ATLAS Collaboration(Aad, G. et al), Amoros, G., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Ferrer, A., et al. (2012). Measurement of D*(+/-) meson production in jets from pp collisions at root s=7 TeV with the ATLAS detector. Phys. Rev. D, 85(5), 052005–22pp.
Abstract: This paper reports a measurement of D*(+/-) meson production in jets from proton- proton collisions at a center- of- mass energy of root s = 7 TeV at the CERN Large Hadron Collider. The measurement is based on a data sample recorded with the ATLAS detector with an integrated luminosity of 0.30 pb(-1) for jets with transverse momentum between 25 and 70 GeV in the pseudorapidity range vertical bar eta vertical bar <2.5. D*(+/-) mesons found in jets are fully reconstructed in the decay chain: D*(+/-)-> D-0 pi(+), D-0 -> K-pi(+), and its charge conjugate. The production rate is found to be N(D*(+/-))/N(jet) = 0.025 +/- 0.001(stat.) +/- 0.004(syst.) for D*(+/-) mesons that carry a fraction z of the jet momentum in the range 0.3< z< 1. Monte Carlo predictions fail to describe the data at small values of z, and this is most marked at low jet transverse momentum.
|
ATLAS Collaboration(Aad, G. et al), Alvarez Piqueras, D., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Fernandez Martinez, P., et al. (2016). Identification of boosted, hadronically decaying W bosons and comparisons with ATLAS data taken at root s=8 TeV. Eur. Phys. J. C, 76(3), 154–47pp.
Abstract: This paper reports a detailed study of techniques for identifying boosted, hadronically decaying W bosons using 20.3 fb(-1) of proton-proton collision data collected by the ATLAS detector at the LHC at a centre-of-mass energy root s = 8 TeV. A range of techniques for optimising the signal jet mass resolution are combined with various jet substructure variables. The results of these studies in Monte Carlo simulations show that a simple pairwise combination of groomed jet mass and one substructure variable can provide a 50 % efficiency for identifying W bosons with transverse momenta larger than 200 GeV while maintaining multijet background efficiencies of 2-4% for jets with the same transverse momentum. These signal and background efficiencies are confirmed in data for a selection of tagging techniques.
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Cardillo, F., et al. (2022). Modelling and computational improvements to the simulation of single vector-boson plus jet processes for the ATLAS experiment. J. High Energy Phys., 08(8), 089–61pp.
Abstract: This paper presents updated Monte Carlo configurations used to model the production of single electroweak vector bosons (W, Z/gamma*) in association with jets in proton-proton collisions for the ATLAS experiment at the Large Hadron Collider. Improvements pertaining to the electroweak input scheme, parton-shower splitting kernels and scale-setting scheme are shown for multi-jet merged configurations accurate to next-to-leading order in the strong and electroweak couplings. The computational resources required for these set-ups are assessed, and approximations are introduced resulting in a factor three reduction of the per-event CPU time without affecting the physics modelling performance. Continuous statistical enhancement techniques are introduced by ATLAS in order to populate low cross-section regions of phase space and are shown to match or exceed the generated effective luminosity. This, together with the lower per-event CPU time, results in a 50% reduction in the required computing resources compared to a legacy set-up previously used by the ATLAS collaboration. The set-ups described in this paper will be used for future ATLAS analyses and lay the foundation for the next generation of Monte Carlo predictions for single vector-boson plus jets production.
|
ATLAS Collaboration(Aad, G. et al), Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Ferrer, A., Fiorini, L., et al. (2014). Measurement of the muon reconstruction performance of the ATLAS detector using 2011 and 2012 LHC proton-proton collision data. Eur. Phys. J. C, 74(11), 3130–34pp.
Abstract: This paper presents the performance of the ATLAS muon reconstruction during the LHC run with pp collisions at root s = 7-8 TeV in 2011-2012, focusing mainly on data collected in 2012. Measurements of the reconstruction efficiency and of the momentum scale and resolution, based on large reference samples of J/psi -> μmu, Z -> μμand gamma -> μμdecays, are presented and compared to Monte Carlo simulations. Corrections to the simulation, to be used in physics analysis, are provided. Over most of the covered phase space (muon |eta| < 2.7 and 5 less than or similar to p(T) less than or similar to 100 GeV) the efficiency is above 99% and is measured with per-mille precision. The momentum resolution ranges from 1.7% at central rapidity and for transverse momentum p(T) similar or equal to 10 GeV, to 4% at large rapidity and p(T) similar or equal to 100 GeV. The momentum scale is known with an uncertainty of 0.05% to 0.2% depending on rapidity. A method for the recovery of final state radiation from the muons is also presented.
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., Cabrera Urban, S., et al. (2023). Observation of four-top-quark production in the multilepton final state with the ATLAS detector. Eur. Phys. J. C, 83(6), 496–35pp.
Abstract: This paper presents the observation of four-topquark (t (t) over bart (t) over bar) production in proton-proton collisions at the LHC. The analysis is performed using an integrated luminosity of 140 fb-1 at a centre-of-mass energy of 13 TeVcollected using the ATLAS detector. Events containing two leptons with the same electric charge or at least three leptons (electrons or muons) are selected. Event kinematics are used to separate signal from background through a multivariate discriminant, and dedicated control regions are used to constrain the dominant backgrounds. The observed (expected) significance of themeasured t (t) over bart (t) over bar signal with respect to the standard model (SM) background-only hypothesis is 6.1 (4.3) standard deviations. The t (t) over bart (t) over bar production cross section is measured to be 22.5(-5.5)(+6.6), consistent with the SM prediction of 12.0 +/- 2.4 fb within 1.8 standard deviations. Data are also used to set limits on the three-top-quark production cross section, being an irreducible background not measured previously, and to constrain the top-Higgs Yukawa coupling and effective field theory operator coefficients that affect t (t) over bart (t) over bar production.
|
