 % while the precision of the momentum scale for low-p(T) muons from J/psi -> μμdecays is about 0.2 %.
|
ATLAS Collaboration(Aad, G. et al), Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Cardillo, F., Castillo, F. L., et al. (2021). Muon reconstruction and identification efficiency in ATLAS using the full Run 2 pp collision data set at root s = 13 TeV. Eur. Phys. J. C, 81(7), 578–44pp.
Abstract: This article documents the muon reconstruction and identification efficiency obtained by the ATLAS experiment for 139 fb-1 of pp collision data at <mml:msqrt>s</mml:msqrt>=13 TeV collected between 2015 and 2018 during Run 2 of the LHC. The increased instantaneous luminosity delivered by the LHC over this period required a reoptimisation of the criteria for the identification of prompt muons. Improved and newly developed algorithms were deployed to preserve high muon identification efficiency with a low misidentification rate and good momentum resolution. The availability of large samples of Z -> μμand J/psi -> μμdecays, and the minimisation of systematic uncertainties, allows the efficiencies of criteria for muon identification, primary vertex association, and isolation to be measured with an accuracy at the per-mille level in the bulk of the phase space, and up to the percent level in complex kinematic configurations. Excellent performance is achieved over a range of transverse momenta from 3 GeV to several hundred GeV, and across the full muon detector acceptance of |eta|<2.7.
|
ATLAS Tile Calorimeter System(Abdallah, J. et al), Ferrer, A., Fiorini, L., Hernandez Jimenez, Y., Higon-Rodriguez, E., Ruiz-Martinez, A., et al. (2016). The Laser calibration of the ATLAS Tile Calorimeter during the LHC run 1. J. Instrum., 11, T10005–29pp.
Abstract: This article describes the Laser calibration system of the ATLAS hadronic Tile Calorimeter that has been used during the run 1 of the LHC. First, the stability of the system associated readout electronics is studied. It is found to be stable with variations smaller than 0.6 %. Then, the method developed to compute the calibration constants, to correct for the variations of the gain of the calorimeter photomultipliers, is described. These constants were determined with a statistical uncertainty of 0.3 % and a systematic uncertainty of 0.2 % for the central part of the calorimeter and 0.5 % for the end-caps. Finally, the detection and correction of timing mis-configuration of the Tile Calorimeter using the Laser system are also presented.
|