|
ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Aparisi Pozo, J. A., Bailey, A. J., Barranco Navarro, L., Cabrera Urban, S., et al. (2019). Measurement of prompt photon production in root s(NN)=8.16 TeV p Pb collisions with ATLAS. Phys. Lett. B, 796, 230–252.
Abstract: The inclusive production rates of isolated, prompt photons in p Pb collisions at root s(NN) = 8.16 TeV are studied with the ATLAS detector at the Large Hadron Collider using a dataset with an integrated luminosity of 165 nb(-1) recorded in 2016. The cross-section and nuclear modification factor R-p pb are measured as a function of photon transverse energy from 20 GeV to 550 GeV and in three nucleon-nucleon centre-of-mass pseudorapidity regions, (-2.83, -2.02), (-1.84, 0.91), and (1.09, 1.90). The cross-section and R-p pb values are compared with the results of a next-to-leading-order perturbative QCD calculation, with and without nuclear parton distribution function modifications, and with expectations based on a model of the energy loss of partons prior to the hard scattering. The data disfavour a large amount of energy loss and provide new constraints on the parton densities in nuclei.
|
|
|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Castillo, F. L., et al. (2020). Measurement of the ttbar production cross-section and lepton differential distributions in e mu dilepton events from pp collisions at root s=13 TeV with the ATLAS detector. Eur. Phys. J. C, 80(6), 528–70pp.
Abstract: The inclusive top quark pair (tt<overbar></mml:mover>) production cross-section sigma tt<overbar></mml:mover> has been measured in proton-proton collisions at <mml:msqrt>s</mml:msqrt>=13<mml:mspace width=“0.166667em”></mml:mspace>TeV, using 36.1 fb-1 of data collected in 2015-2016 by the ATLAS experiment at the LHC. Using events with an opposite-charge e μpair and b-tagged jets, the cross-section is measured to be: <disp-formula id=“Equ10”><mml:mtable><mml:mtr><mml:mtd columnalign=“right”>sigma tt<overbar></mml:mover>=826.4 +/- 3.6<mml:mspace width=“0.166667em”></mml:mspace>(stat)<mml:mspace width=“4pt”></mml:mspace>+/- 11.5<mml:mspace width=“0.166667em”></mml:mspace>(syst)<mml:mspace width=“4pt”></mml:mspace>+/- 15.7<mml:mspace width=“0.166667em”></mml:mspace>(lumi)<mml:mspace width=“4pt”></mml:mspace>+/- 1.9<mml:mspace width=“0.166667em”></mml:mspace>(beam)<mml:mspace width=“0.166667em”></mml:mspace>pb,</mml:mtd></mml:mtr></mml:mtable><graphic xmlns:xlink=“http://www.w3.org/1999/xlink” xlink:href=“1005220207907ArticleEqu10.gif” position=“anchor”></graphic></disp-formula>where the uncertainties reflect the limited size of the data sample, experimental and theoretical systematic effects, the integrated luminosity, and the LHC beam energy, giving a total uncertainty of 2.4%. The result is consistent with theoretical QCD calculations at next-to-next-to-leading order. It is used to determine the top quark pole mass via the dependence of the predicted cross-section on mtpole, giving mtpole=173.1-2.1+2.0<mml:mspace width=“0.166667em”></mml:mspace>GeV. It is also combined with measurements at <mml:msqrt>s</mml:msqrt><mml:mo>=7<mml:mspace width=“0.166667em”></mml:mspace>TeV and <mml:msqrt>s</mml:msqrt><mml:mo>=8<mml:mspace width=“0.166667em”></mml:mspace>TeV to derive ratios and double ratios of t<mml:mover accent=“true”>t<mml:mo stretchy=“false”><overbar></mml:mover> and Z cross-sections at different energies. The same event sample is used to measure absolute and normalised differential cross-sections as functions of single-lepton and dilepton kinematic variables, and the results are compared with predictions from various Monte Carlo event generators.
|
|
|
Hara, K. et al, Escobar, C., Garcia, C., Lacasta, C., Miñano, M., & Soldevila, U. (2020). Charge collection study with the ATLAS ITk prototype silicon strip sensors ATLAS17LS. Nucl. Instrum. Methods Phys. Res. A, 983, 164422–6pp.
