|
ATLAS Collaboration(Aad, G. et al), Amoros, G., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Escobar, C., et al. (2011). Measurement of the W+W- Cross Section in sqrt(s)=7 TeV pp Collisions with ATLAS. Phys. Rev. Lett., 107(4), 041802–18pp.
Abstract: This Letter presents a measurement of the W(+)W(-) production cross section in root s = 7 TeV pp collisions by the ATLAS experiment, using 34 pb(-1) of integrated luminosity produced by the Large Hadron Collider at CERN. Selecting events with two isolated leptons, each either an electron or a muon, 8 candidate events are observed with an expected background of 1.7 +/- 0.6 events. The measured cross section is 41(-16)(+20)(stat) +/- 5(syst) +/- 1(lumi) pb, which is consistent with the standard model prediction of 44 +/- 3 pb calculated at next-to-leading order in QCD.
|
|
|
ATLAS Collaboration(Aad, G. et al), Amoros, G., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Escobar, C., et al. (2012). Measurement of the pseudorapidity and transverse momentum dependence of the elliptic flow of charged particles in lead-lead collisions at root s(NN)=2.76 TeV with the ATLAS detector. Phys. Lett. B, 707(3-4), 330–348.
Abstract: This Letter describes the measurement of elliptic flow of charged particles in lead-lead collisions at root s(NN) = 2.76 TeV using the ATLAS detector at the Large Hadron Collider (LHC). The results are based on an integrated luminosity of approximately 7 μb(-1). Elliptic flow is measured over a wide region in pseudorapidity, vertical bar eta vertical bar < 2.5, and over a broad range in transverse momentum, 0.5 < p(T) < 20 GeV. The elliptic flow parameter nu(2) is obtained by correlating individual tracks with the event plane measured using energy deposited in the forward calorimeters. As a function of transverse momentum, nu(2)(p(T)) reaches a maximum at p(T) of about 3 GeV. then decreases and becomes weakly dependent on p(T) above 7-8 GeV. Over the measured pseudorapidity region, nu(2) is found to be only weakly dependent on eta, with less variation than observed at lower beam energies. The results are discussed in the context of previous measurements at lower collision energies, as well as recent results from the LHC.
|
|
|
ATLAS Collaboration(Aad, G. et al), Amoros, G., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Ferrer, A., et al. (2012). Search for Production of Resonant States in the Photon-Jet Mass Distribution Using pp Collisions at root s=7 TeV Collected by the ATLAS Detector. Phys. Rev. Lett., 108(21), 211802–18pp.
Abstract: This Letter describes a model-independent search for the production of new resonant states in photon + jet events in 2.11 fb(-1) of proton-proton collisions at root s = 7 TeV. We compare the photon + jet mass distribution to a background model derived from data and find consistency with the background-only hypothesis. Given the lack of evidence for a signal, we set 95% credibility level limits on generic Gaussian-shaped signals and on a benchmark excited-quark (q*) model, excluding 2 TeV Gaussian resonances with cross section times branching fraction times acceptance times efficiency near 5 fb and excluding q* masses below 2.46 TeV, respectively.
|
|
|
ATLAS Tile Calorimeter System(Abdallah, J. et al), Ferrer, A., Fiorini, L., Hernandez Jimenez, Y., Higon-Rodriguez, E., Ruiz-Martinez, A., et al. (2016). The Laser calibration of the ATLAS Tile Calorimeter during the LHC run 1. J. Instrum., 11, T10005–29pp.
Abstract: This article describes the Laser calibration system of the ATLAS hadronic Tile Calorimeter that has been used during the run 1 of the LHC. First, the stability of the system associated readout electronics is studied. It is found to be stable with variations smaller than 0.6 %. Then, the method developed to compute the calibration constants, to correct for the variations of the gain of the calorimeter photomultipliers, is described. These constants were determined with a statistical uncertainty of 0.3 % and a systematic uncertainty of 0.2 % for the central part of the calorimeter and 0.5 % for the end-caps. Finally, the detection and correction of timing mis-configuration of the Tile Calorimeter using the Laser system are also presented.
|
|
|
ATLAS Collaboration(Aad, G. et al), Amoros, G., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Escobar, C., et al. (2011). Measurement of the Z -> tau tau cross section with the ATLAS detector. Phys. Rev. D, 84(11), 112006–29pp.
Abstract: The Z -> tau tau cross section is measured with the ATLAS experiment at the LHC in four different final states determined by the decay modes of the tau leptons: muon-hadron, electron-hadron, electron-muon, and muon-muon. The analysis is based on a data sample corresponding to an integrated luminosity of 36 pb(-1), at a proton-proton center-of-mass energy of root s = 7 TeV. Cross sections are measured separately for each final state in fiducial regions of high detector acceptance, as well as in the full phase space, over the mass region 66-116 GeV. The individual cross sections are combined and the product of the total Z production cross section and Z -> tau tau branching fraction is measured to be 0.97 +/- 0.07(stat) +/- 0.06(syst) +/- 0: 03(lumi) nb, in agreement with next-to-next-to-leading order calculations.
|
|