ATLAS Collaboration(Aad, G. et al), Amoros, G., Cabrera Urban, S., Castillo Gimenez, V., Costa, M. J., Ferrer, A., et al. (2012). Measurement of D*(+/-) meson production in jets from pp collisions at root s=7 TeV with the ATLAS detector. Phys. Rev. D, 85(5), 052005–22pp.
Abstract: This paper reports a measurement of D*(+/-) meson production in jets from proton- proton collisions at a center- of- mass energy of root s = 7 TeV at the CERN Large Hadron Collider. The measurement is based on a data sample recorded with the ATLAS detector with an integrated luminosity of 0.30 pb(-1) for jets with transverse momentum between 25 and 70 GeV in the pseudorapidity range vertical bar eta vertical bar <2.5. D*(+/-) mesons found in jets are fully reconstructed in the decay chain: D*(+/-)-> D-0 pi(+), D-0 -> K-pi(+), and its charge conjugate. The production rate is found to be N(D*(+/-))/N(jet) = 0.025 +/- 0.001(stat.) +/- 0.004(syst.) for D*(+/-) mesons that carry a fraction z of the jet momentum in the range 0.3< z< 1. Monte Carlo predictions fail to describe the data at small values of z, and this is most marked at low jet transverse momentum.
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Cabrera Urban, S., Cardillo, F., et al. (2022). Modelling and computational improvements to the simulation of single vector-boson plus jet processes for the ATLAS experiment. J. High Energy Phys., 08(8), 089–61pp.
Abstract: This paper presents updated Monte Carlo configurations used to model the production of single electroweak vector bosons (W, Z/gamma*) in association with jets in proton-proton collisions for the ATLAS experiment at the Large Hadron Collider. Improvements pertaining to the electroweak input scheme, parton-shower splitting kernels and scale-setting scheme are shown for multi-jet merged configurations accurate to next-to-leading order in the strong and electroweak couplings. The computational resources required for these set-ups are assessed, and approximations are introduced resulting in a factor three reduction of the per-event CPU time without affecting the physics modelling performance. Continuous statistical enhancement techniques are introduced by ATLAS in order to populate low cross-section regions of phase space and are shown to match or exceed the generated effective luminosity. This, together with the lower per-event CPU time, results in a 50% reduction in the required computing resources compared to a legacy set-up previously used by the ATLAS collaboration. The set-ups described in this paper will be used for future ATLAS analyses and lay the foundation for the next generation of Monte Carlo predictions for single vector-boson plus jets production.
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., Cabrera Urban, S., et al. (2023). Observation of four-top-quark production in the multilepton final state with the ATLAS detector. Eur. Phys. J. C, 83(6), 496–35pp.
Abstract: This paper presents the observation of four-topquark (t (t) over bart (t) over bar) production in proton-proton collisions at the LHC. The analysis is performed using an integrated luminosity of 140 fb-1 at a centre-of-mass energy of 13 TeVcollected using the ATLAS detector. Events containing two leptons with the same electric charge or at least three leptons (electrons or muons) are selected. Event kinematics are used to separate signal from background through a multivariate discriminant, and dedicated control regions are used to constrain the dominant backgrounds. The observed (expected) significance of themeasured t (t) over bart (t) over bar signal with respect to the standard model (SM) background-only hypothesis is 6.1 (4.3) standard deviations. The t (t) over bart (t) over bar production cross section is measured to be 22.5(-5.5)(+6.6), consistent with the SM prediction of 12.0 +/- 2.4 fb within 1.8 standard deviations. Data are also used to set limits on the three-top-quark production cross section, being an irreducible background not measured previously, and to constrain the top-Higgs Yukawa coupling and effective field theory operator coefficients that affect t (t) over bart (t) over bar production.
|
ATLAS Collaboration(Aad, G. et al), Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., Cabrera Urban, S., et al. (2023). Studies of the muon momentum calibration and performance of the ATLAS detector with pp collisions at √s=13 TeV. Eur. Phys. J. C, 83(8), 686–37pp.
Abstract: This paper presents the muon momentum calibration and performance studies for the ATLAS detector based on the pp collisions data sample produced at root s = 13 TeV at the LHC during Run 2 and corresponding to an integrated luminosity of 139 fb(-1). An innovative approach is used to correct for potential charge-dependent momentum biases related to the knowledge of the detector geometry, using the Z ->mu(+)mu(-) resonance. The muon momentum scale and resolution are measured using samples of J/psi ->mu(+)mu(-) and Z ->mu(+)mu(-) events. A calibration procedure is defined and applied to simulated data to match the performance measured in real data. The calibration is validated using an independent sample of Upsilon ->mu(+)mu(-) events. At the Z(J/psi) peak, the momentum scale is measured with an uncertainty at the 0.05% (0.1%) level, and the resolution is measured with an uncertainty at the 1.5% (2%) level. The charge-dependent bias is removed with a dedicated in situ correction for momenta up to 450 GeV with a precision better than 0.03 TeV-1.
|
ATLAS Collaboration(Aad, G. et al), Aikot, A., Amos, K. R., Aparisi Pozo, J. A., Bailey, A. J., Bouchhar, N., et al. (2024). Electron and photon energy calibration with the ATLAS detector using LHC Run 2 data. J. Instrum., 19(2), P02009–58pp.
Abstract: This paper presents the electron and photon energy calibration obtained with the ATLAS detector using 140 fb-1 of LHC proton -proton collision data recorded at -Js = 13 TeV between 2015 and 2018. Methods for the measurement of electron and photon energies are outlined, along with the current knowledge of the passive material in front of the ATLAS electromagnetic calorimeter. The energy calibration steps are discussed in detail, with emphasis on the improvements introduced in this paper. The absolute energy scale is set using a large sample of Z -boson decays into electron -positron pairs, and its residual dependence on the electron energy is used for the first time to further constrain systematic uncertainties. The achieved calibration uncertainties are typically 0.05% for electrons from resonant Z -boson decays, 0.4% at ET – 10 GeV, and 0.3% at ET – 1 TeV; for photons at ET <^>' 60 GeV, they are 0.2% on average. This is more than twice as precise as the previous calibration. The new energy calibration is validated using .11tfr -, ee and radiative Z -boson decays.
|