Abstract: The inner tracker of the ATLAS detector is scheduled to be replaced by a completely new silicon-based inner tracker (ITk) for the Phase-II of the CERN LHC (HL-LHC). The silicon strip detector covers the volume 40 < R < 100 cm in the radial and vertical bar z vertical bar <300 cm in the longitudinal directions. The silicon sensors for the detector will be fabricated using the n(+)-on-p 6-inch wafer technology, for a total of 22,000 wafers. Intensive studies were carried out on the final prototype sensors ATLAS17LS fabricated by Hamamatsu Photonics (HPK). The charge collection properties were examined using penetrating Sr-90 beta-rays and the ALIBAVA fast readout system for the miniature sensors of 1 cm xl cm in area. The samples were irradiated by protons in the 27 MeV Birmingham Cyclotron, the 70 MeV CYRIC at Tohoku University, and the 24 GeV CERN-PS, and by neutrons at Ljubljana TAIGA reactor for fluence values up to 2 x 10(15) n(eq)/cm(2). The change in the charge collection with fluence was found to be similar to the previous prototype ATLAS12, and acceptable for the ITk. Sensors with two active thicknesses, 300 μm (standard) and 240 μm (thin), were compared and the difference in the charge collection was observed to be small for bias voltages up to 500 V. Some samples were also irradiated with gamma radiation up to 2 MGy, and the full depletion voltage was found to decrease with the dose. This was caused by the Compton electrons due to the( 60)Co gamma radiation. To summarize, the design of the ATLAS17LS and technology for its fabrication have been verified for implementation in the ITk. We are in the stage of sensor pre-production with the first sensors already delivered in January of 2020.
|
|
|
ATLAS Collaboration(Aaboud, M. et al), Alvarez Piqueras, D., Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Castillo, F. L., et al. (2021). Measurement of the jet mass in high transverse momentum Z(-> b(b)over-bar)gamma production at root s=13 TeV using the ATLAS detector. Phys. Lett. B, 812, 135991–23pp.
Abstract: The integrated fiducial cross-section and unfolded differential jet mass spectrum of high transverse momentum Z -> b (b) over bar decays are measured in Z gamma events in proton-proton collisions at root s = 13 TeV. The data analysed were collected between 2015 and 2016 with the ATLAS detector at the Large Hadron Collider and correspond to an integrated luminosity of 36.1 fb(-1). Photons are required to have a transverse momentum p(T) > 175 GeV. The Z -> b (b) over bar decay is reconstructed using a jet with p(T) > 200 GeV, found with the anti-k(t) R = 1.0 jet algorithm, and groomed to remove soft and wide-angle radiation and to mitigate contributions from the underlying event and additional proton-proton collisions. Two different but related measurements are performed using two jet grooming definitions for reconstructing the Z -> b (b) over bar decay: trimming and soft drop. These algorithms differ in their experimental and phenomenological implications regarding jet mass reconstruction and theoretical precision. To identify Zbosons, b-tagged R = 0.2 track-jets matched to the groomed large-R calorimeter jet are used as a proxy for the b-quarks. The signal yield is determined from fits of the data-driven background templates to the different jet mass distributions for the two grooming methods. Integrated fiducial cross-sections and unfolded jet mass spectra for each grooming method are compared with leading-order theoretical predictions. The results are found to be in good agreement with Standard Model expectations within the current statistical and systematic uncertainties.
|
|
|
ATLAS Collaboration(Aad, G. et al), Amoros, G., Cabrera Urban, S., Campabadal Segura, F., Castillo Gimenez, V., Costa, M. J., et al. (2010). Drift Time Measurement in the ATLAS Liquid Argon Electromagnetic Calorimeter using Cosmic Muons. Eur. Phys. J. C, 70(3), 755–785.
Abstract: The ionization signals in the liquid argon of the ATLAS electromagnetic calorimeter are studied in detail using cosmic muons. In particular, the drift time of the ionization electrons is measured and used to assess the intrinsic uniformity of the calorimeter gaps and estimate its impact on the constant term of the energy resolution. The drift times of electrons in the cells of the second layer of the calorimeter are uniform at the level of 1.3% in the barrel and 2.8% in the endcaps. This leads to an estimated contribution to the constant term of (0.29(-0.04)(+0.05))% in the barrel and (0.54(-0.04)(+0.06))% in the endcaps. The same data are used to measure the drift velocity of ionization electrons in liquid argon, which is found to be 4.61 +/- 0.07 mm/mu s at 88.5 K and 1 kV/mm.
|
|