|
|
AGATA Collaboration, Farnea, E., Recchia, F., Bazzacco, D., Kroll, T., Podolyak, Z., et al. (2010). Conceptual design and Monte Carlo simulations of the AGATA array. Nucl. Instrum. Methods Phys. Res. A, 621(1-3), 331–343.
Abstract: The aim of the Advanced GAmma Tracking Array (AGATA) project is the construction of an array based on the novel concepts of pulse shape analysis and gamma-ray tracking with highly segmented Ge semiconductor detectors. The conceptual design of AGATA and its performance evaluation under different experimental conditions has required the development of a suitable Monte Carlo code. In this article, the description of the code as well as simulation results relevant for AGATA, are presented.
|
|
|
|
BABAR Collaboration(del Amo Sanchez, P. et al), Lopez-March, N., Martinez-Vidal, F., Milanes, D. A., & Oyanguren, A. (2010). Measurement of the absolute branching fractions for D-s(-) -> l(-) (nu)over-bar(l) and extraction of the decay constant f(Ds). Phys. Rev. D, 82(9), 091103–8pp.
Abstract: The absolute branching fractions for the decays D-s(-) -> l(-) (nu) over bar (l) (l = e, mu, or tau) are measured using a data sample corresponding to an integrated luminosity of 521 fb(-1) collected at center-of-mass energies near 10.58 GeV with the BABAR detector at the PEP-II e(+)e(-) collider at SLAC. The number of D-s(-) mesons is determined by reconstructing the recoiling system DKX gamma in events of the type e(+)e(-) -> DKXDs*(-), where D-s*(-) -> D-s(-) gamma and X represents additional pions from fragmentation. The D-s(-) -> l(-) nu(l) events are detected by full or partial reconstruction of the recoiling system DKX gamma l. The branching fraction measurements are combined to determine the D-s(-) decay constant f(Ds) (258.6 +/- 6.4 +/- 7:5) MeV, where the first uncertainty is statistical and the second is systematic.
|
|
|
|
n_TOF Collaboration(Massimi, C. et al), Domingo-Pardo, C., & Tain, J. L. (2010). Au-197(n,gamma) cross section in the resonance region. Phys. Rev. C, 81(4), 044616–22pp.
Abstract: The (n,gamma) cross section of Au-197 has been measured at nTOF in the resolved resonance region, up to 5 keV, with the aim of improving the accuracy in an energy range where it is not yet considered standard. The measurements were performed with two different experimental setup and detection techniques, the total energy method based on C6D6 detectors, and the total absorption calorimetry based on a 4 pi BaF2 array. By comparing the data collected with the two techniques, two accurate sets of neutron-capture yields have been obtained, which could be the basis for a new evaluation leading to an extended cross-section standard. Overall good agreement is found between the n_TOF results and evaluated cross sections, with some significant exceptions for small resonances. A few resonances not included in the existing databases have also been observed.
|
|
|
|
Studen, A., Burdette, D., Chesi, E., Cindro, V., Clinthorne, N. H., Cochran, E., et al. (2010). Timing performance of the silicon PET insert probe. Radiat. Prot. Dosim., 139(1-3), 199–203.
Abstract: Simulation indicates that PET image could be improved by upgrading a conventional ring with a probe placed close to the imaged object. In this paper, timing issues related to a PET probe using high-resistivity silicon as a detector material are addressed. The final probe will consist of several (four to eight) 1-mm thick layers of silicon detectors, segmented into 1 x 1 mm(2) pads, each pad equivalent to an independent p + nn+ diode. A proper matching of events in silicon with events of the external ring can be achieved with a good timing resolution. To estimate the timing performance, measurements were performed on a simplified model probe, consisting of a single 1-mm thick detector with 256 square pads (1.4 mm side), coupled with two VATAGP7s, application-specific integrated circuits. The detector material and electronics are the same that will be used for the final probe. The model was exposed to 511 keV annihilation photons from an Na-22 source, and a scintillator (LYSO)-PMT assembly was used as a timing reference. Results were compared with the simulation, consisting of four parts: (i) GEANT4 implemented realistic tracking of electrons excited by annihilation photon interactions in silicon, (ii) calculation of propagation of secondary ionisation (electron-hole pairs) in the sensor, (iii) estimation of the shape of the current pulse induced on surface electrodes and (iv) simulation of the first electronics stage. A very good agreement between the simulation and the measurements were found. Both indicate reliable performance of the final probe at timing windows down to 20 ns.
|
|
|
|
Deo, A. Y., Podolyak, Z., Walker, P. M., Algora, A., Rubio, B., Agramunt, J., et al. (2010). Structures of Po-201 and Rn-205 from EC/beta(+)-decay studies. Phys. Rev. C, 81(2), 024322–8pp.
Abstract: Several low-lying excited states in Rn-205(86)119 and Po-201(84)117 were identified for the first time following EC/beta(+) decay of Fr-205 and At-201, respectively, using gamma-ray and conversion electron spectroscopy at the CERN isotope separator on-line (ISOLDE) facility. The EC/beta(+) branch from Fr-205 was measured to be 1.5(2)%. The excited states of the daughter nuclei are understood in terms of the odd nucleon coupling to the neighboring even-even core. The neutron single-particle energies of the p(3/2) orbital relative to the f(5/2) ground state in Rn-205, and the f(5/2) orbital relative to the p(3/2) ground state in Po-201, were determined to be 31.4(2) and 5.7(3) keV, respectively. We tentatively identify a 13/2(+) isomeric level at 657.1(5) keV in Rn-205. The systematic behavior of the 13/2(+) and 3/2(-) levels is also discussed.
|
|
